Fluke 62 MAX Bedienungsanleitung
62 MAX/62 MAX +
Infrared Thermometer
Users Manual
Introduction
The Fluke 62 MAX and 62 MAX + Infrared Thermometers (the Product) can determine the
surface temperature by measuring the amount of infrared energy radiated by the target’s
surface. Note that the Japanese models indicate Celsius only.
WWarning
Read all safety information before you use the Product.
62 MAX/62 MAX +
Users Manual
Safety Information
A Warning identifies conditions and procedures that are dangerous to the user. A Caution
identifies conditions and procedures that can cause damage to the Product or the equipment
under test.
Table 1 tells you about symbols used on the Product and in this manual.
*WWarning
To prevent eye damage and personal injury:
•Read all safety Information before you use the Product.
•Do not use the Product if it operates incorrectly.
•Use the Product only as specified, or the protection supplied by the
Product can be compromised.
•Before you use the Product, inspect the case. Do not use the Product if it
appears damaged. Look for cracks or missing plastic.
Infrared Thermometer
Safety Information
•See emissivity information for actual temperatures. Reflective objects
result in lower than actual temperature measurements. These objects
pose a burn hazard.
•Do not look directly into the laser with optical tools (for example,
binoculars, telescopes, microscopes). Optical tools can focus the laser
and be dangerous to the eye.
•Do not look into the laser. Do not point laser directly at persons or
animals or indirectly off reflective surfaces.
•Replace the batteries when the low battery indicator shows to prevent
incorrect measurements.
•Do not use the Product around explosive gas, vapor, or in damp or wet
environments.
•Use the Product only as specified or hazardous laser radiation exposure
can occur.
62 MAX/62 MAX +
Users Manual
Table 1. Symbols
Symbol Meaning Symbol Meaning
WRisk of danger. Important
information. See Manual. ~
Do not dispose of this product as
unsorted municipal waste.
*Warning. Laser. PConforms to European Union
directives.
Battery Conforms to relevant Australian
standards.
Infrared Thermometer
Maintenance
Maintenance
WCaution
To avoid damage to the Product, do not leave the thermometer on or near
objects of high temperature.
How to Change the Battery
To install or change the AA IEC LR06 battery, open the battery compartment and replace the
battery as shown in Figure 16.
How to Clean the Product
Use soap and water on a damp sponge or soft cloth to clean the Product case. Carefully wipe
the surface with a moist cotton swab. The swab may be moistened with water. See Figure 17.
62 MAX/62 MAX +
Users Manual
Specifications
62 MAX 62 MAX +
Temperature Range -30 °C to 500 °C
(-22 °F to 932 °F) -30 °C to 650 °C
(-22 °F to 1202 °F)
Accuracy
≥0 °C: ±1.5 °C or ±1.5 % of
reading, whichever is
greater
(≥32 °F: ±3 °F or ±1.5 % of
reading, whichever is
greater)
≥-10 °C to <0 °C: ±2 °C
(≥14 °F to <32 °F: ±4 °F)
< -10 °C: ±3 °C
(<14 °F: ±6 °F)
≥0 °C: ±1 °C or ±1 % of
reading, whichever is
greater (≥32 °F: ±2 °F or
±1 % of reading, whichever
is greater)
≥-10 °C to <0 °C: ±2 °C
(≥14 °F to <32 °F: ±4 °F)
< -10 °C: ±3 °C
(<14 °F: ±6 °F)
Response Time (95 %) <500 ms (95 % of reading) <300 ms (95 % of reading)
Spectral Response 8 to 14 microns
Emissivity 0.10 to 1.00
Infrared Thermometer
Specifications
Optical Resolution 10:1
(calculated at 90 % energy) 12:1
(calculated at 90 % energy)
Display Resolution 0.1 °C (0.2 °F)
Repeatability (% of reading) ±0.8 % of reading or ±1.0 °C
(2 °F), whichever is greater ±0.5 % of reading or ±0.5 °C
(1 °F), whichever is greater
Power 1 AA IEC LR06 Battery
Battery Life 10 hours with laser and
backlight on 8 hours with laser and
backlight on
Weight 255 g (8.99 oz)
Size (175 x 85 x 75) mm (6.88 x 3.34 x 2.95) inches
Operating Temperature 0 °C to 50 °C (32 °F to 122 °F)
Storage Temperature -20 °C to 60 °C (-4 °F to 140 °F), (without battery)
Operating Humidity 10 % to 90 % RH non-condensing @ 30 °C (86 °F)
Operating Altitude 2000 meters above mean sea level
Storage Altitude 12,000 meters above mean sea level
62 MAX/62 MAX +
Users Manual
IP Rating IP 54 per IEC 60529
Drop Test 3 meters
Vibration and Shock IEC 68-2-6 2.5 g, 10 to 200 Hz, IEC 68-2-27, 50 g, 11 ms
EMC EN 61326-1:2006 EN 61326-2:2006
Standards and Agency Approval
Compliance.............................................EN/IEC 61010-1: 2001
Laser Safety............................................FDA and EN 60825-1 Class II
Infrared Thermometer
The Product
The Product
1 2
Andere Handbücher für 62 MAX
10
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere Fluke Thermometer Handbücher
Fluke
Fluke 62 MAX Bedienungsanleitung
Fluke
Fluke 568 EX Montageanleitung
Fluke
Fluke 1551A Ex Gebrauchs- und Pflegehandbuch
Fluke
Fluke Hart Scientific 5623A Bedienungsanleitung
Fluke
Fluke 561 HVACPro Bedienungsanleitung
Fluke
Fluke 1529 Chub-E4 Bedienungsanleitung
Fluke
Fluke 1620A-H Bedienungsanleitung
Fluke
Fluke 1521 Bedienungsanleitung
Fluke
Fluke 566 Bedienungsanleitung
Fluke
Fluke Nuclear Associates 07-402 Bedienungsanleitung
Fluke
Fluke 54 Series II Bedienungsanleitung
Fluke
Fluke 1502A Bedienungsanleitung
Fluke
Fluke Series II Bedienungsanleitung
Fluke
Fluke 561 HVACPro Bedienungsanleitung
Fluke
Fluke 2180A Bedienungsanleitung
Fluke
Fluke 1529 Kurzanleitung
Fluke
Fluke VT08-II Bedienungsanleitung
Fluke
Fluke 572-2 Bedienungsanleitung
Fluke
Fluke 66 Bedienungsanleitung
Fluke
Fluke 572 Bedienungsanleitung
