ETS-Lindgren 4340 Bedienungsanleitung

Model 4340

Digital Camera System

(CCTV)

User Manual

ii |

ETS-Lindgren Inc. reserves the right to make changes to any product described

herein in order to improve function, design, or for any other reason. Nothing

contained herein shall constitute ETS-Lindgren Inc. any product or circuit

described herein. ETS-Lindgren Inc. does not convey any license under its

patent rights or the rights of others.

document may be copied by any means without written permission from

ETS-Lindgren Inc.

Trademarks used in this document: The ETS-Lindgren logo is a trademark of

ETS-Lindgren Inc.; Microsoft, Windows, and Internet Explorer are registered

trademarks of Microsoft Corporation in the United States and/or other countries;

Intel and Pentium are registered trademarks of Intel Corporation.

Revision Record

MANUAL,4340,PAN CAMERA | Part #399371, Rev. A

Revision

Description

Date

Initial Release

May, 2013

| iii

Table of Contents

Notes, Cautions, and Warnings................................................ v

1.0 Introduction..........................................................................7

Standard Configuration and Components ................................................... 7

Optional Configurations and Additional Components ................................ 10

If You Have a Chamber With A Shielded Control Room.................... 10

If You Have a Tripod Mount.............................................................. 10

If You Have a Multi-Camera System................................................. 11

Power Supply Options .............................................................................. 12

10/100 Ethernet Filter ....................................................................... 12

Battery Pack and Charger................................................................. 12

H-491009 Tripod....................................................................................... 13

About Installation and Setup..................................................................... 13

Installation and Setup Checklist........................................................ 14

ETS-Lindgren Product Information Bulletin ............................................... 14

2.0 Maintenance .......................................................................15

Replacement and Optional Parts .............................................................. 16

Service Procedures .................................................................................. 17

3.0 Specifications.....................................................................19

Camera Enclosure, Converter Enclosure, Dome....................................... 19

Battery Pack and Charger......................................................................... 20

Panasonic Network Camera WV-SC385................................................... 21

4.0 Pre-Installation Tasks........................................................23

Demonstrate Good Shielding Practices..................................................... 23

Choose the Camera Location ................................................................... 24

5.0 Install the 10/100 Ethernet Filter.......................................25

Overview of 10/100 Ethernet Filter Connections ....................................... 26

Overview of 10/100 Ethernet Filter Operation ........................................... 26

Installing a Schuko Plug............................................................................ 27

6.0 Wall or Ceiling Mount the Camera ...................................29

7.0 Install Optional Components............................................33

If You Have a Chamber with a Shielded Control Room............................. 33

iv |

Chamber With Shielded Control Room—Additional Pre-installation

Tasks................................................................................................ 35

Chamber With Shielded Control Room—Installation Tasks............... 35

If You Have a Tripod Mount (For Use with or without Shielded Control

Room)....................................................................................................... 37

Tripod Mount—Additional Pre-Installation Tasks............................... 39

Tripod Mount—Installation Tasks...................................................... 39

If You Have a Multi-Camera System (For Use with or without Shielded

Control Room) .......................................................................................... 42

Multi-Camera System—Additional Pre-installation Tasks.................. 45

Multi-Camera System—Installation Tasks......................................... 45

8.0 Computer Setup.................................................................47

Minimum Computer Requirements............................................................ 47

Setup the Computer.................................................................................. 47

Viewing Images from a Multi-Camera System........................................... 48

9.0 Operation............................................................................49

Operating Notices..................................................................................... 49

Viewing Images from the Camera............................................................. 50

If the Camera Stops Working............................................................ 50

Using Multiple Cameras............................................................................ 50

Arranging Multi-Camera Images ....................................................... 51

Setting Up a Multi-Screen Configuration ........................................... 51

Setting Resolution & Frame Rate.............................................................. 52

Operating the Battery Pack....................................................................... 53

Using the Battery Pack...................................................................... 53

Storing the Battery Pack ................................................................... 55

Charging the Battery Pack................................................................ 56

Replacing the Battery Pack............................................................... 58

Appendix A: Warranty .............................................................63

Appendix B: EC Declaration of Conformity ..........................65

| v

Notes, Cautions, and Warnings

Note: Denotes helpful information intended to

provide tips for better use of the product.

Caution: Denotes a hazard. Failure to follow

instructions could result in minor personal injury

and/or property damage. Included text gives proper

procedures.

Warning: Denotes a hazard. Failure to follow

instructions could result in SEVERE personal injury

and/or property damage. Included text gives proper

procedures.

See the ETS-Lindgren Product Information Bulletin for safety,

regulatory, and other product marking information.

vi |

This page intentionally left blank.

