Evonicfires e-lectra Banff Bedienungsanleitung
STOVESSTOVES
INSTALLATION MANUALINSTALLATION MANUAL
1
EVONIC - 104 INSTRUCTION MANUAL TEMPLATE ISS. 1EVONIC - 104 INSTRUCTION MANUAL TEMPLATE ISS. 1 STOVES. 1STOVES. 1
evonicfires
ee-lectra Banff-lectra Banff
ee-lectra-lectra C600C600
TuvaTuva
HalmstadHalmstad
HaldenHalden
The following materials and components should be disposed of in accordance with the below table.
Metal -
Steel or cast iron
Can be taken to a local recycling centre for reuse to reduce waste going to landfill.
Glass & Screens Can be taken to a local recycling centre for reuse to reduce waste going to landfill.
Vermiculite Non hazardous material. Vermiculite can be crushed up and used for plant bedding and ash
used for composting or disposed of at a local recycling centre for reuse to reduce waste going to
landfill.
Electrical components -
Fans, heater elements,
PCB’s, Power pack’s,
LED’s
Dispose at a local recycling centre In accordance with latest WEEE directive.
Log fuel effects These logs contain refractory ceramic fibre materials which requires disposal in accordance with
WEEE legislation.
Natural Wood Can be taken to a local recycling centre for reuse to reduce waste going to landfill.
2EVONIC - 104 INSTRUCTION MANUAL TEMPLATE ISS. 1EVONIC - 104 INSTRUCTION MANUAL TEMPLATE ISS. 1 STOVES. 1STOVES. 1
CONTENTS
Health and safety.................................................................................................................................................................4
Checks before installation – All models................................................................................................................5
Free-standing Installation ............................................................................................................................................6
C600 Installation .................................................................................................................................................................7
C600 Heater removal .......................................................................................................................................................9
Glass Installation - Slotted ..........................................................................................................................................10
Glass Installation - Slide................................................................................................................................................. 11
ControlMethods………………………………………………………………………………………………………………...........................…....12
E-Smart Remote Control……………………………………………………………………………………………….................................13
E-Smart App Setup…………………………………………………………………………………………………………..........................…....14
Using the E-Smart App ………………………………………………………………………………………………...................................16
Control Overview……………………………………………………………………………………………………………...........................…....17
Programming the Timer……………………………………………………………………………………………..........................….......18
Connection Problems…………………………………………………………………………………………………..........................….......19
Connecting to Amazon Alexa…………………………………………………………………………………...........................….......20
Connecting to Google Home……………………………………………………………………………………...............................…22
Commands for Voice Control…………………………………………………………………………………...........................….......24
Retro-fitting the Remote Control…………………………………………………………………………...........................….......25
Warranty…………………………………………………………………………………………………………………………...........................…........26
All Evonic Fires products are in conformity with the relevant UK Statutory InstrumentsAll Evonic Fires products are in conformity with the relevant UK Statutory Instruments
(and their amendments).(and their amendments).
2016 No. 1101 The Electrical Equipment (Safety) Regulations 20162016 No. 1101 The Electrical Equipment (Safety) Regulations 2016
2016 No. 1091 The Electromagnetic Compatibility Regulations 20162016 No. 1091 The Electromagnetic Compatibility Regulations 2016
2012 No. 3032 The Restriction Of Use Of Certain Hazardous Substances In2012 No. 3032 The Restriction Of Use Of Certain Hazardous Substances In
Electrical And Electronic Equipment Regulations 2012Electrical And Electronic Equipment Regulations 2012
EU DIRECTIVES
All Evonic Fires products meet the requirements of the EC Directives.All Evonic Fires products meet the requirements of the EC Directives.
These directives have been met by compliance with the following standards:These directives have been met by compliance with the following standards:
EU 2011-65/EU 2015/863 Restriction of Hazardous Substances.EU 2011-65/EU 2015/863 Restriction of Hazardous Substances.
References to the relevant designated standards used:References to the relevant designated standards used:
EN 55014-1:2006 + A1:2009 + A2:2011 Electromagnetic Compatibility.EN 55014-1:2006 + A1:2009 + A2:2011 Electromagnetic Compatibility.
EN 55014-2:2015 Electromagnetic Compatibility.EN 55014-2:2015 Electromagnetic Compatibility.
EN 61000-3-2:2014 Electromagnetic Compatibility (EMC). Limits. Limits forEN 61000-3-2:2014 Electromagnetic Compatibility (EMC). Limits. Limits for
Harmonic Current Emissions.Harmonic Current Emissions.
EN 61000-3-3:2013 Electromagnetic Compatibility (EMC). Limits. Limitation ofEN 61000-3-3:2013 Electromagnetic Compatibility (EMC). Limits. Limitation of
Voltage Changes, Voltage Fluctuations and Flicker.Voltage Changes, Voltage Fluctuations and Flicker.
