28188-2-0114 Page 3
The installation must conform with local codes or, in
theabsenceoflocalcodes,withtheNationalFuelGas
Code, ANSI Z223.1 (latest edition) and to the National
electrical Code, ANSI/NFPA70 (latest edition).
NOTE:Installationandrepairshouldbedonebyaquali-
edserviceperson.Theapplianceshouldbeinspected
beforeuseandatleastannuallybyaqualiedservice
person.Morefrequentcleaningmayberequireddue
toexcessivelintfromcarpeting,beddingmaterial,etc.
Itisimperativethatcontrolcompartment,burnersand
circulatingairpassagewaysoftheappliancebekept
clean.
Any safety screen or guard removed for servicing an
appliancemustbereplacedpriortooperatingtheap-
pliance.Provideadequatecombustionandventilation
air.
TheowofcombustionandventilationairMUSTNOT
beobstructed.
Provide adequate clearance around air openings into
the combustion chamber and adequate accessibility
clearance for servicing and proper operation. NEVER
obstructthefrontopeningoftheappliance.
This Empire Comfort Systems, Inc. rebox and its
componentshavebeentestedandwilloperatesafely
when installed in accordance with this installation
manual. Read all instructions before starting
installation, then follow these instructions carefully
during installation to maximize rebox benet and
safety. Report to your dealer any parts damaged in
shipment.
The Empire Comfort Systems, Inc. warranty will be
voidedby,andEmpireComfortSystems,Inc.disclaims
anyresponsibilityforthefollowingactions:
- Installationofanydamagedrebox.
- Modicationofthereboxoranyofthecomponents
parts thereof.
- Installation other than as instructed by Empire
Comfort Systems, Inc.
- Installation and/or use of any component part
or accessory not approved by Empire Comfort
Systems, Inc. in combination or assembly with
a Empire Comfort Systems, Inc. firebox, not
withstandinganyindependenttestinglaboratoryor
other third party approval of such component part
or accessory.
Anysuchactionmaycreateapossiblerehazard.
Consultyourlocalbuildingcodes.
FireboxScreen.
Thereboxscreenmustbeinplacewhentherebox
is operating.
Instructions to Installer
1. Installer must leave instruction manual with owner after
installation.
2. Installer must have owner ll out and mail warranty card
suppliedwithrebox.
3. Installer should show owner how to start and operate log set
thatisinstalledintorebox.
Important
All correspondence should refer to complete Model Number,
Serial Number.
Notice:Duringinitialringofthisreboxwithalogsetinstalled,its
paint will bake out, and smoke will occur. To prevent triggering of
smoke alarms, ventilate the room in which the unit is installed.
QualiedInstallingAgency
Installation and replacement of gas piping, gas utilization equipment
or accessories and repair and servicing of equipment shall be
performedonlybyaqualiedagency.Theterm"qualiedagency"
meansanyindividual,rm,corporationorcompanywhicheitherin
person or through a representative is engaged in and is responsible
for (a) the installation or replacement of gas piping or (b) the
connection, installation, repair or servicing of equipment, who is
experienced in such work, familiar with all precautions required
and has complied with all the requirements of the authority having
jurisdiction.
State of Massachusetts: The installation must be made by
a licensed plumber or gas tter in the Commonwealth of
Massachusetts. The state of Massachusetts requires that
a exible appliance connector cannot exceed three feet in
length.
Sellersofunventedpropaneornaturalgas-redsupplemental
room heaters shall provide to each purchaser a copy of 527
CMR 30 upon sale of the unit.
In the State of Massachusetts, unvented propane and natural
gas-redspaceheatersshallbeprohibitedinbedroomsand
bathrooms.
The installation must conform with local codes or, in the absence
of local codes, with the National Fuel Gas Code, ANSI Z223.1/
NFPA 54.*
*Available from the American National Standards Institute, Inc.,
11 West 42nd St., New York, N.Y. 10036.
IMPORTANT SAFETY INFORMATION
INTRODUCTION
