* Notice: The factory set pressure value of the air pump is 10PSI
(10PSI=0.689BAR), and at the time of the secondary use, the set
pressure value for the last time use will be displayed by default.
* Notice: After powered on, if there is no operation within 2
minutes, the air pump will enter standby mode, and the machine
can be initiated by pressing the power switch button.
10
HT-767 DC12V 110WHT-767 DC12V 110W
9
V. Inflation Operation
VI. Deflation operation
VII. Precautions
* Connect the end with flexible conduit adaptor (11) of the hose
with the air pump inflation inlet (1), and twist clockwise to
tighten it, as Figure 1
* Install the other end of the hose into the supporting air tap of
the air bag (step①in Figure 2), and twist clockwise to tighten it,
and then insert the inflation valve of the air bag and twist
clockwise to fix it (step②in Figure 2).
* Press the pressure unit toggle button to select the unit you need.
* Press the pressurizing button or decompressing button to set the
pressure value you need, with the range of the pressure value from
0 to 20PSl, (1PSI=0.0689BAR)
* Plug the DC plug into the 12V DC socket.
* After finishing the above steps, press the power switch button to start
to inflate.
* During the inflating process, you can press the pressurizing button or
decompressing button to increase or reduce the pressure value, press
the pressure unit toggle button to switch the unit, and press the On/Off
button to stop.
* Press and hold the On/Off button for 3 seconds to directly start the high
pressure pump.
* When the pressure reaches the set value, the air pump will stop working
automatically.
* Remove the hose from the inflation inlet, Connect the end with flexible
conduit adaptor (11) of the hose with the air pump deflation outlet (2),
and twist clockwise to tighten it, as Figure 3,and the other end shall still
be to the airbag.
* The applied powersource must be the 12V DC power source (as Figure 4).
* Do not block the inflation inlet (1)and Deflation outlet (2), and ensure that the
inflation inlet (1) and Deflation outlet(2) shall remain smooth at all times
* Observe the local waste treatment provisions, and it is not alowed to throw
the air pump away randomly.
* Don't use this product when the hose is damaged, and please change the
hose immediately.
*Don't pull out the hose when inflating, because that
the high pressure may hurt the physical body.
* Don't make the air pump work for more than 20 minutes,
because that motor overheating may cause intemal
damage; and the air pump shall be fully cooled for 30
minutes after continuously working up to 20 minutes.
* Please don't use this air pump if any part is damaged, and please contact with the
professional personnel to repair it.
* Press the button of the power switch of air pump, and start the deflation
until all the gas is discharged, then the power can be turned off to stop
the deflation.
* After completing the inflation, pull out the DC plug from the 12V DC socket.
* After pulling out the DC plug, please take down the hose from the air pump
and air bag and store it.
(Figure 1) (Figure 2)
(Figure 3)
(Figure 4)
