Enable-IT 828W Bedienungsanleitung

Enable-IT 828W Weatherproof

Professional Grade PoE Extender Unit

Quickstart Guide

INSTALLING THE 828W WEATHERPROOF POE EXTENDER !

Installation!

The Enable-IT 828W – A Dual Output PoE and Gigabit PoE Ethernet Unit has a distance restriction

of 800ft or 240m over 4-pair Category 5e or higher spec rated wiring. Multiple 828W units can be

daisy chained to reach up to 2,000ft or 1,828m. For the 828W daisy chain use additional 828W

units.!

•Total distance limitation of 800ft or 240m from end to end per 828W unit.

•4-pair CAT 5e .24 AWG or better cabling is required for Gigabit throughput.

•Wire pairs used must be straight through, no taps/connection points.

Perform an Out Of The Box Test (OOTBT)

We highly recommend that you perform a quick test to ensure the working order of

your Enable-IT 828W Weatherproof PoE Extender Unit units prior to installing. !

This will also serve to familiarize you with how easy the process should be. Using a

Ethernet patch cord attach any PoE Injector Output to the 828W left side (single port)

sealed jack as shown below in the diagram.

Next use another Ethernet patch cord to connect one of the 828W right side (dual

ports) jack to your PoE device. Power up your PoE Injector. The left side Green Power

LEDs will turn on and all Yellow Link LEDs will flicker for LAN traffic activity. This

confirms basic proper operation of the units.

For a more detailed test and to confirm your LAN Equipment works with the 828W

units, connect your Ethernet LAN to the PoE injector LAN in port and then test LAN

port and test connectivity all the way end to end.

You will need a long flathead screwdriver to carefully remove the Ethernet patch cables

from the deeply recessed ports prior to installing.

Performing the On-Site Installation

After removing the Enable-IT 828W Weatherproof PoE Extender Unit from the box, and

performing the Out Of The Box Testing (OOTBT), all that remains to install the unit on-site is

to mount the unit, attach the LAN device cabling through the open end screw caps, use the

grey sealant around the inserted Ethernet RJ45 LAN cable (inside the screw cap) and

securely tighten the screw caps.

Mounting the Enable-IT 828W Weatherproof PoE Extender Unit Units!

The Enable-IT 828W Weatherproof extended Ethernet solution is designed for quick wall

mounting. Choose a location to mount each of the Enable-IT 828W Weatherproof’s where

the maximum distance does not exceed 400ft or 121m from your PoE injector and or the end

PoE device or next 828W unit - (See diagram below). When wall-mounting the Enable-IT

828W Weatherproof unit it is recommended that you use the appropriate screw anchors for

your mounting surface. If mounting on existing plywood use wood screws; if mounting onto

drywall or sheetrock, use plastic drywall anchors to secure your installation.

TECHNICAL SUPPORT

Enable-IT, Inc.’s Customer Care Team support is available directly to customers and distributors. All

support requests are processed through the online support portal. This allows us to provide

assigned support ticket numbers in order to bring closure to any technical issues.

Online Technical Services

The Enable-IT Support Portal is available 24/7 to open a ticket or check the status of one. Please

use this support website as your first source for help as it contains an on-line knowledge base of

articles, documentation, FAQ's and other problem-solving resources. This web-based support

resource provides the quickest solution to the most common technical support issues.

World Wide Web Site

https://enableit.com/customer-care-support

Returning Products for Warranty Repair

Enable-IT warrants to the original purchaser of the Product ("you" or the "End User") that, for the

limited lifetime period commencing on the date the Product was purchased (the “Warranty Period"),

the Product will be substantially free from defects in materials and workmanship under normal use

and conditions. This warranty does not apply to Products, which are resold as used, repaired or

reconditioned. Electrical or water damage is not covered under this warranty, extended

warranties or Advanced Replacement Program (AREP).

In order to obtain an authorized RMA approval, the End User must complete the required

information online located at http://support.enableit.com. If you have questions or difficulty

completing this information you may contact the Customer Care Team at 888-309-0910 between

the hours of 6:30 a.m. and 4:00 p.m. PT.

Please ship Authorized RMAs to:

RMA Warranty Repair Processing Facility

16027 Brookhurst St, Suite G272

Fountain Valley, CA 92708-1551

Returning Products for Refund

Enable-IT, Inc. offers a generous 45-Day refund on a single Ethernet Extender Kit only, and is

subject to a 15% Restocking Fee. Shipments without a valid or authorized RMA number, or

sent to our corporate Las Vegas address, can be refused and / or billed for additional

shipping.

