380W
RANDOMORBITSANDER
ENB624SDR
4 Use and maintenance of the tool
a) Do not force the tool. Use the correct tool for your application. The correct tool will do the work better
and safer in the conditions for which it was manufactured.
b) Do not use the tool if the switch does not make it possible to change from the operating condition to
stop and vice versa. Any tool which cannot be controlled by the switch is dangerous and should be repaired.
c) Disconnect the power cord before any adjustment, changing an accessory or before storing the
tool. Such preventive safety measures reduce the risk of starting the tool accidentally.
d) Keep idle tools out of the reach of children and do not allow persons unfamiliar with the tool or
these instructions to operate it. Tools are dangerous in the hands of untrained users.
e) Maintain the tool. Check that there is no misalignment or obstruction of the moving parts, broken
parts or any other condition that could affect the operation of the tool. In the event of damage, have
the tool repaired before using it. Many accidents are due to badly maintained tools.
f) Keep cutting tools sharp and clean. Properly maintained tools with sharp cutting edges are less likely to
bind and are easier to control.
g) Use the tool, accessories and blades etc., in accordance with these instructions, while taking into
account the work conditions and the work to be done. The use of the tool for operations other than those
intended could result in dangerous situations.
5)Service
a) Have your power tool serviced by a qualified repair person using only identical replacement parts.
This will ensure that the safety of the power tool is maintained
1. This tool is not suitable for wet sanding. Never use the water during working!And never use the sanding
sheet suitable wet sanding.
2. Never use the same sanding sheet for wood and metal. Please make sure the sanding sheet can be used in
working price.
3. Do not touch the moving sanding sheet.
4. Do not continue to use worn, torn or heavily clogged sanding sheets.
5. Do not work on materials containing asbestos. Asbestos is considered carcinogenic.
6. Secure the work piece (a work piece clamped with clamping devices or in a vice is held more securely than
by hand).
7. Remove the plug from the socket before carrying out any adjustment, servicing or maintenance.
8. Fully unwind extension cords to avoid potential overheating.
9. When an extension cord is required, please ensure it has the correct ampere rating for the power tool and
that it is in a safe electrical condition.
10. Ensure the supply voltage is same as rating voltage.
11. The tool is double insulated for additional protection against a possible electrical insulation failure within
the tool.
WARNING！
When sanding wood or other flammability materials: never use the lighter or spark plug! The dust may
be explosive.
The updated Control of Substances Hazardous to Health Regulations 1st October 2012 now also targets to
reduce the risks associated with silica, wood and gypsum dusts.
Construction workers are one of the at-risk groups within this because of the dust that they breathe: silica dust
is not just a nuisance; it is a real risk to your lungs!
Silica is a natural mineral present in large amounts in things like sand, sandstone and granite. It is also
commonly found in many construction materials such as concrete and mortar. The silica is broken into very
fine dust (also known as Respirable Crystalline Silica or RCS) during many common tasks such as cutting,
SPECIAL SAFETY INSTRUCTIONS
ADDITIONAL SAFETY WARNING FOR CONSTRUCTION DUST
