Extron electronics VCM 200 D Bedienungsanleitung

MUTE

VOLUME

VCM 200 D

VCM 200 D • Installation Guide

This guide provides instructions for an experienced installer to install an

Extron VCM 200 D Remote Volume Controller.

The VCM 200 D is a remote volume/mute controller with a 10k ohm

potentiometer. It is designed to work solely with any Extron amplifier

product with a remote volume control port, such as the MPA 152 Plus

or MPA 601 Mini Power Amplifiers. The VCM 200 D is backwards

compatible, able to control existing ampliers and preampliers as well

as new ampliers and preampliers.

NOTE: Models of the VCM 200 D with an E number before E30472

are not compatible with newer amplifier models. The E number

is located next to the device serial number.

The VCM 200 D is shipped assembled with a black faceplate and knob, and mounts into a mud

ring (supplied) or a junction box (not supplied) and is finished by a decorator-style trim plate. A

white trim, bezel, and knob are also included.

NOTES:

• Check that the installation meets the local and state regulatory requirements, including

building, electrical, and safety codes, and UL and ADA accessibility requirements.

• For more information on safety guidelines, regulatory compliances, EMI/EMF

compatibility, accessibility, and related topics, see the Extron Safety and Regulatory

Compliance Guide on the Extron website.

• For product specications visit www.extron.com.

Installation

1. If the installation requires a white faceplate and knob

instead of black, change the faceplate and knob:

a. Turn the adjustment knob to its lowest setting

and, using the supplied hex key, turn counter-

clockwise to loosen the hex screw and remove

the knob (see image at right).

b. Turn the device over, press the two tabs on the

underside, and push the faceplate away.

c. Snap in the desired faceplate and install the

matching knob. Secure it in place by

turning the hex screw clockwise to

tighten it.

2. Connect the cables from the audio source

(amplier) location to the rear of the

VCM200D as shown:

GND = ground

VOL = volume and mute control with DC

voltage. The range is 0 to 10 V, where 0 V is

mute and 0 V is maximum volume.

10V = 10 VDC reference voltage

3. Mount the cabled device and attach

the decorator-style trim plate.

NOTE: Control signal ground pins may be labels as , GND, or G. The wiring and function

are the same, whichever way your product is labeled.

Amplifier

Rear Panel VCM

Rear Panel

Red

Black

Ground

VC G

10V

VOL

GND

MUTE

VOLUME

Turn knob to

expose screw.

Use Allen wrench

to remove screw.

VCM 200 D • Installation Guide (Continued)

68-2089-01

Rev. C 10 17

Operation

The Mute button toggles between mute and unmute. It lights bright red to indicate mute, and

dim white to indicate unmute.

Turn the Volume knob clockwise to increase the volume, and counterclockwise to decrease

the volume.

Audio Level Setting Procedure

To set the system level to not exceed the maximum volume:

1. Reduce the power amplier volume to minimum.

2. Turn the Volume knob clockwise on the VCM 200 to the maximum position.

3. Slowly turn up the power amplier to the system volume desired.

VCG

10V 50mA

REMOTE

STANDBY

TIMER OFF

INPUTS

CLASS 2 WIRING

MPA 601-70V

70V OUTPUT

(SUMMED)

POWER

12V

..A MAX

Extron

MPA 601

Mini Power

Amplier

Extron

MIX 301

Three Channel

Mixer

Wireless

Microphone System

MIX 301

3 CHANNEL

MIXER

IN 2 MIX OUT

IN 1 IN 3

12V

0.5a MAX

DVD Player

Left

Right

Extron

SI 3CT LP

Full-Range

Ceiling Speakers

VOLUME

VCM 100

Extron

VCM 200 D

Volume and

Mute Controller

VOLUME

MUTE

ATTENTION:

• Install into a UL Listed outlet/junction box with the provided faceplate or a UL Listed faceplate.

• Installer dans une prise de courant ou un boîtier de raccordement certié(e) UL avec le

panneau avant fourni ou un panneau avant certié UL.

