ETIGER ES-S7AU Bedienungsanleitung

www.etiger.com EN

ES-S7AU

Outdoor Siren

Features

- Wireless connection for an easy installation

- Radio-frequency security of the accessories:

more than one million of codes combinations

- EEPROM information protection, power failure

will not damage data

- Simplied accessory expansion by easy

connection

- Compatible with eTIGER Security Kits

- Silent at night

Box Content

1 x ES-S7AU

1 x 12V Adaptor

1 x Backup Battery (built-in)

1 x User Manual

General information

The signal of the ES-S7AU is transmitted by radio-

frequency, which makes its installation easier.

Several ES-S7AU can be installed in dierent indoor

locations to deter illegal intrusions. Several ES-

S7AU can be registered in the control panel of your

alarm system. When your alarm system detects an

intrusion, the ES-S7AU rings out and its strobe lights

turn on.

The ES-S7AU can also be used as a standalone alarm

system by registering wireless accessories in the

siren.

Layout

Tamper switch

Siren

Power switch

Connect button

Strobe light

Use as an additional siren

If the siren is used as an additional siren, it must be

registered to your alarm’s control panel. If the alarm

is triggered, the ES-S7AU will ring out and its LED

lights will turn on.

Regardless the system is armed or disarmed,

press the Connect button to switch to Connection

mode. The LED indicator turns on: you are now in

connection mode for 20 seconds. Press any of the

“SOS”, “ Disarm” or “Arm” buttons on the control

panel of your alarm system. You hear short beeps:

the siren has been registered in the control panel

successfully.

Note

Do not trigger any sensor when registering the

siren in the control panel.

Test

Press the “Arm” button on the control panel. The

built-in speaker of the control panel beeps and

the LEDs of the ES-S7AU turn on for 4 seconds: the

connection is successful. If not, the connection has

failed, try registering the siren again.

Use as a standalone alarm system

The ES-S7AU can be connected to wireless

accessories to be used as an independent alarm

system.

When the system is armed, if a sensor is triggered,

the siren will ring out and the strobe lights will turn

on.

Connect a wireless sensor

Wireless sensors must be registered in the siren

before being used with it. Press the Connect button

to switch to connection mode. The LED indicators

turn on: you are now in connection mode for 20

seconds. Trigger the accessory (e.g. press any button

on the remote if you want to connect a remote

control). You hear short beeps: the accessory has

been connected to the siren successfully.

The siren supports up to 20 wireless accessories.

Test

Press the “Arm” button of the remote control. The

LEDs of the ES-S7AU turn on for 4 seconds: the

connection is successful. Trigger a sensor that is

already connected to the siren, the siren will ring

out. If not, the connection has failed, try registering

the siren again.

Clear all accessories

It is recommended to clear every accessory from

the siren if you were to lose one of them, especially

if you have lost your remote control.

Regardless the system is armed or disarmed, press

and hold the Connect button until you hear 3

beeps (7 seconds): all accessories or contol panels

connected have been cleared from the siren. To use

the siren again, register wireless accessories in the

siren again.

Specications

Power supply

Input: AC 110V

~ 220V/50-60Hz

Output: DC 12V/800mA

Static current

< 2mA

Alarm current

< 300mA

Volume

100dB

Radio frequency

315MHz (±75KHz)

Housing material

ABS plastic

Operating conditions

Temperature:

14 °F ~ +131 °C

Relative Humidity: ≤80%

(non-condensing)

Dimensions

5.71” x 2.93” x 1.5”

Standards

This product bears the selective sorting symbol for

waste electrical and electronic equipment (WEEE).

This means that this product must be handled

pursuant to European Directive 2002/96/EC in

order to be recycled or dismantled to minimize

its impact on the environment. For further

information, please contact your local or regional

authorities. Electronic products not included in the

selective sorting process are potentially dangerous

for the environment and human health due to the

presence of hazardous substances.

In compliance with European laws.

This product was designed and manufactured

in compliance with Directive 2002/95/EC of the

European Parliament and of the Council on the

restriction of use of certain hazardous substances in

electrical and electronic equipment (RoHS Directive

- RoHS) and is deemed to comply with the maximum

concentration values set by the European Technical

Adaptation Committee (TAC).

