Package
EPoC Transceiver DC Cable &
DC Terminal Block
Hardware Overview
Right
Left
BNC 커넥터
EPoC Transceiver
EPoC Transceiver
DC 전원 어댑터
상태 표시등
Join 버튼
DC OUT스위치RJ45 DC OUT 표시등 터미널 블럭
Status LED
indicator
DC Power Jack Join Button
BNC connector
DC OUT LED
DC OUT
ON / OFF Switch
Terminal Block
Overview
This device is aHigh-Speed, long distance Ethernet &PoE extender
that makes possible to transmit IP data up to 2.4Km up to 1.2Km
through various analog cables in different situations.
It is cost-effective and time saving solution to migrate existing analog
system to IP based system since EPoC Transceiver supports
easy installation utilizing the existing CCTV cable (Coax, UTP, 2wire &
Etc.).
With long distance transmission feature, the device makes to
overcome 100 meters distance limitation easily and reduces the
construction cost significantly compared with fiber optic configuration.
Features
Ethernet over coax (UTP, 2-Wire) communication following
IEEE1901 Standard
Data (or UTP, 2-wire)
Data distance up to 2.4Km
Max. 270Mbps Bandwidth
10/100/1000 Full Duplex
128bit AES network encryption
Supports Multi-connection (Daisy chain, Star, etc.)
Supports UTP, Telephone (2 Pairs), 2-Wire cable communication
(Using BTE Series)
Quality LED (Data & Power)
Plug & Play
Surge Protection
12VDC output (for Non-PoE Camera)
Please read carefully the instruction manual before use. Depending
on the model, the image and the actual look of the product may vary.
LED Indicators
Indicator Color Function
BNC Join EPoC Devices connected
PWR 56VDC input connected
Quality
LINK Good data connection
Poor data connection
PWR Good power supply condition
Additional adapter required
Data Flashes when data is transferred
DC OUT DC OUT switch is ON
Installation Guide
1. Set the IP address on the camera following the instruction manual
of the camera.
Î
If the camera IP is automatically assigned (DHCP, etc.), there is no
need to set the camera IP separately.
2. Connect BNC of the coaxial cable to each EPoC Transceiver.
3. Connect 56V DC power to EPoC Transceiver first and then to AC
outlet. transmission up to 1200m over RG6 coaxial cable.
4. When they are correctly connected, PWR/BNC Join/Quality PWR LED
are on.
5. Fix up EPoC Transceiver where it should be placed.
6. Connect the UTP(LAN) cable between EPoC Transceiver and NVR
first and then between EPoC Transceiver and camera.
7. Connect DC Cable between camera and Terminal Block on EPoC
Transceiver.
Î
EPoC Transceiver send data via BNC connector.
Î
Mind
the
polarity (+/-) and tie up DC cable on the terminal block.
8. Ping test is recommended to confirm the whole network after
installation.
9. Check the video signal on the monitor.
Quick Installation Guide
Ethernet over Coax Transceiver,
Data/Power supply 270Mbps,
57VDC power input
IAM-6MC1001M0A
Quick
Installation
Guide
Quick Installation
Guide
Note: The Join Button is currently disabled.
