Quick Start Manual
PMINI-MANUAL (50881)
For latest version visit:
www.enttec.com
4
ID: 209766
•1: Maps to One universe, and drives first 170 pixels
in RGB modes, or First 128 Pixels in RGBW modes.
•2: Maps the output to two universes, and drives
first 340 pixels in RGB modes, or First 256 Pixels in
RGBW modes.
First Universe
Allows selections of the First universe that the output will
be mapped to. Drives the first 170 Pixels in RGB modes, or
the first 128 Pixels in RGBW modes.
For Art-net universe, please change Net/Subnet to increase
combined universe beyond 15. (Combined universe is
shown under the selection).
Second Universe
Allows selections of the Second universe that the output
will be mapped to. Drives pixels 171-340 in RGB modes, or
the pixels 129-256 in RGBW modes.
For Art-net universe, please change Net/Subnet to increase
combined universe beyond 15. Combined universe is
shown under the selection.
Pixel Order
Ordering controls, how the DMX slots are mapped to the
LED pixel color on each LED pixel. The ordering selected
here should match the ordering on the Pixel Tape or Dots
being used. The Pixel ordering selected, will also determine
the number of Pixels being driven on the output.
RGB options: uses 3 DMX channels per pixel.
RGBW options: uses 4 DMX channels per pixel.
Pixel Group
Pixel Grouping allows one DMX pixel to drive multiple
physical LED pixels. This option is only available when One
Universe/Output is selected. Defaults to 1.
The max. Group will depend on the Pixel order selected.
DMX Start Add
Selects DMX slot number for the first pixel to output. This op-
tion is only available when One Universe/Output is selected.
Defaults to 0.
Update Firmware
From this page you can update Pixelator Mini to the latest
firmware. Latest firmware file is available at enttec.com/mini.
Choose or browse the firmware file (as per your browser) and
click on Update firmware to start the process. The update pro-
gress is shown in real-time, and will take a few seconds for the
update to complete
When the update is complete, the page will refresh and you
will be taken to the home page –where you can verify the
firmware version. If the update fails for any reason, please try
the same process again.
Pixelator Mini will reboot after a firmware update, please allow
a few seconds for it to be refreshed in the browser. Please wait
until the update process is complete.
Reset button
The reset button restores the configuration of the Pixelator
Mini to factory defaults:
•DHCP is set to enabled