Introduction | 7

1.0 Introduction

The ETS-Lindgren Model 4340 Digital Camera System (CCTV) is designed to

monitor tests conducted in anechoic or reverb chambers and large test cells

where moderate EMI field strengths are present. Depending on the configuration,

the camera is connected to a personal computer outside the chamber by either

Ethernet or fiber optic cables. When the camera and computer are on, the

camera image displays in a browser window at the computer. From the browser

window you can control these camera features:

Pan and tilt—Move the camera lens up and down, and from side to

side to create a wide area of vision.

Zoom—18x optical zoom with 12x digital/electronic zoom enabling

216x zoom; 36x extra optical zoom under VGA resolution with

12x digital/electronic zoom enabling 432x zoom.

Standard Configuration and Components

The standard configuration for the Model 4340 CCTV is installed into a chamber

without a shielded control room.

See the diagram on the following page.

8 | Introduction

Introduction | 9

The standard configuration for the Model 4340 CCTV includes these

components:

Panasonic Network Camera WV-SC385—Includes Ethernet cable

and power cable connected to camera.

Shielded camera enclosure with dome—Includes camera

penetration connected to enclosure, and absorber wrap for the

enclosure.

Mounting hardware—The hardware allows you to mount the camera

enclosure from the wall or ceiling, and includes two 12-inch pipe

lengths, one 6-inch pipe length, one elbow joint (for wall mount only),

four pipe-to-pipe couplers, and absorber wrap for the assembled pipe.

10/100 Ethernet Filter—Provides one Ethernet connector, two

fiber optic connectors, an Ethernet-to-fiber optic converter, and a

fiber optic to Ethernet converter. Depending on your configuration, the

fiber optic to Ethernet converter may be provided as an internal or

external converter. Following are the two types of 10/100 Ethernet

filters:

–LMF-4095 10/100 Ethernet filter—Includes internal

fiber optic-to-Ethernet converter.

–LMF-4106 10/100 Ethernet filter—Includes external

fiber optic-to-Ethernet converter.

Personal Computer—Includes monitor, mouse, and keyboard.

10/100 Network Switch—If you ordered a multi-camera configuration,

you will install the 10/100 network switch. If you ordered a

single-camera configuration, you will not install the switch. In that case,

store the 10/100 network switch in a safe location for future expansion

of your Model 4340 CCTV.

A 30-meter Ethernet cable is included with some configurations.

10 | Introduction

Optional Configurations and Additional Components

Following are the optional configurations for the Model 4340 CCTV, including a

list of additional components required to install the configuration. For diagrams

and more information on installing an optional configuration, see Install Optional

Components on page 33.

IF YOU HAVE A CHAMBER WITH ASHIELDED CONTROL ROOM

You need these additional components:

Fiber optic-to-Ethernet converter

Ethernet cable to connect computer to converter (not included with all

configurations)

Fiber optic feedthrough connectors

30-meter fiber optic cable

3-meter fiber optic cable

IF YOU HAVE A TRIPOD MOUNT

For use with or without a shielded control room.

You need these additional components:

ETS-Lindgren H-491009 tripod

Battery pack and charger

Fiber optic-to-Ethernet converter

Ethernet cable to connect computer to converter (not included with all

configurations)

Fiber optic feedthrough connectors

30-meter fiber optic cable

3-meter fiber optic cable (only for installations with a shielded

control room)

Inhaltsverzeichnis

Beliebte Sicherheitskamera Handbücher anderer Marken

Okina USA

Okina USA SIR36-870VF650LP Bedienungsanleitung

Divio

Divio NDR155PA Bedienungsanleitung

Canon

Canon VB-C500D Bedienungsanleitung

Easy Access

Easy Access EasyGuard Bedienungsanleitung

Vivotek

Vivotek FD9389-EHV-v2 Bedienungsanleitung

TUYA

TUYA COSMO W2 Bedienungsanleitung

Eusso

Eusso UNC7500-IR Einrichtungshandbuch

urmet domus

urmet domus 1096/204 Bedienungsanleitung

VC VC20 series Bedienungsanleitung

Axis

Axis Q1614 Bedienungsanleitung

ieGeek

ieGeek DD201 Bedienungsanleitung

VADDIO

VADDIO ClearVIEW HD-USB PTZ 999-6990-000 Bedienungsanleitung

Vicon

Vicon V662-D-1 Betriebsanleitung

Grundig

Grundig GCH-K0274P Bedienungsanleitung

Lorex

Lorex VANTAGE LBC7032 Bedienungsanleitung

4xem

4xem WPT Bedienungsanleitung

Samsung

Samsung SCV-3082 Bedienungsanleitung

Vitek

Vitek VTC-C544 Bedienungsanleitung