EN 60335-1:2012 + A11:2014 Household and similar electrical appliances - SafetyEN 60335-1:2012 + A11:2014 Household and similar electrical appliances - Safety
EN 60335-2-30:2009+A11:2012 Household and similar electrical appliances. Safety.EN 60335-2-30:2009+A11:2012 Household and similar electrical appliances. Safety.
Particular requirements for room heatersParticular requirements for room heaters
UKCA STANDARDS
3
EVONIC - 104 INSTRUCTION MANUAL TEMPLATE ISS. 1EVONIC - 104 INSTRUCTION MANUAL TEMPLATE ISS. 1 STOVES. 1STOVES. 1
IMPORTANT INFORMATION AND HEALTH & SAFETY
When using electrical appliances, basic precautions should always be followed to reduce the risk of fire,
electric shock, and injury to persons, including the following:
• Read all of the instructions carefully before using the appliance, only use this appliance as described
in this manual. Any other use not recommended by the manufacturer may cause injury to persons,Any other use not recommended by the manufacturer may cause injury to persons,
or damage to the appliance.or damage to the appliance.
• Remove all packaging and dispose of it at an appropriate recycling facility.
•• When transporting or storing the appliance and power lead, keep in a dry place, away from excessiveWhen transporting or storing the appliance and power lead, keep in a dry place, away from excessive
vibration and store so as to avoid damage.vibration and store so as to avoid damage.
• This fireplace is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. The trim
around the heater outlet becomes hot during heater operation. DANGER: High temperatures may be
generated under certain abnormal conditions.
• Do not install this appliance immediately in front of a fixed socket outlet.
• Do not install this appliance in the immediate surroundings of a bath, shower, swimming pool or any
other area where the appliance could come into contact with water or humidity, e.g. a bathroom.
•• Do not use in areas where gasoline, paint, or any flammable liquids are used or stored.Do not use in areas where gasoline, paint, or any flammable liquids are used or stored.
• This appliance is only suitable for indoor use, do not use outdoors.
• Do not cover the appliance, or let the air inlet/outlet to be obstructed in any way as it may overheat.
• Keep the power lead away from hot surfaces and the heater outlet. Do not route the power lead in
front of the appliance, or under any carpets or rugs. Do not allow the power lead to be coiled up once
installed, as this can cause overheating.
• This appliance must be firmly fixed to or recessed into, a flat internal wall.
• A maintenance hatch must be installed into the surrounding installation to allow future access.
• Always use a certified electrician should new circuits or outlets be required. And always use properly
grounded, fused and polarised outlets.
• Where the power lead passes through any masonry wall, stone surround etc. ensure that suitable
rubber bushes are fitted at any possible wear points.
• If the power lead is damaged do not use the appliance until it has been replaced.
• Do not use any external switching device, timers, or extension leads. Do not connect the appliance to
a circuit that is frequently switched on and off by the utility.
•• In the event of a malfunction, switch off the appliance, and disconnect it from the mains powerIn the event of a malfunction, switch off the appliance, and disconnect it from the mains power
supply. Have the appliance inspected by a certified electrician before reusing.supply. Have the appliance inspected by a certified electrician before reusing.
• Do not use the appliance if it is damaged. In the event of any damage to the appliance, please
contact the retailer from whom the appliance was purchased.
• Any repairs must only be performed by a certified electrician.
• Extreme caution is necessary when any heater is used by, located near children or people of reduced
mobility, and whenever the unit is left operating and unattended.
• Young children should be supervised to ensure that they do not play with the appliance.
•• Disconnect from the power supply before performing any cleaning, maintenance or relocation of theDisconnect from the power supply before performing any cleaning, maintenance or relocation of the
unit. Do not use steam cleaners, or aerosols near the appliance.unit. Do not use steam cleaners, or aerosols near the appliance.
• Do not burn wood or anything else in this appliance.
• Do not strike the glass. The glass used is toughened safety glass, if broken it will shatter into small
chunks which are less likely to cause injury.
• Do not drill or screw any new holes into the appliance.
4EVONIC - 104 INSTRUCTION MANUAL TEMPLATE ISS. 1EVONIC - 104 INSTRUCTION MANUAL TEMPLATE ISS. 1 STOVES. 1STOVES. 1
CHECKS BEFORE INSTALLATION - ALL MODELS
INSTALLATION DO’S AND DONT’S
Before installing the appliance please read and take into account the following important requirements;
• Consult a qualified professional to check the structure of the installation site.
• If installing into an existing chimney, make sure to adequately block off the flue.
• The appliance must never be installed in front of an electrical socket.
