FiveStar TN331-7W Bedienungsanleitung

INSTALLATION INSTRUCTIONS

PROFESSIONAL RANGE MODELS

36” ALL GAS,CONVECTION WITH SEALED BURNERS**

36” NATURAL GAS MODELS

*TN331-7BW

*TN331-7W

**THESE MODELS ARE NOT FIELD CONVERITBLE FOR LP/PROPANE GAS.THEY MUST BE

ORDERED FROM THE FACTORY SET FOR NATURAL OR LP/PROPANE GAS.**

36” LP/PROPANE GAS MODELS

*PN331-7BW

*PN331-7W

**THESE MODELS ARE NOT FIELD CONVERTIBLE FOR NATURAL GAS.THEY MUST BE

ORDERED FROM THE FACTORY SET FOR NATURAL OR LP/PROPANE GAS.**

IF YOU HAVE QUESTIONS,CALL 800-251-7224, 8AM TO 5PM EASTERN TIME,OR VISIT OUR

WEBSITE,WWW.FIVESTARRANGE.COM.

Installation Instructions

BEFORE YOU BEGIN

CAUTION:

Read these instructions completely and

carefully.

THESE RANGES SHOULD BE INSTALLED IN

CONJUNCTION WITH A SUITABLE

OVERHEAD VENT HOOD. Due to the high heat

capacity of this unit, particular attention should be paid to the hood

• IMPORTANT -Save these instructions for local

duct work installation to assure it meets local building codes.

inspector's use.

• IMPORTANT - Observe all governing codes and

Standard countertop installations:

ordinances.

A 1200 CFM hood is recommended for 48" & 60" ranges.

A 600 CFM hood is recommended for 30" & 36" ranges.

• Note to Installer - Be sure to leave these instructions

with the Consumer.

Hoods should be 24" min. deep and at least the same width as the

cooktop. FiveStar hoods may be installed from 24” to 30” above the

• Note to Consumer - Keep these instructions for future

cooking surface. A minimum of 28” is required when a FiveStar

reference.

Backsplash with warming shelves is used.

• FiveStar recommends this product be installed by a

Check local building codes for the proper method of gas range

licensed professional.

installation. Local codes vary. Installation, electrical connections and

grounding must comply with applicable codes. In the absence of local

• Product failure due to improper installation is not covered

codes, the gas range should be installed in accordance with the

under the Warranty.

National Fuel Gas Code ANSI 223.1, latest edition and National

Electrical Code ANSI/NFPA 70, latest edition.

WARNING:

This appliance must be properly grounded.

CAUTION:

In the Commonwealth of Massachusetts:

These ranges weigh up to 510 pounds. Some

• This product must be installed by a licensed plumber or

gas

disassembly will reduce the weight considerable. Due to

fitter.

the weight and size of the range and to reduce the risk of

personal injury or damage to the produce and/or damage

• When using ball type gas shut-off valves, they shall be T

to the floor, TWO PEOPLE ARE REQUIRE FOR PROPER

handle type.

INSTALLATION.

• A flexible gas connector, when used, must not exceed

Three (3) feet.

INSTALLATION INSTRUCTIONS

Please read these instructions

before attempting to install this

range

Inspection and Unpacking

Check the range carton for visible

damage. If there is damage or even

creases in the carton, contact the

carrier, request an inspection and file

the appropriate freight claim. Do not

refuse shipment. Responsibility for

shipping damage is with the carrier

and the dealer or end user. Cut the

shipping straps, then carefully lift the

carton up from the range. This will

help eliminate possible damage to the

backguard that is packed in the top of

the range carton.

Remove, unwrap and temporarily lay

aside any parts that are not attached

to the range. Make sure no parts are

left in the carton for accidental

disposal. Carefully inspect the range

for damage.

STEP 1

REMOVE PACKAGING

Before moving the range indoors:

Remove outer carton and packing material from the

shipping base. The range is now ready for removal

from the wooden base.

STEP 2

Due to the weight of these ranges, use a dolly with

soft wheels to move this range.

Lift the range onto the dolly and move indoors.

The range should be placed onto sliders to

prevent damage to the floor.

STEP 3

To simplify handling and to reduce the weight of

the range:

Remove the grates and the burner pans.

Remove griddle/grill and housing.

Remove the broiler pan, racks and literature

package from inside oven.

STEP 5

ELECTRIC CONNECTION

This range must be supplied with 120 volt, 60 Hz. and

connected to an individual, properly grounded branch

circuit protected by a 15 amp circuit breaker or time

delay fuse.

The power cord of this appliance is equipped with a

three-prong (grounding) plug which mates with a

standard three-prong grounding wall receptacle to

minimize the possibility of shock hazard from this

appliance.

If the electrical service provided does not meet the

above specifications, it is recommended that a

licensed electrician install an approved outlet.

DO NOT, UNDER ANY CIRCUMSTANCES, CUT

OR REMOVE THE THIRD (GROUND) PRONG

FROM THE POWER CORD.

DO NOT USE AN EXTENSION CORD WITH THIS

APPLIANCE.

Locate the electric supply within the area shown or

within reach of the cooktop’s six foot power cord.

To avoid tangling cord with items stored in the

cabinet, locate the receptacle or rear wall, inside

the cabinet.

ELECTRICAL REQUIREMENTS FOR ALL GAS RANGES:

120 volts, 60 Hz, 15 amps

STEP 7

INSTALLING THE BACKGUARD –SEALED BURNER MODELS

NOTE:PLEASE READ ALL INSTRUCTIONS BEFORE STARTING INSTALLATION.

