Epson Stylus Photo - Ink Jet Printer Technisches Datenblatt

Quick Setup

Unpack the Printer

Here’s how to set up your new EPSON®Stylus Photo

printer ...

Remove any packing material from the printer, as described on

the Notice Sheet in the box. Save all the packaging so you can

use it if you need to transport the printer later. You’ll find these

items inside:

4007082

Place the printer flat on a stable desk near a grounded outlet.

Leave plenty of room in back for the cables and enough room

in front for opening the output tray.

Do NOT put the printer:

◗In an area with high temperature or humidity

◗In direct sunlight or dusty conditions

◗Near sources of heat or electromagnetic interference, such

as loudspeakers or cordless telephone base units.

Also, be sure to follow the Safety Instructions in the

Introduction of your User’s Guide.

○○ ○○○○○

black ink

cartridge

○○○○○○

color ink

cartridge

paper

support

Quick setup Comoro 5/22/97, 10:18 AM1

Insert the paper support in the top slot on the back of the

printer.

Attach the Paper Support

Caution:

Do not plug the printer

into an outlet

controlled by a wall

switch or timer, or on

the same circuit as a

large appliance. This

may disrupt the power,

which can erase

memory and damage

the power supply.

First make sure the power is off.

Plug the power cord into a properly grounded outlet.

Plug In the Printer

○○○○○○○○○○○○○○○○

power

Quick setup Comoro 5/22/97, 10:18 AM2

1. Lower the output tray and raise the printer cover.

2. Press the power button to turn on the printer. The power

light flashes, the and ink out lights come on, and the ink

cartridge holders move to the installation position.

3. Pull up the two ink cartridge clamps.

4. Open the ink cartridge packages. Remove the disposable

yellow portion of the tape seal on top.

Install the Ink Cartridges

color ink

cartridge

○○○○

black ink

cartridge

○○○

Caution:

You must remove the

tape seal from the top

of the cartridge or you

will permanently

damage it. Don’t

remove the tape seal

from the bottom or ink

will leak.

Quick setup Comoro 5/22/97, 10:18 AM3

Caution:

Never turn off the

printer when the

power light is

flashing, unless the

printer hasn’t moved or

made any noise for

more than 5 minutes.

5. Lower the ink cartridges into their holders with the labels

face up and the arrows pointing toward the back of the

printer.

6. Push down the clamps until they lock in place.

7. Press the cleaning button and close the printer cover.

The printer moves the print heads and begins charging the

ink delivery system. Charging can take up to seven minutes.

The power light flashes, and the printer makes various

sounds.

Warning:

If ink gets on your

hands, wash them

thoroughly with soap

and water. If ink gets in

your eyes, flush them

immediately with water.

○○○○○○○○○○○○○○○

○○○○○○○○○○

color ink

cartridge

black ink

cartridge

Quick setup Comoro 5/22/97, 10:18 AM4

1. Slide the left edge guide all the way left and pull out the

output tray extensions.

2. Fan a stack of plain paper and then even the edges.

3. Load the stack with the printable surface face up. Push the

paper against the right edge guide.

4. Slide the left edge guide back against the stack of paper.

Note:

Don’t load paper above

the arrow mark inside the

left edge guide.

Load the Paper

Note:

Keep unused paper in its

original packaging and store

it in a cool, dark place.

○○○○○○○○○○○○

arrow

mark

Quick setup Comoro 5/22/97, 10:18 AM5

1. Turn off the printer.

2. Hold down the load/eject button and press the

power button. Hold down the buttons until the power

light starts to flash. Then release the buttons.

A page prints out showing the ROM version and a nozzle

check pattern.

3. When it’s finished, turn off the printer. If you have any

problems with the test, see Chapter 6 in your User’s Guide

for more information.

You can connect your EPSON Stylus™Photo to either an IBM®

compatible PC or an Apple®Macintosh®

. You’ll need a shielded,

twisted-pair parallel cable to connect to a PC or an Apple

System Peripheral-8 cable to connect to a Macintosh. For a

complete list of system requirements, see the Introduction of

your printer User’s Guide.

1. Turn off the printer and your computer.

2. Connect the cable to the printer’s parallel interface; then

squeeze the wire clips together until they lock in place. (If

your cable has a ground wire, connect it now.)

3. Connect the other end of the cable to your computer’s

parallel port and secure it as necessary.

Check the Printer

Note:

The printer is assigned to

parallel port LPT1; if you

want to use a different

port, see your Windows

documentation for

instructions.

Connect the Printer toYour Computer

○○○○○○○○○

ground

wire

Connecting to a PC

Quick setup Comoro 5/22/97, 10:18 AM6

Connecting to a Macintosh

1. Turn off the printer and your Macintosh.

2. Connect one end of the cable to the serial connector on

the back of the printer.

3. Connect the other end of the cable to either the modem

port or the printer port on your Macintosh.

Install the Software

Your EPSON Digital Darkroom CD-ROM includes the software

for both Windows®and Macintosh.®You must install the printer

driver software for the printer to work correctly.

Before your start, make sure both your computer and the printer

are turned off.

Note:

If you’re using a

PowerBook™

, connect your

printer to the modem port.

If your Macintosh has an

internal modem, use the

printer port.

Installing the Software forWindows

1. Turn on the printer first, then your computer. Make sure

Windows 95 or Windows 3.1 is running.

If the Windows 95 New Hardware Found screen appears,

choose Do not install a driver and click OK.

