Extron electronics DTP HDMI 301 Bedienungsanleitung
DTP HDMI 301Tx Rear Panel DTP HDMI 301 Rx Rear Panel
DTP HDMI
30
1Tx Rear Pane
l
POWER
12V
RxTx
RS-232 IR
INPUTS
0.6 A MAX
RxTx
AUDIO
OUT
ANALOG AUDIO
SIG LINK
DTP OUT
D
TP HDMI
30
1 Rx Rear Pane
l
Front Panel
OUTPUTS
LR
AUDIO
POWER
12V
0.6 A MAX
IN
ANALOG AUDIO
SIG LINK
DTP IN
Front
Panel
FrontPanel
RxTx
RS-232 IR
RxTx DTP HDMI 301 Rx
4 43
3
6
7 71 52
DTP HDMI 301 • Setup Guide
This guide provides quick start instructions for an experienced installer to set up and operate
Extron DTP HDMI 301 digital video extender. The DTP 301 transmitter and receiver pair can
extend an HDCP-compliant HDMI signal up to 330 feet (100 m).
Installation
Step 1 — Mounting
Turn off or disconnect all equipment power sources and mount the Tx and Rx units as required.
Step 2 — Connections
aHDMI Input connector (Tx) — Connect an HDMI cable
INPUTS
AUDIO
between this port and the HDMI output port of the digital
video source.
bAudio input (Tx) — Connect an unbalanced stereo audio
source to this 3.5 mm mini stereo jack for an analog audio
input.
cRS-232 and IR connectors — To pass serial or infrared data or control signals, such as
serial control of a projector, connect the master device to the transmitter and the slave
device to the receiver via the RS-232 and IR captive screw connectors on both units.
dDTP and Analog Audio (Output and Input) RJ-45 connectors — Connect one or
two TP cables between these RJ-45 female connectors on the transmitter and receiver.
Ü DTP connector (required) — Connect transmitter DTP Out to receiver DTP In.
This cable carries:
zTMDS (digital) video
zEmbedded audio
zBidirectional RS-232 and IR commands and data
zRemote power
Signal LED — This LED lights when the unit is receiving a TMDS clock signal on the
HDMI input (transmitter) or any valid signal on the DTP In connector (receiver).
Link LED — This LED lights a valid link is established between the units on the DTP
cable.
á Analog Audio connector (optional) — Connect transmitter Analog Audio Out to receiver Analog Audio In. This cable
carries analog audio only and is not needed for applications that do not require this audio signal.
Terminate all cable ends in accordance with the same standard, either TIA/EIA T 568 A or TIA/EIA T 568 B.
CAUTION: Do not connect these devices to a computer data or telecommunications network.
NOTES: •The DTP and Analog Audio ports are in reverse order on the receiver.
•You can check the DTP Out to DTP In cable connection as follows:
1. Plug a cable into the DTP jack on the powered unit.
2. Connect the opposite end of the cable into the DTP jack on the unpowered unit.
If the DTP Link LED and the Power LED on the unpowered unit are lit, the connection is correct.
5
Pin
1
2
3
6
7
8
4
Wire color
White-green
Green
White-orange
White-blue
Orange
White-brown
Brown
Blue
Wire color
White-green
Green
White-orange
White-blue
Orange
White-brown
Brown
TIA/EIAT
568 A TIA/EIAT
568 B
Blue
TP Wires
12345678
Pins:
Ground
Receive pin on connected unit
Transmit pin on connected unit
Connected RS-232
and IR Device Pins
Tx/Rx
Pins
Receive pin on connected unit
Transmit pin on connected unit
RxTx
RS-232 IR
RxTx
2
eHDMI Output connector (Rx) — Connect a display with an HDMI input for display of the
OUTPUTS
LR
AUDIO
transmitted direct digital image.
fAudio Output connector (Rx) — Connect a balanced or unbalanced stereo or mono
audio device to the receiver via the Audio captive screw connector. See the drawing below.
Unbalanced Stereo Output Balanced Stereo Output
LR
Ring
Sleeve(s)
Tip
Tip
Ring
LR
Sleeve(s)
Tip
Tip
Do not tin the wires!
CAUTION: Connect the sleeves to the ground contact. DO NOT connect the sleeves to the negative (-) contacts).
gPower connector — Connect an IEC power cord between the included 12 VDC power supply and a 100-240 VAC, 50-60 Hz
source. Connect the power supply to either unit as shown at right.
