Kalea Bay LED See-Thru Conversion Kit REV. A Page 6
Step 1
Step 2
Front of Fireplace
LED
HOT GLASS WILL
CAUSE BURNS
DO NOT TOUCH
GLASS UNTIL COOLED
NEVER ALLOW CHILDREN
TO TOUCH GLASS
A barrier designed to reduce the risk of burns from the
hot viewing glass is provided with this appliance and
MUST be installed for the protection of children and other
at-risk individuals.
DANGER
Step 9:
• Carefully unpack the glass panels.
• Using gloves carefully lift one glass panel, into the
replace opening, over top of the glass clips, and slide
it down into the metal retainer clip, supporting the glass
at the top and bottom as you handle it. See Fig. 10
• As the glass enters the clip the bottom edge of the
glass will rest in place on the bottom of the clip.
• Install the second glass pane in the same manner as
described in Fig. 10.
• Both glass panels should be level when installed.
• Center glass between clips after installation.
Fig. 10 Installing glass panels.
GLASS PANEL/WINDSHIELD INSTALLATION
WARNING
ALL FOUR (4) GLASS PANELS MUST BE INSTALLED
WHILE OPERATING A SEE-THROUGH FIREPLACE.
CAUTION: THIS IS TEMPERED GLASS. DO NOT CHIP
GLASS. CHIPPED TEMPERED GLASS CAN BREAK
WITHOUT WARNING.
Step 10: INSTALLING HOOD: The replace requires a hood to be installed into each side of the rebox. One hood
would have come with the single sided replace, the other hood is supplied with this kit. All models require ve (5) screws
(#77129) to secure the hood to the replace except the 72-inch model, which uses seven (7) screws to secure the hood.
The hood protrudes outward 1-inch from the top opening of the replace. Fig. 11 shows hole location and installation
process for hood installation. The protruding area of the hood angles downward to deect heat, see Hood Detail below.
Fig. 11 Installing hood(s) on the replace.
Hood Screw Locations
FRONT VIEW SIDE VIEW
Hood
(Deector Facing Downward)
Hood Detail
End View
