Fluke TL1000-KIT Originalbetriebsanleitung

TL1000-KIT

Test Lead s

TL1000/30M

30 m Test Lead on Reel

Safety Information

A Warning identifies hazardous conditions and procedures that

are dangerous to the user. A Caution identifies conditions and

procedures that can cause damage to the Product or the

equipment under test.

XW Warning

To prevent possible electrical shock, fire, or personal

injury:

Read all safety information before you use the

Product.

Use the Product only as specified, or the protection

supplied by the Product can be compromised.

Carefully read all instructions.

PN 5341976 (English) 8/2022

subject to change without notice. All Product names are trademarks of

their respective companies.

1.888.610.7664sales@GlobalTestSupply.com Fluke-Direct.com

Comply with local and national safety codes. Use

personal protective equipment (approved rubber

gloves, face protection, and flame-resistant clothes)

to prevent shock and arc blast injury where hazardous

live conductors are exposed.

Do not use in CAT III or CAT IV environments without

the protective cap (if included with the Product)

installed on test probe. The protective cap decreases

the exposed probe metal to <4 mm. This decreases the

possibility of arc flash from short circuits.

Do not use a shrouded banana jack accessory such as

an alligator clip with an unshrouded 4 mm banana

probe tip terminal in a hazardous electrical

installation. Due to the lack of a shroud, the probe tip

connector does not provide suitable insulation to

accessible parts with this type of assembly.

Use Product-approved measurement category (CAT),

voltage, and amperage rated accessories (probes,

test leads, and adapters) for all measurements.

Do not touch voltages >30 V ac rms, 42 V ac peak, or

60 V dc.

Do not use the Product around explosive gas, vapor,

or in damp or wet environments.

Do not exceed the Measurement Category (CAT)

rating of the lowest rated individual component of a

Product, probe, or accessory.

Do not use test leads if they are damaged. Examine the

test leads for damaged insulation, exposed metal, or if

the wear indicator (if present) shows. Check test lead

continuity.

Keep fingers behind the finger guards on the probes.

1.888.610.7664sales@GlobalTestSupply.com Fluke-Direct.com

Symbols

The table below lists the symbols that can be used on the Product

or in this document.

Maintenance

Clean with a soft towel moistened with water and mild detergent.

DO NOT IMMERSE in liquid.

Specifications

Safety............................................IEC 61010-031, Pollution Degree 2

TL1000 Test Leads .............CAT III 1000 V, CAT IV 600 V, 10 A

TL1000/30M Test Lead .....CAT III 1000 V, CAT IV 600 V,

5 A (on reel) 10 A (fully extended)

TP74 Test Probes

with cap.............................CAT III 1000 V, CAT IV 600 V, 10 A

without cap ......................CAT II 1000 V, 10 A

AC285 Alligator Clips.........CAT III 1000 V, CAT IV 600 V, 10 A

Temperature................................-20 °C to 50 °C (-4 °F to 122 °F)

Humidity .......................................<95 % RH, up to 35 °C (95 °F)

<40 % RH, 35 °C to 50 °C (95 °F to

122 °F)

Altitude .........................................2000 m

Symbol Description

WWARNING. RISK OF DANGER.

XWARNING. HAZARDOUS VOLTAGE. Risk of electric

shock.

TDouble insulated

PConforms to European Union directives.

Measurement Category II is applicable to test and

measuring circuits connected directly to utilization

points (socket outlets and similar points) of the low-

voltage MAINS installation.

Measurement Category III is applicable to test and

measuring circuits connected to the distribution

part of the building’s low-voltage MAINS installation.

Measurement Category IV is applicable to test and

measuring circuits connected at the source of the

building’s low-voltage MAINS installation.

This product complies with the WEEE Directive and

its marking requirements. The affixed label indicates

that you must not discard this electrical/electronic

product in domestic household waste. Do not

dispose ofthis product as unsorted municipal

waste. For information about take-back and

recycling programs available in your country, see

the website.