ENABLE-IT, INC. LIMITED WARRANTY

Enable-IT, Inc. warrants the Enable-IT 828W Weatherproof PoE Extender Unit solely pursuant

to the following terms and conditions.

1.ENABLE-IT PRODUCT WARRANTY.

a. Express Warranty.

Enable-IT warrants to the original purchaser of the Product ("you" or the "End User") that,

forthelimitedlifetimeperiodcommencingonthedatetheProductwaspurchased(the

“WarrantyPeriod"),theProductwillbesubstantiallyfreefromdefectsinmaterialsand

workmanshipundernormaluseandconditions.ThiswarrantydoesnotapplytoProducts,

whichareresoldasused,repairedorreconditioned.

Electrical or water damage are not covered under this warranty, extended warranties

orAdvancedReplacementProgram(AREP).

Enable-IT does not make any warranty with respect to any third party product, software or

accessorysuppliedwithorusedinconnectionwiththeProductandsuchthirdparty

products,softwareandaccessories,ifany,areprovided"ASIS."Warrantyclaimsrelatedto

suchthirdpartyproducts,softwareandaccessoriesmustbemadetotheapplicablethird

partymanufacturer.

Sales and Customer Care:

Toll Free US and Canada 888 309-0910

866 389-8605 Fax

Other International +1 702 924-0402

+1 702 800-2711 Fax

E Mail [email protected]

[email protected]

RMA Support:

https://support.enableit.com

Inhaltsverzeichnis

Andere Enable-IT Extender Handbücher

Enable-IT

Enable-IT 860 W PRO Bedienungsanleitung

Enable-IT

Enable-IT 860 PRO Rev C Bedienungsanleitung

Enable-IT

Enable-IT 821C Bedienungsanleitung

Enable-IT

Enable-IT 860XS PRO Bedienungsanleitung

Enable-IT

Enable-IT 865C PRO Bedienungsanleitung

Enable-IT

Enable-IT 868 Bedienungsanleitung

Enable-IT

Enable-IT 865 PTZQ PRO Bedienungsanleitung

Enable-IT

Enable-IT 860 Pro Rev B Bedienungsanleitung

Enable-IT

Enable-IT 824P Bedienungsanleitung

Enable-IT

Enable-IT 865Q PRO Bedienungsanleitung

Enable-IT

Enable-IT 865W PRO Bedienungsanleitung

Enable-IT

Enable-IT 864P Mini DSLAM Bedienungsanleitung

Enable-IT

Enable-IT 824 Bedienungsanleitung

Enable-IT

Enable-IT 850 Bedienungsanleitung

Enable-IT

Enable-IT 824C Bedienungsanleitung

Enable-IT

Enable-IT 860 Series Bedienungsanleitung

Enable-IT

Enable-IT 821CW Bedienungsanleitung

Enable-IT

Enable-IT 860X PRO Bedienungsanleitung

Enable-IT

Enable-IT 850 CPE Bedienungsanleitung

Enable-IT

Enable-IT 860 Series Bedienungsanleitung

Enable-IT

Enable-IT 895 Series Bedienungsanleitung

Enable-IT

Enable-IT 860 PRO Rev C Bedienungsanleitung

Enable-IT

Enable-IT 821P Bedienungsanleitung

Enable-IT

Enable-IT 850 CPE Bedienungsanleitung

Beliebte Extender Handbücher anderer Marken

SY HDBT-60T Bedienungsanleitung

Appsys ProAudio

Appsys ProAudio ADX-16 Bedienungsanleitung

Atlona

Atlona RS232 Bedienungsanleitung

IDK

IDK OPF-TH1000-A Bedienungsanleitung

Worx

Worx Landroid RadioLink WA0864 Technisches Datenblatt

TP-Link

TP-Link TL-WA730RE Bedienungsanleitung

Camplex

Camplex CMX-HDMI-SFPL Bedienungsanleitung

SC&T

SC&T HE03-4K Bedienungsanleitung

Marmitek

Marmitek MegaView70 Bedienungsanleitung

Samsung

Samsung SCS-26UC4 Bedienungsanleitung

Foxun

Foxun SX-GES24 Bedienungsanleitung

MuxLab

MuxLab 500771 Bedienungsanleitung

foxunhd

foxunhd SX-AEX01 Bedienungsanleitung

TERK Technologies

TERK Technologies LFIRX2 Bedienungsanleitung

Devolo

Devolo Audio Extender Handbuch

Edimax

Edimax EW-7438RPn V2 Bedienungsanleitung

Shinybow USA

Shinybow USA SB-6335T5 Bedienungsanleitung

SECO-LARM

SECO-LARM ENFORCER EVT-PB1-V1TGQ Bedienungsanleitung