• The appliance must not be installed anywhere that it may come into contact with water, i.e. a
bathroom.
• Do not wet plaster directly onto the appliance.
CHECKS BEFORE INSTALLATION
We recommend turning on the appliance before installation, connect the appliance to a power source
using the provided electrical lead, and depress the right side of the ON/OFF switch.
Remove the electrical lead from the wall and continue with the installation.
Please note: The image below shows the C600 appliance. Not all stoves have the same ON/OFF switch
and Power Inlet location. ON/OFF switch locations and Power Inlet locations for all models can be found
on page 6.
5
EVONIC - 104 INSTRUCTION MANUAL TEMPLATE ISS. 1EVONIC - 104 INSTRUCTION MANUAL TEMPLATE ISS. 1 STOVES. 1STOVES. 1
Power Inlet
On/Off Switch
6EVONIC - 104 INSTRUCTION MANUAL TEMPLATE ISS. 1EVONIC - 104 INSTRUCTION MANUAL TEMPLATE ISS. 1 STOVES. 1STOVES. 1
STOVE INSTALLATION - BANFF / HALDEN / TUVA / HALMSTAD
The following models are free-standing appliances, which means that they can be situated almost
anywhere without any installation. Once the outer packaging has been removed and the product has
been tested (see page 5), the below models can then be placed in situ. Be sure to locate them as close to
a plug socket as possible to avoid the power lead running along the floor and becoming a trip hazard.
FREE-STANDING
HALDEN TUVA E-LECTRA BANFF
HALMSTAD
7
EVONIC - 104 INSTRUCTION MANUAL TEMPLATE ISS. 1EVONIC - 104 INSTRUCTION MANUAL TEMPLATE ISS. 1 STOVES. 1STOVES. 1
STOVE INSTALLATION - C600
1
Once you have slid the appliance into place, you can then go about securing it in position
by screwing it into the studwork frame. There are 4 holes located in each corner .
2
Once your studwork frame has been constructed, slide the appliance into the prepared
void.
8EVONIC - 104 INSTRUCTION MANUAL TEMPLATE ISS. 1EVONIC - 104 INSTRUCTION MANUAL TEMPLATE ISS. 1 STOVES. 1STOVES. 1
Once you have secured the fire into place, adding the outer frame is the final stage. The
outer frame of the C600 comes with either a 3-sided or 4-sided frame, which are both
attached using the same method. The frame uses a a combination of magnets and a push
fit method. The frame will slide perfectly into the front of the stove.
3
Above you will see suggested positioning for
the magnets, although they can be positioned
anywhere along the plaster kit to provide extra
support.
CONTINUED...
9
EVONIC - 104 INSTRUCTION MANUAL TEMPLATE ISS. 1EVONIC - 104 INSTRUCTION MANUAL TEMPLATE ISS. 1 STOVES. 1STOVES. 1
C600 HEATER REMOVAL
1
2
The heater for the C600 can be accessed from the front of the appliance. Following the
glass removal steps, remove the front glass and the rear glass to expose the heater
housing. The heater housing is attached using 4 screws - 1 in each corner of the housing.
Unscrew the heater housing and carefully pull the housing out towards you. To fully
remove the housing you will need to remove the wiring connecting the heater. You must
ensure the fire has been turned off at the mains before attempting this.
10 EVONIC - 104 INSTRUCTION MANUAL TEMPLATE ISS. 1EVONIC - 104 INSTRUCTION MANUAL TEMPLATE ISS. 1 STOVES. 1STOVES. 1
GLASS INSTALLATION
SLOTTED INSTALL
1To install the front glass first locate the four keyhole slots on the front of the appliance, and
the four screws on the back of the front glass.
The slotted install of the front glass applies to the e-lectra Banff, Halmstad, and Tuva. The model shown
in this example is the Halmstad, but the same process applies to all three models.
2Now line up the screws and screw holes and slot them into each other, then allow the
glass to drop into place.
Warning:
Always support the glass throughout
the entire process until the glass is
fully fitted. The glass is toughened
safety glass and if broken will shatter
into many small chunks.
Keyhole Slots
Screw
Heads
Dieses Handbuch passt für folgende Modelle
4
Inhaltsverzeichnis
Andere Evonicfires Herd Handbücher
Beliebte Herd Handbücher anderer Marken
Vermont Castings
Vermont Castings Intrepid 2 Bedienungsanleitung
Italiana Camini
Italiana Camini CLASSICA Kurzanleitung
Avalon
Avalon Vashon Avanti DVS FS Bedienungsanleitung
Spartherm
Spartherm ambiente a1 Bedienungsanleitung
Dimplex
Dimplex MCFSTV12AU Bedienungsanleitung
Warmlite
Warmlite WL46040 Bedienungsanleitung