ND1 2 732558 - Rev. D
WARNINGS FOR THE INSTALLER
GENERAL SAFETY REQUIREMENTS
EC DECLARATION OF CONFORMITY
Manufacturer: FAAC S.p.A.
Address: Via Calari, 10 - 40069 Zola Predosa BOLOGNA - ITALIA
Declares that: The operator mod. N1D Kit, N1D auto Kit, N1D senso kit
• conforms to the essential safety requirements of the following EEC directives:
2006/95/EC Low Voltage Directive
2004/108/EC Electromagnetic Compatibility Directive
99/05/ECRTTE Directive
• conforms to that foreseen by the following harmonised standards:
- EN 60335-2-103
- EN 61000-3-2, EN 61000-3-3
- EN 55014-1, EN 55014-2
Bologna, 01-07-2014
CEO
A. Marcellan
1. ATTENTION! It is important for the safety of people to follow all
the instructions carefully. Incorrect installation or incorrect use
of the product could cause serious harm to people.
2. Read the instructions carefully before installing the product.
3. The packaging materials (plastic, polystyrene, etc.) must not
be left within reach of children as they are potential sources
of danger.
4. Keep these instructions for future reference.
5. This product was solely designed and built for the use described
in this document. Any other use, not specifically described, could
compromise the integrity of the product and/or be a source of
danger.
6. FAAC declines all liability deriving from improper use or use
other than that for which the automated system is intended.
7. Do not install the equipment in an explosive atmosphere: the
presence of flammable gas or fumes is a serious safety risk.
8. FAAC is not responsible for failure to comply with GoodTechnical
Practice when constructing the closing elements that are to be
motorised or for any deformation that may occur during use.
9. Before performing any operation on the system, disconnect the
power supply.
10. Installation must be performed by skilled technical personnel
and in compliance with regulations in force.
11. The power mains of the automation system must be fitted with
a multi-pole power switch with a switch-contact gap of at least
3 mm. It is advisable to use a 6A circuit breaker with a multi-pole
power switch.
12. Verify that there is a differential switch with a 0.03 threshold
upstream of the system.
13. For outdoor use, install the electric cables inside specific pro-
tective conduit.
14. Verify that the earthing system is perfectly constructed and
connect the metal closing parts.
15. Do not connect more than one engine to the same inverter.
16. Do not connect two inverters to the same engine.
17. FAAC declines all liability concerning safety and the automated
system working properly, if system components not manufac-
tured by FAAC are used.
18. Only use original FAAC parts for maintenance.
19. Do not modify the components of the automated system in
any way.
20. The appliance must always be visible when handled.
21. Do not allow children or adults to stay near the product during
operation.
22. Keep radio controls or other pulse generators out of the reach of
children to prevent the automation system from being activated
involuntarily.
23. The user must not attempt any kind of repair or direct interven-
tion and must only contact qualified personnel.
24. Anything not specifically stipulated in these instructions is not
permitted.
