Field Controls FIELD DIRECT VENT SYSTEM REDUCING TEE Bedienungsanleitung

www.eldcontrols.com

Please retain these instructions after installation.

This device MUST be installed by a qualied agency in accordance with the manufacturer's installation instructions. The denition of

a qualied agency is: any individual, rm, corporation or company which either in person or through a representative is engaged

in, and is responsible for, the installation and operation of HVAC appliances, who is experienced in such work, familiar with all the

precautions required, and has complied with all the requirements of the authority having jurisdiction.

READ THESE INSTRUCTIONS CAREFULLY AND COMPLETELY BEFORE PROCEEDING WITH THE INSTALLATION.

Installation Date:

Installed By: Phone:

FIELD DIRECT VENT SYSTEM

REDUCING TEE

Model: FDVS WITH REDUCING TEE

page 2

Figure 1

Figure 2

REDUCING TEE INSTALLATION

1. Apply a bead of sealant to appliance collar

approximately 1" from end of collar.

(See Figure 1)

2. Remove all oil and grease from the inside of the

appliance reducing tee and apply a bead of

sealant to inside of reducing tee 1⁄2" from end.

(See Figure 1)

3. With a twisting motion, assemble the reducing

tee rmly onto the appliance collar.

4. Push the reducing tee onto the appliance collar,

using care to avoid damaging the appliance

collar or the reducing tee. (See Figure 2)

5. Assemble clamp halves using the supplied 5⁄16"

bolts and square nuts, and install the appliance

clamp onto the reducing tee and tighten

securely. (See Figure 1)

6. Install the supplied self-drilling, self-tapping

anchoring screws through the 4 holes in the

appliance clamp into the appliance collar.

(See Figure 2) No pilot hole is required.

7. Apply sealant to the end of the reducing tee

and anchoring screws. (See Figure 2)

8. After testing and burner adjustments have

been made, apply sealant to the supplied 3⁄8"

sampling port plug screw and install the screw

in the sampling port. (See Figure 2)

page 3

JOINT ASSEMBLY: VENT PIPE TO TERMINATION AND

REDUCING TEE

If necessary, the vent pipe may be cut to length with a

hacksaw or cut o saw.

CAUTION: Use safety glasses and other appropriate

safety gear.

1. Pull outer vent pipe back 1-2" from inner vent

pipe end and remove insulation. (See Figure 3)

2. Slide cover sleeve onto end of vent pipe a few

inches back from end of outer vent pipe.

(See Figure 3)

3. Slide cover ring over stop bead on termination

inner pipe. (See Figure 3)

4. Assemble inner pipe clamp halves using the

supplied 1⁄4" bolts and square nuts, and position

inner pipe clamp 1⁄4" from end of inner pipe.

(See Figure 3)

5. Remove all oil and grease from end of termination

inner pipe and apply a bead of sealant between

the stop bead and retainer bead. (See Figure 4)

6. Apply a thick bead of sealant to inside of inner

vent pipe 1⁄2" from the end of pipe, working the

sealant into the corrugations. (See Figure 4)

7. Push the inner vent pipe onto the termination inner

pipe all the way up to the stop bead.

8. Tighten the inner pipe clamp bolts until both

clamp halves are within 1⁄8" of each other at each

end. (See Figure 5)

9. Slide the cover sleeve and cover ring together to

engage the ring in the groove of the sleeve and

tighten the cover sleeve clamp. (See Figure 6)

10. Repeat this procedure to install vent pipe on

reducing tee.

11. To maintain 1" clearance to combustibles, wrap

minimum 11⁄2" thick ceramic insulation (installer-

supplied) around the exposed portion of the

termination inner pipe (See Figure 6), and secure

with foil tape (installer supplied).

Figure 6

Figure 5

Figure 4

Figure 3

Phone: 252.522.3031 • Fax: 252.522.0214

www.fieldcontrols.com

Warranty

For warranty information about this or any Field Controls product, visit:

www.eldcontrols.com/warranty

Inhaltsverzeichnis

Andere Field Controls Lüfter Handbücher

Field Controls

Field Controls 46115300 Benutzerhandbuch

Field Controls

Field Controls VentCool 1.8 Bedienungsanleitung

Field Controls

Field Controls PVO-600 Bedienungsanleitung

Field Controls

Field Controls Oil Venting Systems Bedienungsanleitung

Field Controls

Field Controls 46477000 Bedienungsanleitung

Field Controls

Field Controls 46107700 Bedienungsanleitung

Field Controls

Field Controls 46267300 Bedienungsanleitung

Field Controls

Field Controls FIELD DIRECT VENT SYSTEM FDVS Bedienungsanleitung

Field Controls

Field Controls 1984600 Bedienungsanleitung

Field Controls

Field Controls 46261700 Leitfaden

Field Controls

Field Controls SWG-AF Series Bedienungsanleitung

Field Controls

Field Controls OVD-4 Bedienungsanleitung

Field Controls

Field Controls ventCool Bedienungsanleitung

Field Controls

Field Controls 46311800 Bedienungsanleitung

Field Controls

Field Controls 4052900 Montageanleitung

Field Controls

Field Controls VentCool Tahoe Series Bedienungsanleitung

Field Controls

Field Controls 46330800 Bedienungsanleitung

Field Controls

Field Controls 46413900 Bedienungsanleitung

Field Controls

Field Controls 46334800 Bedienungsanleitung

Field Controls

Field Controls 46381400 Bedienungsanleitung

Field Controls

Field Controls 46263500 Kurzanleitung

Field Controls

Field Controls 46202200 Bedienungsanleitung

Field Controls

Field Controls 46483500 Bedienungsanleitung

Field Controls

Field Controls 4592700 Bedienungsanleitung

Beliebte Lüfter Handbücher anderer Marken

ELTA FANS

ELTA FANS H03VV-F Bedienungsanleitung

Hunter

Hunter 20714 Gebrauchsanweisung

Emerson

Emerson CARRERA VERANDA CF542ORB00 Bedienungsanleitung

Hunter

Hunter Caraway Gebrauchsanweisung

Panasonic

Panasonic FV-15NLFS1 Bedienungsanleitung

Kompernass

Kompernass KH 1150 Bedienungsanleitung

VES

VES FALA100/12V/TR Bedienungsanleitung

Vertiv

Vertiv Liebert DCD Bedienungsanleitung

Westinghouse

Westinghouse GFP Series Bedienungsanleitung

Venmar

Venmar KUBIX HRV PLUS Series Bedienungsanleitung

Maico

Maico ECR 31 Bedienungsanleitung

Sonnenkonig

Sonnenkonig Dinky Bedienungsanleitung

S&P

S&P ECOWATT HXBR Bedienungsanleitung

Wider

Wider IMP03369BH Bedienungsanleitung

Panasonic

Panasonic F-60DHN Bedienungsanleitung

Hinkley

Hinkley HIGHLAND Bedienungsanleitung

Broan

Broan 766BN Bedienungsanleitung

Premium

Premium PFS16022 Montageanleitung