Endura PanoLock Bedienungsanleitung
1
PanoLock™- Lock Assembly & Handing
PanoLock™Multi-Point Lock Instructions
Lock Assembly & Handing
8817 West Market Street
Colfax, NC 27235 | 800.334.2006
www.enduraproducts.com
Ensurelockmortiseinpaneledgeisclear
of dust and debris.
STEP 1
Orient lock assembly as shown.
STEP 2
Latch
Top end of lock
Spring
Adjuster
Screw
Place lock assembly in mortise pocket.
STEP 3
Check to conrm proper
placement of the lock.
Ensure entire length
lock face plate is ush
with edge face of panel.
If lock does not sit ush,
remove lock and check
for debris in pocket. It
may be necessary to
verify mortise pocket
dimensionsifnodebrisor
contaminationispresent.
STEP 4
Ensure lock drive hubs
alignwithpanelfacebores
2
PanoLock™- Lock Assembly & Handing
Secure lock with installation screws.
STEP 5
Two #8 x 3" Screws: Place through open holes
just above the latch, and just below the spring
adjuster screw.
Four #8 x 1-5/8" Screws: Place through
remaining open holes.
LockHanding-Theangledsurfaceofthelatchfaces
the strike plate.
STEP 6
To rehand the lock, loosen the latch screw with a
9/64" allen wrench.
STEP 7
#8 x 1-5/8"
Screw
#8 x 1-5/8"
Screw
#8 x 3"
Screw
#8 x 3"
Screw
#8 x 1-5/8"
Screw
#8 x 1-5/8"
Screw
3
PanoLock™- Lock Assembly & Handing
Lift latch away from lock, rotate 180 degrees, place back into lock.
STEP 8
Slots on back of latch must align with ribs at bottom of latch hole.
Note placement of roller sleeve, latch and screw.
Tighten screw to secure latch in place.
STEP 9
4
PanoLock™- Lock Assembly & Handing
STEP 10
Place a at head screwdriver next to the
pin.
Movethepinbuttonbacktothestarting
position to disengage the upper, lower,
and center latches.
Use the screwdriver to push the pin to the right. The
latch should fully retract.
Push down on either of the multipoint latches.
The latch should remain extended.
Pushdownonthecenterlatch. Thelatch
should remain extended.
Check lock function.
Inhaltsverzeichnis
Andere Endura Sperren Handbücher
