ETS SM1-WP Bedienungsanleitung

SM1-WP Microphone Instructions

The SM1-WP is a high quality, 12VDC powered, flush mount, omni-directional, pre-amplified,

weather proof microphone for use with DRVs, I/P cameras, etc. Note- the audio output of the

SM1-WP is “line level” (0db).

SM1-WP Microphone Placement.

The SM1-WP is designed for outdoor applications and can even withstand complete submersion

in water. Do not mount the microphone near air conditioning vents, light fixtures or electrical

equipment. The SM1-WP should be placed at least five feet away from the subject(s) to be

monitored. The SM1-WP is still useable in the range of 15-25 feet but is dependent on the level of

background noise in the area. Experimentation in the environment will determine what distances

work best.

Cable Run

Run a 22 gauge, stranded, two conductor shielded cable between the SM1-WPW microphone

and the monitoring device. Keep the cable run distance under 1,000 feet and away from AC

power sources, light fixtures and electrical equipment. Connect power to the + terminal, the audio

signal to the “audio” terminal and ground to the – terminal. The Ground of the power and audio

signal must share a common ground for proper operation. See Figure 1 for connection diagram.

Mounting

The SM1-WP is designed to be surface mounted on any flat surface or on an exterior single gang

“bell” electrical box. Be sure to use the supplied gasket to prevent water from entering the

electronics.

Adjusting the SM1-WP Gain

The SM1-WP is shipped with the gain set at midrange. If the sound at the “head end” is distorted,

rotate the control towards the – mark (counter-clockwise). If the volume at the “head end” is too

low, rotate the control towards the + mark (clockwise).

Figure 1.

Caution

It may be against the law to install this microphone kit in certain environments. It may also be against the law

to record conversations of the person(s) being monitored without their knowledge. It is the responsibility of

the installation company and end-user to determine if the application of this product is legal. These laws vary

from state to state. If you are not informed on these matters, consult a qualified attorney or contact the

appropriate state agency. A sticker is provided with this kit for the applications where notification must be

posted.

Warranty

All ETS products carry a one year parts and labor warranty. This warranty does not cover damages as a

result of misuse, improper handling of the unit or exposure to extreme temperatures or moisture. At its

discretion, ETS reserves the right to repair or replace this unit under the conditions of the warranty. If you

experience problems with your equipment call ETS at: 505-888-3923 to obtain a return authorization

number. Equipment requiring repair beyond the warranty period or units that have been damaged or are not

covered under the warranty can be repaired by ETS for a minimal cost under most conditions.

Made in the USA

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Beliebte Mikrofon Handbücher anderer Marken

IK Multimedia

IK Multimedia iRig Stream MIC PRO Bedienungsanleitung

DAPAudio

DAPAudio RM-101 Bedienungsanleitung

AKG

AKG CHM 21 Bedienungsanleitung

Sennheiser

Sennheiser evolution wireless series EM 100 Bedienungsanleitung

Sony

Sony C-48 Bedienungsanleitung

GIGAMEDIA

GIGAMEDIA GGM PAMICUHFG Bedienungsanleitung

Shure

Shure WH30TQG Bedienungsanleitung

auna PRO

auna PRO MIC-900 Bedienungsanleitung

AKG

AKG D 3800 Bedienungsanleitung

Shure

Shure KSM141 Bedienungsanleitung

MAIIN SOUND

MAIIN SOUND IIN style Bedienungsanleitung

Earthworks

Earthworks TC25 Bedienungsanleitung

Sennheiser

Sennheiser evolution D1 Bedienungsanleitung

Alesis

Alesis MicLink Wireless Bedienungsanleitung

DSPPA

DSPPA D6234 Bedienungsanleitung

Monacor

Monacor IMG STAGELINE ECM-300B Bedienungsanleitung

Ansr Audio

Ansr Audio Scan16 Bedienungsanleitung

Shure

Shure MXA710 Series Bedienungsanleitung