2. Insert the EPSON Digital Darkroom CD-ROM in your drive.

The EPSON Digital Darkroom main screen appears.

If the EPSON Digital Darkroom doesn’t open automatically

in Windows 95, double-click My Computer, then

double-click your CD-ROM icon.

Note:

If you don’t have a

CD-ROM drive, you can

get the printer driver

software on diskettes or

download it through your

modem. Check out

EPSON’s Home Page at

http://www. epson.com.

For more information, see

your

User’s Guide

Introduction.

Quick setup Comoro 5/22/97, 10:18 AM7

EPSON is a registered trademark and EPSON Stylus is a trademark of SEIKO EPSON CORPORATION.

General Notice: Other product names used herein are for identification purposes only and may be trademarks of their respective owners.

EPSON disclaims any and all rights in those marks.

Printed on recycled paper with at least 10% post-consumer content.

If you’re using Windows 3.1, select Run from the File menu.

Type D:\INSTALL and click OK. (If your drive has a different

letter, substitute it for D.)

3. When you see the EPSON Digital Darkroom main screen, click

INSTALL PRINTER DRIVERS. Then follow the instructions

on the screen to install your printer driver software.

After installation is complete, you can use the EPSON Digital

Darkroom CD-ROM to install LivePix™(Windows 95 only) or

print the coupon.

Installing the Software on a Macintosh

1. Turn on your printer, then turn on your Macintosh. Make sure

you turn off any virus protection programs you may be using.

2. Insert the EPSON Digital Darkroom CD-ROM and

double-click the EPSON Digital Darkroom icon.

3. When you see the EPSON Digital Darkroom main screen, click

INSTALL PRINTER DRIVERS. Then follow the instructions on

the screen to install your printer driver software.

After your Macintosh restarts, you can open the EPSON Digital

Darkroom CD-ROM again and install Live Picture®or print the

coupon. But before you can print, you must select your printer in

the Chooser as described below.

SelectingYour Printer

After you install the software, you need to select your printer

using the Chooser.

1. Open the Chooser and click the EPSON Stylus (EX) icon.

2. Select the port where you connected your printer.

3. Turn on background printing if you want to run your

print jobs and use your Macintosh at the same time.

(Background printing is slower and may also slow down

your Macintosh while you’re printing.)

4. If you’re using the printer port on your Macintosh, make

sure AppleTalk is inactive.

Quick setup Comoro 5/22/97, 10:18 AM8

Andere Handbücher für Stylus Photo - Ink Jet Printer

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Epson Drucker Handbücher

Epson

Epson Stylus Photo R3000 Series Bedienungsanleitung

Epson

Epson LQ-2170 Abmessungen

Epson

Epson LX-810 Bedienungsanleitung

Epson

Epson U375 - TM B/W Dot-matrix Printer Bedienungsanleitung

Epson

Epson F6070 Bedienungsanleitung

Epson

Epson Stylus Photo 720 Bedienungsanleitung

Epson

Epson AcuLaser M4000N Bedienungsanleitung

Epson

Epson LQ-1050 Bedienungsanleitung

Epson

Epson 1400 - Stylus Photo Color Inkjet Printer Bedienungsanleitung

Epson

Epson Stylus Pro GS6000 Bedienungsanleitung

Epson

Epson StylusRIP Professional (Stylus Photo 2200 Abmessungen

Epson

Epson XP-332A Bedienungsanleitung

Epson

Epson TM-m50 Bedienungsanleitung

Epson

Epson XP-630 Bedienungsanleitung

Epson

Epson WorkForce EC-4040 Bedienungsanleitung

Epson

Epson WorkForce 845 Bedienungsanleitung

Epson

Epson TM-T88V-i Bedienungsanleitung

Epson

Epson FX-2190 Bedienungsanleitung

Epson

Epson J2100 - TM Color Inkjet Printer Bedienungsanleitung

Epson

Epson Disc Producer PP-100AP Bedienungsanleitung

Epson

Epson Photo750 Bedienungsanleitung

Epson

Epson Stylus Pro 7880 ColorBurst Edition - Stylus Pro 7880... Bedienungsanleitung

Epson

Epson T20IIIL-T Bedienungsanleitung

Epson

Epson SC-F9400H Series Handbuch

Beliebte Drucker Handbücher anderer Marken

Lexmark

Lexmark 1400 Series Handbuch

Canon

Canon i70 Series Bedienungsanleitung

Evolis

Evolis Elypso Bedienungsanleitung

Kyocera

Kyocera FS-9530DN Bedienungsanleitung

Canon

Canon LASER SHOT LBP-1210 Bedienungsanleitung

Samsung

Samsung BIXOLON SRP-350plusF Bedienungsanleitung

Canon

Canon PIXMA PRO-1 Series Bedienungsanleitung

Canon

Canon PIXMA G3560 Einrichtungshandbuch

Dell

Dell Color Laser Printer 2130cn Bedienungsanleitung

Tektronix

Tektronix Phaser 840 Bedienungsanleitung

Canon

Canon CLBR 460ps Bedienungsanleitung

Eltron

Eltron P210 Guide Bedienungsanleitung

Ricoh

Ricoh MD-P1 Bedienungsanleitung

Canon

Canon imagePASS-A2 Bedienungsanleitung

Canon

Canon S820D Bedienungsanleitung

IRA3D

IRA3D POETRY4 Bedienungsanleitung

Ricoh

Ricoh Aficio AP400 Bedienungsanleitung

BIXOLON

BIXOLON SRP-352plusV Bedienungsanleitung