1.888.610.7664sales@GlobalTestSupply.com Fluke-Direct.com

LIMITED WARRANTY

This Fluke product will be free from defects in material and

workmanship for 1 year from the date of purchase. This warranty

does not cover fuses, disposable batteries, or damage from

accident, neglect, misuse, alteration, contamination, or abnormal

conditions of operation or handling. Resellers are not authorized

to extend any other warranty on Fluke’s behalf. To obtain service

during the warranty period, contact your nearest Fluke authorized

service center to obtain return authorization information, then

send the product to that Service Center with a description of the

problem.

THIS WARRANTY IS YOUR ONLY REMEDY. NO OTHER

WARRANTIES, SUCH AS FITNESS FOR A PARTICULAR PURPOSE,

ARE EXPRESSED OR IMPLIED. FLUKE IS NOT LIABLE FOR ANY

SPECIAL, INDIRECT, INCIDENTAL OR CONSEQUENTIAL

DAMAGES OR LOSSES, ARISING FROM ANY CAUSE OR THEORY.

Since some states or countries do not allow the exclusion or

limitation of an implied warranty or of incidental or consequential

damages, this limitation of liability may not apply to you.

11/99

1.888.610.7664sales@GlobalTestSupply.com Fluke-Direct.com

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Fluke Prüfgeräte Handbücher

Fluke

Fluke PRV240FS Bedienungsanleitung

Fluke

Fluke 718Ex 30G Bedienungsanleitung

Fluke

Fluke FEV-CON-TSL Originalbetriebsanleitung

Fluke

Fluke 1652C Gebrauchs- und Pflegehandbuch

Fluke

Fluke 719 Series Bedienungsanleitung

Fluke

Fluke DTX-MFM Bedienungsanleitung

Fluke

Fluke 5500A Bedienungsanleitung

Fluke

Fluke AIRCHECK Bedienungsanleitung

Fluke

Fluke 4181 Bedienungsanleitung

Fluke

Fluke 721 Bedienungsanleitung

Fluke

Fluke TS22A Bedienungsanleitung

Fluke

Fluke 55XXA Bedienungsanleitung

Fluke

Fluke NetTool Bedienungsanleitung

Fluke

Fluke 990DSL Bedienungsanleitung

Fluke

Fluke 9100 Series Bedienungsanleitung

Fluke

Fluke 718-100US Bedienungsanleitung

Fluke

Fluke 105B Bedienungsanleitung

Fluke

Fluke DTX-CLT CertiFiber Bedienungsanleitung

Fluke

Fluke FiberInspector Pro FI-3000 Bedienungsanleitung

Fluke

Fluke 5730A Bedienungsanleitung

Fluke

Fluke 753 Bedienungsanleitung

Fluke

Fluke NX8 Bedienungsanleitung

Fluke

Fluke 714B/EN Bedienungsanleitung

Fluke

Fluke 5520A Service Handbuch

Beliebte Prüfgeräte Handbücher anderer Marken

SMART

SMART KANAAD SBT XTREME 3G Series Bedienungsanleitung

Agilent Technologies

Agilent Technologies BERT Serial Bedienungsanleitung

Agilent Technologies

Agilent Technologies N3280A Bedienungsanleitung

Vernier

Vernier Go Direct Voltage Bedienungsanleitung

Lifeloc

Lifeloc R.A.D.A.R. Bedienungsanleitung

Mercury

Mercury TSL01 Bedienungsanleitung

MAHA

MAHA MBT Series Bedienungsanleitung

Fuji Electric

Fuji Electric P-61 Bedienungsanleitung

ETC

ETC SealerAtor Bedienungsanleitung

Skyfine

Skyfine ETHYWAY V2 Bedienungsanleitung

Appion

Appion G5 Twin Bedienungsanleitung

PCB Piezotronics

PCB Piezotronics 8159-0112A Bedienungsanleitung

BW Technologies

BW Technologies MicroDock II Bedienungsanleitung

Sun Nuclear

Sun Nuclear 1027 Bedienungsanleitung

Biomark

Biomark HPR LITE READER Bedienungsanleitung

Hioki

Hioki 3169-20 Bedienungsanleitung

Ashcroft

Ashcroft ATE-100 Bedienungsanleitung

Rohde & Schwarz

Rohde & Schwarz RTA4000 Bedienungsanleitung