Flash F7100545 Bedienungsanleitung
User Manual
Instrukcja Obsługi
F7100545
Moving Head
150W 3in1
Please keep this User Manual for future
user, be sure that they also receive this
instruction booklet.
Unpack and check carefully there is no
transportation damage before using the
Before operating, ensure that the voltage
and frequency of power supply match the
It’s important to ground the yellow/green
conductor to earth in order to avoid electric
shock.
Disconnect main power before servicing
and maintenance.
but always by taking its base.
Don’t operate it where the temperature is
higher than this.
WARNING! The Moving Head 150W 3in1 has a powerful pan motor. The torque reaction when
on a surface. Do not apply power to the Moving Head 150W 3in1 unless the baase is securely
fastened to a surface or to rigging hardware.
WARNING!
clockwise.
WARNING!
of clamp that does not completely encircle the structure when fastened.
WARNING!
See Figure 2. The Moving
Head 150W 3in1 lens can focused the sun's rays, creating a potential fire hazard and causing
damage.
IMPORTANT! Moving Head 150W 3in1,
as intense illumination can damaged the display.
In the event of serious operating problem,
carried out by unskilled people can lead to
damage or malfunction. Please contact the
nearest authorized technical assistance
center. Always use the same type spare parts.
Do not connect the device to any dimmer
pack.
Do not touch any wire during operation and
there might be a hazard of electric shock.
To prevent or reduce the risk of electrical
or moisture.
The housing must be replaced if they are
visibly damaged.
2. SAFETY INFORMATION
1. INTRODUCTION
Moving Head 150W 3in1
WARNING!
User Manual •Instrukcja Obsługi
Figure 2.
DMX
Controller DMX 512 DMX 512
Moving Head 150W 3in1 •Art No P7100545
variable speed
The unit should be mounted via its screw
holes on the bracket. Always ensure that
and slipping while operating. Always
ensure that the structure to which you are
attaching the unit is secure and is able to
5.1 Connecting DMX signal
The connection is performed using cable with
4. INSTALLATION
5. CONNECTION
3. PRODUCT INFORMATION
weight. Also always use a safety cable
that can hold 12 times of the weight of
out of the touch of people and has no one
pass by or under it.
The device is equipped with the following
1
3
22
FEMALE
XLR
GROUND
DMX +
DMX -
MALE
XLR
3
1
CAUTION!
1
FEMALE
XLR
GROUND
DMX +
DMX -
MALE
XLR
2
3
4
5
1
2
3
45
The connection is performed using
operated by qualified personnel.
5.2 Voltage specification
Input Voltage Total Power Frequency
100~245V 250W 50/60Hz
5.3 Connecting power supply
CAUTION! In the case of cable damage do not attempt to repair.
person with appropriate permissions.
Make sure that the power grid supply
parameters are consistent with device
parameters and limitations are not
Using lamp, the change rate of power voltage should be within
± 10%, if the voltage is too high, it will shorten the light’s life; if it’s not
enough, the lamp will be dark. Please restart it after turning off light
for 20 minutes until full-cooling. Frequent switching will reduce the
life span of lamps and bulbs; intermittent using will improve the life
of bulbs and lamps.
User Manual •Instrukcja Obsługi
Advanced
Photometric Data
up up up down down down
To verify press enter.
DISTANCE
lx 6177 1501 637
angle
9°
9°
5m 10m 15m
the size of
the light spot
ø 207 cmø 95 cm ø 184 cm
6. DMX CHANNELS
Setting
Run mode
DMX
controller or master lighting
Auto slow
Auto random reverse
sound
Channels mode
RDM
X-axis offset
Y-axis offset
XY-axis change
XY-axis encode Use encoder to judge lost step and correct
automatically
Do not use encoder to correct position
No DMX signal
Delete Motors reset and stopping running
Screen protection
Background light continue
Restore default
dialogue, press enter again to restore default
settings
Moving Head 150W 3in1 •Art No P7100545
User Manual •Instrukcja Obsługi
Manual control
To press enter then into the edit status. Press up or down to change channels value, press
enter again to choose tens place edit. Press enter again to choose ones place edit. Press enter
System information
Advanced
Item Instructions
Software edition
DMX value
System wrong record
into sub interface to check. After check to press delete to clear
wrong record
Wrong information Instructions
Motorse reset failure Drive board no feedback,. The wires connected display board and
drive board problem, or check drive board problem.