Manufactured in China.

FCC Statement

This device complies with Part 15 of the FCC rules. Operation is

subject to the following two conditions: (1) This device may not

cause harmful interference, and (2) This device must accept any

interference received, including interference that may cause

undesired operation. Any change or modication not expressly

approved by eTIGER may void the user’s authority to operate

the equipment.

This equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant to Part

15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and

can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is

no guarantee that interference will not occur in a particular

installation.

If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the

equipment o and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit dierent from

that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for

help.

Images, illustrations and text are non-contractual. ETIGER and

the ETIGER logo are registered trademarks and the property of

ES-S7AU–UM-EN20150310-1.0-W

ETIGER USA

1500 Fashion Island Blvd. Suite 102, San Mateo, CA 94404, USA

service@etiger.com

This user manual is available in other languages at

www.etiger.com/us/support

Inhaltsverzeichnis

Andere eTIGER Sicherheitssystem Handbücher

eTIGER

eTIGER ES-D4A Bedienungsanleitung

eTIGER

eTIGER S3b Sim Secual Bedienerhandbuch

eTIGER

eTIGER S3 Sim Secual Bedienungsanleitung

eTIGER

eTIGER S4 Combo Secual Bedienungsanleitung

eTIGER

eTIGER S5 Bedienungsanleitung

eTIGER

eTIGER S3b Sim Secual Bedienungsanleitung

eTIGER

eTIGER S2 Bedienungsanleitung

eTIGER

eTIGER ES-S6A Bedienungsanleitung

eTIGER

eTIGER S4 Cell + Line Bedienungsanleitung

eTIGER

eTIGER S3b Sim Secual Bedienungsanleitung

eTIGER

eTIGER ES-D3B Bedienungsanleitung

eTIGER

eTIGER secual box Bedienungsanleitung

eTIGER

eTIGER ES-S7A Bedienungsanleitung

eTIGER

eTIGER S3b Bedienungsanleitung

eTIGER

eTIGER Secual Box V2 Bedienungsanleitung

eTIGER

eTIGER secual box Bedienungsanleitung

eTIGER

eTIGER S3b Sim Secual Bedienerhandbuch

eTIGER

eTIGER ES-D3A Bedienungsanleitung

eTIGER

eTIGER S3b Sim Secual Bedienungsanleitung

eTIGER

eTIGER S5 Bedienungsanleitung

eTIGER

eTIGER S4 Combo Secual Bedienungsanleitung

eTIGER

eTIGER Secual Box V2 Bedienungsanleitung

eTIGER

eTIGER S4 Combo Secual Bedienungsanleitung

eTIGER

eTIGER ESB-WS2A Bedienungsanleitung

Beliebte Sicherheitssystem Handbücher anderer Marken

Inner Range

Inner Range Concept 2000 Bedienungsanleitung

Climax

Climax Mobile Lite R32 Montageanleitung

CADDX

CADDX NX-6 Bedienungsanleitung

FBII

FBII XL-31 Series Bedienungsanleitung

Johnson Controls

Johnson Controls PENN Connected PC10 Bedienungsanleitung

Aeotec

Aeotec Siren Gen5 Bedienungsanleitung

Blaupunkt

Blaupunkt SA 2700 Bedienungsanleitung

IDEAL

IDEAL Accenta Betriebsanleitung

AJAX

AJAX DoubleButton Bedienungsanleitung

Swann

Swann SW-P-MC2 Bedienungsanleitung

Ecolink

Ecolink Siren+Chime Bedienungsanleitung

Digital Monitoring Products

Digital Monitoring Products XR150 Bedienungsanleitung

EDM

EDM Solution 6+6 Wireless-AE Bedienungsanleitung

Highway Safety Group

Highway Safety Group EA401 Bedienungsanleitung

Siren

Siren LED GSM Bedienungsanleitung

Detection Systems

Detection Systems 7090i Montageanleitung

Se-Kure Controls

Se-Kure Controls MicroMini SK-4841 Bedienungsanleitung

Siemens

Siemens FDM273 Bedienungsanleitung

eTIGER ES-S7AU Bedienungsanleitung

Beliebte Sicherheitssystem Handbücher anderer Marken