Kalea Bay LED Outdoor Fireplace REV. 4-17-19 Page 19
Step 7: Remove the screws from the “bottom end” of
the burner pan area. The bottom end part lls the space
between the burner pan and the replace side panel. It
is held into place with three (3) screws. See Fig. 22. First
remove the two inside screws, then the screw securing the
side wall. Lift up the area where the two screws were and
push down where the single screw was, then lift the
bottom end out of the replace.
Step 8: With bottom end removed, insert the LED channel
assembly female connector (protruding through the wire
grommets) to the LED male connector 77110. Note: The
male end of the LED connector will only insert into the
female connector in one direction. Once locked in
position, screw the threaded cap of the female connector
securely over the male connector. See Fig. 23.
Step 9: Attach 77110 to 77111 using the molex
connectors. After connecting the LED lights into the 77111
wire harness insert the 12-volt adapter 77102 with ¼”
terminals) into the (red & black wires) of LED wire
harness. Plug the 12-volt adapter into the 120VAC GFCI
box with weather proof cover. See Fig. 26, page 21.
LED LIGHTING INSTALLATION
1. Remove Screws
2. Lift up
3. Push down