• The installation shall be in accordance with the applicable provisions of the National Electrical

Code ANSI/NFPA 70, Article 725 and Canadian Electrical Code, Part 1, Section 16.

• Cette installation doit toujours être conforme aux dispositions applicables du Code américain

de l’électricité (National Electrical Code) ANSI/NFPA 70, article 725, et du Code canadien de

l’électricité, partie 1, section 16.

Inhaltsverzeichnis

Andere Extron electronics Controller Handbücher

Extron electronics

Extron electronics MEDIALINK MLC 52 Series Bedienungsanleitung

Extron electronics

Extron electronics MLC 226 IP Series Bedienungsanleitung

Extron electronics

Extron electronics MLC 62 Series Bedienungsanleitung

Extron electronics

Extron electronics CTR 8 Bedienungsanleitung

Extron electronics

Extron electronics MLC 226 IP Series Bedienungsanleitung

Extron electronics

Extron electronics TLP Pro 720C Bedienungsanleitung

Extron electronics

Extron electronics MLC 62 IR D Bedienungsanleitung

Extron electronics

Extron electronics MLC Plus 84 D Bedienungsanleitung

Extron electronics

Extron electronics CCI Pro 700 Bedienungsanleitung

Extron electronics

Extron electronics MEDIALINK MLC 52 Series Bedienungsanleitung

Extron electronics

Extron electronics Basic MediaLink Controllers MLC 52 IR Bedienungsanleitung

Extron electronics

Extron electronics Control Modules ACM Bedienungsanleitung

Extron electronics

Extron electronics FPC 6000 Bedienungsanleitung

Extron electronics

Extron electronics MediaLink MLC Plus 84 Series Bedienungsanleitung

Extron electronics

Extron electronics MLC 206 Stücklistenhandbuch

Extron electronics

Extron electronics MEDIALINK MLC 206 Bedienungsanleitung

Extron electronics

Extron electronics HD CTL 100 Bedienungsanleitung

Extron electronics

Extron electronics RAC 104 Bedienungsanleitung

Extron electronics

Extron electronics HD CTL 100 Bedienungsanleitung

Extron electronics

Extron electronics MediaLink MLC 104 Plus Series Bedienungsanleitung

Extron electronics

Extron electronics MLC 60 Series Bedienungsanleitung

Extron electronics

Extron electronics VNM EC 200 Bedienungsanleitung

Extron electronics

Extron electronics MLC 62 IR D Bedienungsanleitung

Extron electronics

Extron electronics RAC 104 Bedienungsanleitung

Beliebte Controller Handbücher anderer Marken

Digiplex

Digiplex DGP-848 Betriebsanleitung

YASKAWA

YASKAWA SGM series Bedienungsanleitung

Sinope

Sinope Calypso RM3500ZB Bedienungsanleitung

Isimet

Isimet DLA Series Style 2 Installationshandbuch

LSIS

LSIS sv-ip5a Bedienungsanleitung

Rockwell Automation

Rockwell Automation 1769-L31 Bedienungsanleitung

Airflow

Airflow Uno hab Bedienungsanleitung

ABB

ABB ACS580-01 drives Bedienungsanleitung

Panasonic

Panasonic GM1 Series Bedienungsanleitung

Emerson

Emerson SW93 Bedienungsanleitung

AutoAqua

AutoAqua Smart ATO micro SATO-120P Bedienungsanleitung

Panasonic

Panasonic FP? Positioning Unit RTEX Bedienungsanleitung

Samson

Samson Type 5824 Service-Handbuch

Alpha IP

Alpha IP MIOB 21001 Bedienungsanleitung

Siemens

Siemens OpenAir GMA 1 Series Bedienungsanleitung

Surecom

Surecom SR-629 Bedienungsanleitung

Fishman

Fishman TriplePlay Bedienungsanleitung

Regulus

Regulus SRS1 T Bedienungsanleitung