Fell Marine WiMEA Bedienungsanleitung
1
WiMEA
User Manual
Manuel utilisateur
Benutzerhandbuch
Manual de usuario
Wireless Kill Switch
W
I
R
E
L
E
S
S
K
I
L
L
S
W
I
T
C
H
•
W
I
R
E
L
E
S
S
K
I
L
L
S
W
I
T
C
H
•
WWW.FELLMARINE.COM
1215 WEKS 20130301
4
Package content
1. WiMEA Boat Unit
2. External Antenna
3. Adjustable Wristband
4. WiMEA MOB Unit
5. Connection Cable
6. Battery
7. Butt Splices
x 1
x 1
x 1
x 1
x 1
x 1
x 4 + 1
5
The team behind FELL thank you for engaging in a new and
innovative way of being safe while boating. Our mission is to
enable all boaters to enjoy the seas, and for them to be as free as
possible.We call it Safe To Be Free.
We made this product with the expectation that our customers
wanted the free and energizing feeling while spending time on the
sea, whether it is high seas or low seas, rainy or sunny. We wanted
to enhance the boating experience by creating a product providing
absolute safety and no worries - just be free and enjoy.
Still after several decades with a corded solution as the only
alternative for the engine kill switch on motorboats, no one
seems to have developed a system that enables one to be free
and safe while driving a motor boat - as it should be.
Using state of the art wireless technology, we have developed the
effortless and easy to use WiMEA (Wireless Marine Electronics
Algorithm) by FELL of Norway.
Developed using the most advanced wireless technology
available, the WiMEA®Protocol is the most advanced wireless
safety system on the maritime market.
We hope you will enjoy your time spent boating just a little more
with your WiMEA Wireless Kill Switch onboard!
Your FELL-team
Introduction English
6
Press and Hold to Pair
Pair any WiMEA MOB Unit to any WiMEA Boat Unit. Your Boat Unit
remembers the last 20 paired MOB Units. Family or friends can
have their own MOB Unit for the same boat with a WiMEA Boat
Unit installed. The MOB Unit connects to the latest paired Boat Unit
using ID technology.
One click – Connect / Disconnect System
After your MOB Unit and Boat Unit are paired for the first time,
click your MOB Unit once when entering the boat to start
driving. You are now free to move around safely. When
disembarking the boat – click the MOB Unit once more to
disconnect.
MOB situation and Direct Restart System
FELL WiMEA®Protocol automatically triggers MOB Mode (Man
Overboard Mode) when the MOB Unit goes into the water or
travels out of range from the connected Boat Unit. 6 seconds after
stopping the engine the Override Mode is engaged and
automatically switches the signal relay to the engine back on.
This allows any passengers on board to quickly restart the engine
and pick up the missing driver in the water, without the need to
interact with the Boat Unit.
MOOR Mode System
In the event you as the driver need to exit the boat while mooring
or performing other tasks, you can engage MOOR Mode. Simply
Press & Hold your MOB Unit for 3 seconds while being connected.
WiMEA will be in standby for 2 minutes, allowing you to go out of
wireless range without the engine stopping. After 2 minutes the
system will automatically reconnect if you are within range of your
Boat Unit.
Overview
7
Press and hold the button on your Boat Unit.
Release the button when the Boat Unit starts
flashing blue and gives a sound signal indicating
Pairing Mode.
Immediately after releasing the button on the
Boat Unit, press and hold the button on your
MOB Unit. Keep the MOB Unit within 1 meter
range from the Boat Unit.
The Boat Unit will give a sound signal and the
light will flash green to indicate that the units
was paired successfully. You can now release the
button on your MOB Unit.
Pairing
After proper installation, pair the MOB Unit and the Boat Unit, as
described below:
8
Click the button on your MOB Unit to connect.
The Boat Unit will give a sound signal and the
light will flash green to indicate a successful
connection.
Connecting
After successful pairing, connect the MOB Unit to the Boat Unit as
shown below:
Do not detach the MOB Unit from your body
and place it at the helm or any other place in
the boat while driving or while the engine is
running. The MOB Unit must be attached to your
body at all times to ensure that the engine will
stop if you fall over board! Make sure to test the
system before every use.
Start
NOTICE
You can now start your engine.
Every 5 seconds the Boat Unit will flash green to
indicate an active connection.
The green light and battery indication light will
automatically turn off after 5 minutes.
NOTICE
9
Range
After a successful connection, check your range for the first time.
Make yourself familiar with the wireless range around your boat by
starting the engine and walking away from the boat with your MOB
Unit. The WiMEA system has a solid range of at least 15 feet (5 m)
and up to 30 feet (10 m). You may experience an even longer
range, as the wireless signal can vary depending on the environ-
ment around your boat.
When going out of range or if the MOB Unit is
submerged the system will enter MOB Mode
(Man Overboard Mode) and stop the engine. The
Boat Unit will give a sound signal and the light
will flash red to indicate MOB Mode.
Please note that the engine will stop within 1
second after the MOB Unit is submerged by 4
inches (10 cm) of water at any distance from
the Boat Unit.
A bucket or similar will not be adequate for
testing the system. Always test the system in
the ocean/lake.
WiMEA will automatically time out after 10 hours
to save power. You can extend your connection by
pressing the button on the Boat Unit within 2
minutes when you hear the time out warning sound.
NOTICE
NOTICE
NOTICE
10
Disconnect
To disconnect your MOB Unit, click the button once like shown
below:
The Boat Unit will give a sound signal and the
light will flash red to indicate it is disconnected.
Remember to disconnect every time you leave
the boat. Disconnecting while the engine is
running will shut down the engine.
NOTICE
You may disconnect your MOB Unit by clicking
once on the Boat Unit or MOB Unit from
Connected Mode, MOB Mode, Override Mode or
Moor Mode.
Click the button on your MOB Unit to disconnect.
11
MOB Mode
NO CONNECTION
ENGINE STOP
MAN OVERBOARD
MOB Mode (Man Overboard Mode) is the safety mode and the
basic purpose of the system. This is the mode that can save your
and others lives in the event of a man overboard situation. WiMEA
will automatically activate MOB Mode and shut down the engine
when the MOB Unit is submersed in 4 inches (10 cm) of water or
travels out of range from the Boat Unit. After 6 seconds of engine
shut down procedure, the system automatically activates Override
Mode. In Override Mode any passenger or crew onboard can restart
the engine by putting the gearshift in neutral and starting the
engine normally. This allows for a quick recovery of the missing
person in the water and enhances safety.
A bucket or similar will not be adequate for
testing the system. Always test the system in
the ocean/lake.
NOTICE
12
1. The MOB Unit falls into the water or goes out
of range.
2. Engine shut down.
3. 6 seconds engine shut down procedure is
activated - Indicated by flashing red light and
sounding an alarm.
4. 6 seconds after engine shut down, Override
Mode automatically engages – allowing
passengers or crew on board to start the engine
and pick up the missing person in the water.
5. You can disconnect MOB Mode or Override
Mode by clicking the button on the MOB Unit.
6. Reconnect after MOB/Override Mode by first
disconnecting, either by clicking on the Boat
Unit or the MOB Unit button. Then click again
on the MOB Unit to reconnect.
The Override Mode engaged after MOB Mode
will time out after 2 hours. This is to prevent the
system from staying activated in the event that
you leave the boat without disconnecting the
MOB Unit first.
NOTICE
MOB Mode overview
Andere Handbücher für WiMEA
2
Inhaltsverzeichnis
Sprachen:
Andere Fell Marine GPS Handbücher