X axis resett failure
Y axis reset failure
X axis Hall wrong
Y axis Hall wrong
Color wheel reset
failure
Gobo wheel reset
failure
Zoom reset failure Zoom Hall problem, or zoom motor problem.
Led lamp control
failure
Turn on led lamp failure, led problem
Item Instructions
Reset correction
no adjustment
Sensors monitor
status.
Password is up up up down down down. To verify press enter.
Reset
16 CH Mode
Channel Channel Mode
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Bit Effect Remark
255-255
through the unused range and
0-254
Moving Head 150W 3in1 •Art No P7100545
Bit Effect Remark
255
…… ……
100
95-99
90
85
80
75
70
65
60
55
50
45-49
40
35
30
25
20
15
10
5
0
Colour
Stop / Strobe
Bit Effect Remark
252-255
251
…… ……
4
0-3
User Manual •Instrukcja Obsługi
Dimmer
Gobo 1
Bit Effect Remark
255
…… ……
0
Bit Effect Remark
250-255
…… ……
221-225
220
…… ……
135
130-134
129
…… ……
70
60-69
50
40
30
20
10
0
Moving Head 150W 3in1 •Art No P7100545
Gobo 1 Rotation
Gobo
Bit Effect Remark
255
…… ……
193
191-192
190
…… ……
128
…… ……
64
0-63
Bit Effect Remark
250-255
…… ……
211-216
210
…… ……
135
130-134
129
…… ……
99
90-99
80
70
60
50
40
30
20
10
0
User Manual •Instrukcja Obsługi
Inhaltsverzeichnis
Sprachen:
Andere Flash DJ-Equipment Handbücher
Flash
Flash P7200045 Bedienungsanleitung
Flash
Flash F7100091 Bedienungsanleitung
Flash
Flash LED MOONTH FLOWER LIGHT Bedienungsanleitung
Flash
Flash F7000643 Bedienungsanleitung
Flash
Flash LASER 10W RGB GOBO Bedienungsanleitung
Flash
Flash F5100347 Bedienungsanleitung
Flash
Flash Virtuoso 420 Bedienungsanleitung
Flash
Flash LED Spyder Mini Moving Head 8x15W 4in1 RGBW- No Limit... Bedienungsanleitung
Flash
Flash F7100305 Bedienungsanleitung
Flash
Flash F1000501 Bedienungsanleitung
Flash
Flash LASER 2000mW RGB Bedienungsanleitung
Flash
Flash F7100514 Bedienungsanleitung
Flash
Flash BEAM Moving Head 15R Bedienungsanleitung
Flash
Flash F7200169 Bedienungsanleitung
Flash
Flash LED MOVING HEAD 60W Bedienungsanleitung
Flash
Flash LED Spyder Mini Bedienungsanleitung
Flash
Flash F7100531 Bedienungsanleitung
Flash
Flash F7000579c Bedienungsanleitung
Flash
Flash Spyder 3-HEAD Bedienungsanleitung
Flash
Flash F7000543 Bedienungsanleitung
Beliebte DJ-Equipment Handbücher anderer Marken
thomann
thomann Stairville DJ Lase 40-G MK-III Bedienungsanleitung
Eagletone
Eagletone 6 Eyes Flower Bedienungsanleitung
EuroLite
EuroLite FLD-1508 Bedienungsanleitung
Technical Pro
Technical Pro LG8xSEA Bedienungsanleitung
JB Systems
JB Systems Lounge Laser DMX Bedienungsanleitung
Lightmaxx
Lightmaxx Vega Halo 90 Bedienungsanleitung
Elation
Elation FUZE WASH Z350 Bedienungsanleitung
Maverick
Maverick MK3 WASH Bedienungsanleitung
Infinity
Infinity TF-260C7 Fresnel Bedienungsanleitung
Chauvet
Chauvet EVE E-50Z Bedienungsanleitung
Eliminator Lighting
Eliminator Lighting E 138 Bedienungsanleitung
EuroLite
EuroLite Mini Multicolor LED Flashing Light SC Bedienungsanleitung