Euphonix System 5 Bedienungsanleitung

System 5 Post and

Film Setup Guide

Document Revision: 1.2

Release Date: January 2006

Euphonix Inc.

220 Portage Ave.

Palo Alto, California 94306

Phone: 650-855-0400

Fax: 650-855-0410

Web: http://www.euphonix.com

e-mail: info@euphonix.com

Euphonix System

In the interest of continued product development, Euphonix reserves the right to make

improvements in this manual and the product it describes at any time, without notice or

obligation.

System 5, S-5, PatchNet, eMix, EuCon, R-1, Audio Deck, Studio Hub are trademarks of

Euphonix Inc.

reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any

language in any form by any means without written permission of Euphonix, Inc.

Euphonix System 5 Post and Film Setup Guide

iii

Table of Contents

CM403 Installation ..........................................................................................................................5

CM403 Module..............................................................................................................5

External Record Control................................................................................................6

Film Panel Installation...................................................................................................7

Joystick Panel Installation .............................................................................................9

Blank Panel..................................................................................................................10

Record Control Setup.....................................................................................................................11

Solo Linking ..................................................................................................................................12

Physical Connection Between Systems.......................................................................12

Network Settings..........................................................................................................13

Setting up MOConfig...................................................................................................25

Bus Cascade Inputs........................................................................................................................25

Block Diagram...............................................................................................................................26

Euphonix System 5 Post and Film Setup Guide

CM403 Installation

CM403 Module

The CM403 uses the same form factor and architecture as a standard control module

(CM401, 402, 408). A single Ethernet port connects the module to the system via the

100 BaseT EuCon switch. The CM403 houses a TFT and fits three panels of the same

size: Film Post and the Dual-Joystick Panels. The Film Post panel can be placed above

or below the Joystick Panel depending on the preference of the operator. The user has

the option of placing their own motion controller, such as a JSK Engineering Inc. P2

Control Head or Soundmaster ION™, into the spare panel.

Figure 1 CM403 Module with Film Post Panel and Joysticks

Euphonix System 5 Post and Film Setup Guide

ID selection

Up to four CM403 modules can be installed in a System 5 console. Set the ID switches

on the back panel of the module according to Table 1:

Table 1 CM403 ID Switch Settings

NOTE: In a dual-operator console, all CM403 modules are connected to the master

console, which is used for monitoring and record control.

External Record Control

The Euphonix EXT 25-pin connector on the rear panel of the CM403 accepts two

external closures:

Table 2

The+5V outputon theconnector isinternally protectedby a 200 mA self-resetting fuse.

The active-high switch inputs are TTL-level inputs with 100 K pull-down resistors.

CM403 # Frame ID Module ID Position # in

eMix

1 1H 13 1–29

2 1H 14 1–30

3 1H 15 1–31

4 1H 16 1–32

Function Switch Input +5 V

Record In Pin 25 Pin 13

Record Out Pin 11 Pin 13

Euphonix System 5 Post and Film Setup Guide

Film Panel Installation

NOTE: Each instruction pertains to the picture beneath its text.

Connect the 5-V power cables (red) from the Film Panel to the header block on the bot-

tom of the module. Be sure to maintain correct polarity (red/white stripe is negative).

Connect the 12-V power connection to the mating connector coming from the PSU.

Connect the PC104 cable to H26 on the Film Panels 386 board.

Euphonix System 5 Post and Film Setup Guide

Connect the opposite end of the PC104 cable to the PC104 card on the SBC (Single

Board Computer) mounted on the rear ventilation panel of the module. Secure the RF

choke as shown above.

Connect the Euphonix Ext cable (25-pin D-sub on the rear panel) to H103 on the upper

board of the Film Panel.

Euphonix System 5 Post and Film Setup Guide

Connect the TFT backlight cable to the connector on the upper board of the film panel.

Joystick Panel Installation

Connect the 5-V power cables (red) from the Joystick to the header block on the bottom

of the module. Be sure to maintain correct polarity (red/white stripe is negative). See

thephoto in Film Panel Installation. Connect the serial cables from the 9-pin connectors

on the rear panel of the CM403 to the headers on the joystick PCBs. Attach two serial

cables between the external CM403 9-pin joystick ports and the adjacent CM408 9-pin

serial ports.

Euphonix System 5 Post and Film Setup Guide

Blank Panel

800

300

800

1.1

11.

960

11.

960

FREE SPACE

500

Andere Handbücher für System 5

Inhaltsverzeichnis

Andere Euphonix Musikmixer Handbücher

Euphonix

Euphonix MC Mix Bedienungsanleitung

Euphonix

Euphonix R-1 Transfer Station Bedienungsanleitung

Euphonix

Euphonix MC Mix Bedienungsanleitung

Euphonix

Euphonix R-1 Transfer Station Bedienungsanleitung

Euphonix

Euphonix System 5 Bedienungsanleitung

Euphonix

Euphonix Max Air Control surface Gebrauchs- und Wartungshandbuch

Euphonix

Euphonix System 5B Bedienungsanleitung

Euphonix

Euphonix Max Air Control surface Bedienungsanleitung

Euphonix

Euphonix MC Mix Bedienungsanleitung

Euphonix

Euphonix Max Air Control surface Bedienungsanleitung

Euphonix

Euphonix MixView CS3000 Bedienungsanleitung

Euphonix

Euphonix MixView CS3000 Kurzanleitung

Euphonix

Euphonix MC Mix Bedienungsanleitung

Euphonix

Euphonix System 5 Bedienungsanleitung

Euphonix

Euphonix EuCon Bedienungsanleitung

Euphonix

Euphonix System 5 Bedienungsanleitung

Euphonix

Euphonix MixView CS3000 Kurzanleitung

Euphonix

Euphonix System 5 Bedienungsanleitung

Euphonix

Euphonix System 5 Bedienungsanleitung

Euphonix

Euphonix MC Mix Bedienungsanleitung

Euphonix

Euphonix System 5 Control Surface/Frame Bedienungsanleitung

Beliebte Musikmixer Handbücher anderer Marken

Neve

Neve 8816 Bedienungsanleitung

Mackie

Mackie Onyx Analogue Mixer Bedienungsanleitung

Behringer

Behringer EUROPOWER PMP518M Bedienungsanleitung

Peavey

Peavey S-32 Sanctuary Series Bedienungsanleitung

Rane

Rane MP 4 Bedienungsanleitung

True

True T9 Touchscreen Console Bedienungsanleitung

Studiomaster

Studiomaster Air Pro 24 Bedienungsanleitung

Pioneer

Pioneer SVM 1000 - Audio/Video Mixer Bedienungsanleitung

Roland

Roland M-160 Bedienungsanleitung

Yamaha

Yamaha MR1642 Bedienungsanleitung

Ecler

Ecler MAC40v Bedienungsanleitung

Pioneer

Pioneer DJM 909 - Battle Mixer W/Effects Bedienungsanleitung

Veeder-Root

Veeder-Root TLS-350 Series Bedienungsanleitung

Alto

Alto APM80.QUAD Bedienungsanleitung

Omnitronic

Omnitronic PM-211 Bedienungsanleitung

SoundCraft

SoundCraft B400 Bedienungsanleitung

Roland

Roland SoundCanvas SC-8820 Bedienungsanleitung

CARVIN

CARVIN RX 1200 Bedienungsanleitung