CAUTION: This product is intended to be supplied by a Listed Power Unit
marked “Class 2” or “LPS,” rated 12 VDC, 1.0 A minimum.
Always use a power supply supplied by or specified by Extron.
Use of an unauthorized power supply voids all regulatory
compliance certification and may cause damage to the supply
and the end product. Unless otherwise stated, the AC/DC
adapters are not suitable for use in air handling spaces or in
wall cavities. The installation must always be in accordance
with the applicable provisions of National Electrical Code
ANSI/NFPA 70, article 75 and the Canadian Electrical Code
part 1, section 16. The power supply shall not be permanently
fixed to a building structure or similar structure.
NOTE: Only one power supply is required. A single power supply
connected to either unit in the pair powers both units. A power
supply is included with each transmitter.
Operation
After all devices are powered up, the system is fully operational. See the definitions
Rear Panel
R
ear
P
ane
l
Front Panel
F
ront
P
ane
l
POWER
12V
0.6 A MAX
21
of the power indications (shown at right), below:
aPower LED (front panel) —
Amber — The unit is receiving power, either locally or remotely (on the DTP cable).
Green — The unit is powered on and is receiving an active HDMI signal, either on
the HDMI input if a transmitter, or transmitted on the DTP cable if a receiver.
bPower LED (rear panel) —
Amber — The unit is receiving power remotely (on the DTP cable).
Green — The unit is receiving power locally.
If any problems are encountered, verify that the cables are routed and connected properly. If your problems persist, call the
Extron S3 Sales and Technical Support Hotline that is closest to you, at the number shown below.
Power Supply
Output Cord
SECTION A–A
Ridges
Smooth
AA
Captive
Screw
Connector
Tie Wrap
3"
16 (5 mm) Max.
68-2156-50
Rev A
07 11
Extron USA - West
Headquarters
+800.633.9876
Inside USA/Canada
Only
+1.714.491.1500
+1.714.491.1517 FAX
Extron USA - East
+800.633.9876
Inside USA/Canada
Only
+1.919.863.1794
+1.919.863.1797 FAX
Extron Europe
+800.3987.6673
Inside Europe Only
+31.33.453.4040
+31.33.453.4050 FAX
Extron Asia
+800.7339.8766
Inside Asia Only
+65.6383.4400
+65.6383.4664 FAX
Extron Japan
+81.3.3511.7655
+81.3.3511.7656 FAX
Extron China
+400.883.1568
Inside China Only
+86.21.3760.1568
+86.21.3760.1566 FAX
Extron Middle East
+971.4.2991800
+971.4.2991880 FAX
© 2011 Extron Electronics. All rights reserved. www.extron.com
DTP HDMI 301 • Setup Guide (Continued)
Andere Handbücher für DTP HDMI 301
1
Andere Extron electronics Extender Handbücher
Extron electronics
Extron electronics PowerCage FOX Tx HDMI Bedienungsanleitung
Extron electronics
Extron electronics eLink 100 Bedienungsanleitung
Extron electronics
Extron electronics DTP HWP 4K 231 D Bedienungsanleitung
Extron electronics
Extron electronics FOX T Plus MM Bedienungsanleitung
Extron electronics
Extron electronics FOX 3G HD-SDI Bedienungsanleitung
Extron electronics
Extron electronics Extender Wall Mount Series Bedienungsanleitung
Extron electronics
Extron electronics FOX3 T 301 Bedienungsanleitung
Extron electronics
Extron electronics FOX3 SR 20 Bedienungsanleitung
Extron electronics
Extron electronics DTP T DP 4K 330 Bedienungsanleitung
Extron electronics
Extron electronics FOXBOX Tx HDMI Bedienungsanleitung
Extron electronics
Extron electronics DTP DVI 330 Bedienungsanleitung
Extron electronics
Extron electronics Extension Kits AVTrac 4C Bedienungsanleitung
Extron electronics
Extron electronics USB Extender Plus T Bedienungsanleitung
Extron electronics
Extron electronics AKM MAAP Bedienungsanleitung
Extron electronics
Extron electronics eLink 100 Bedienungsanleitung
Extron electronics
Extron electronics DTP T USW 223 Bedienungsanleitung
Extron electronics
Extron electronics DTP HDMI 301 Bedienungsanleitung
Extron electronics
Extron electronics DTP HDMI 230 Bedienungsanleitung
Extron electronics
Extron electronics DTP HDMI 4K D Series Bedienungsanleitung
Extron electronics
Extron electronics PowerCage FOX HDMI Bedienungsanleitung
