Adjusting the flame Height (fig 6)
To turn the stove on and/or to increase the flame
height, press the ▲ button and the small button A at the same time
on the remote handset. Continue pressing until the desired
flame height is obtained. Press and hold the ▼
button to reverse the procedure.
The receiver is equipped with a built-in delay,
recognisable by the flickering light, to facilitate
fine adjustment of the flame. The motorised valve
is equipped with a slip clutch, allowing manual
adjustment of main gas by turning knob B.
To Turn Off Gas to Stove
Turn knob A clockwise until reaching stop. In
this position only pilot gas flows. To shut off the
valve completely, press down slightly and
continue to turn clockwise from pilot position to
the OFF position. The safety interlock prevents
re-ignition of the pilot flame until the
thermocouple has cooled down sufficiently
(elapsed time will vary based on thermocouple
type). Switching off the remote is not necessary.
Disconnect the pressure gauge, tighten the test point sealing screw
and test for gas soundness.
Handset Information
Note : Mains electrical power is not required as this system runs
on batteries only. (Alkaline recommended)
Handset 1 x 9V block
Receiver 4 x 1.5v AA