7-1

Remove the burner grates, griddle/grill and housing.

7-2

From the front of the range, remove the Phillip screws in the rear of each burner pan (black pan

where the top burners are located).

7-3

From the rear of the range, remove two screws from the rear of the side panels, the upper most

screw on each side. You will need a 5/16” nut-driver or 5/16” socket to remove these screws. (Tools

with a magnetized tip will be helpful in replacing the backguard screws.)

7-4

From the rear of the range, locate the upper wire cover with tab slots. Remove two 5/16” mounting

screws. This cover will be reinstalled once the backguard is installed.

7-5

Screws are installed in the backguard, at the Factory for assembly to the backguard support. It is

important that you locate and remove these four screws from the backguard before you attempt to

install the backguard to the range backguard support.

7-6

Remove the vinyl protective covering from the front of the backguard.

7-7

The front of the backguard should fit between the back burner pans and the rear support. If the

burner pan and rear support have a tight tolerance, place a thin bladed screw driver at either end,

between the burner pan and rear support, to start placement of the backguard. Slide the backguard

over the exhaust vent(s). Align the slots in the front of the backguard with the rear support bar

locator studs.

7-8

With the backguard in position, secure the backguard to the rear backguard support using the four

5/16” screws removed in step 7-4, re-install the screws in the edge of the side panels and replace

the screws in the back of each burner pan. Re-install griddle/grill housing. Do not re-install the

grates at this point.

7-9

Reinstall the upper wire cover that was removed in Step 7-4. Place the cover into position with

the lower backguard panel fitting into the tab slots. Reinstall the two 5/16” mounting cover screws.

DIAGRAM FOR STEP 7

STEP 8

LEVEL THE RANGE

1. Remove shipping tape from the leveling

legs.

2. Carefully slide the range into position.

Be careful not to damage the floor or

entangle power cord and gas flexible

tubing.

3. To adjust leveling legs, turn counter-

clockwise to raise the range; clockwise

to lower. “Channel-lock” type pliers are

recommended. Avoid using a pipe wrench

which can scar the legs.

IMPORTANT: The range should always be

installed at countertop height or higher. DO

NOT INSTALL THE RANGE LOWER THAN

ADJACENT COUNTERTOP HEIGHT, DUE

TO RISK OF A FIRE HAZARD

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere FiveStar Reichweite Handbücher

FiveStar

FiveStar TTN337-7BSW Bedienungsanleitung

FiveStar

FiveStar *TN525-7BW Bedienungsanleitung

FiveStar

FiveStar *tn281-7bw Bedienungsanleitung

FiveStar

FiveStar TTN275-W Bedienungsanleitung

FiveStar

FiveStar TTN480-7BW Bedienungsanleitung

FiveStar

FiveStar TTN325-7BSW Bedienungsanleitung

FiveStar

FiveStar TPN335-BGW Installationsanleitung

FiveStar

FiveStar TN-637-7BW Bedienungsanleitung

FiveStar

FiveStar TTN281-7BSW Bedienungsanleitung

FiveStar

FiveStar TTN531-7BSW Bedienungsanleitung

FiveStar

FiveStar TN331-7BW Bedienungsanleitung

FiveStar

FiveStar TTN311-7BW Bedienungsanleitung

FiveStar

FiveStar WTN5317W Bedienungsanleitung

FiveStar

FiveStar TPN4807BW Bedienungsanleitung

FiveStar

FiveStar TTN310-7BSW Bedienungsanleitung

FiveStar

FiveStar TTN637-7BSW Bedienungsanleitung

FiveStar

FiveStar TPN310-7 Bedienungsanleitung

FiveStar

FiveStar *tn281-7w Bedienungsanleitung

FiveStar

FiveStar TTN510-7BSW Bedienungsanleitung

FiveStar

FiveStar TTN260-7BSW Bedienungsanleitung

FiveStar

FiveStar TTN287-BSW Bedienungsanleitung

FiveStar

FiveStar TN537-7BW Series Bedienungsanleitung

FiveStar

FiveStar WPN6377W Bedienungsanleitung

FiveStar

FiveStar TTN331-7BW Bedienungsanleitung

Beliebte Reichweite Handbücher anderer Marken

Samsung

Samsung FCQ321HTUW Bedienungsanleitung

Kenmore

Kenmore 790.45712 Bedienungsanleitung

Wolf

Wolf CHR CHSSR Bedienungsanleitung

Smeg

Smeg Built-in Microwave Oven Bedienungsanleitung

Zanussi

Zanussi ZCG054G Bedienungsanleitung

Whirlpool

Whirlpool 8575985-W Stücklistenhandbuch

Frigidaire

Frigidaire 316000635 Bedienungsanleitung

GE JCSS630 Bedienungsanleitung

Samsung

Samsung NX58M9960P series Bedienungsanleitung

Hotpoint

Hotpoint RB524R Installationsanleitung

Whirlpool

Whirlpool Roper FGP305KW3 Bedienungsanleitung

Amana

Amana ART6610 SERIES Bedienungsanleitung

Maytag

Maytag MERH770WB Bedienungsanleitung

Fulgor Milano

Fulgor Milano SOFIA Bedienungsanleitung

Premier

Premier EF-4358GH Bedienungsanleitung

Kenmore

Kenmore 790.9010 Series Bedienungsanleitung

KitchenAid

KitchenAid KESC300 Bedienungsanleitung

Frigidaire

Frigidaire FFEF3012LS Benutzerhandbuch