Foc.us Filiofocus 1600 Bedienungsanleitung

Page 1 of 21

Filiofocus 1600 wall version

Design Installation & Operating Manual v.5.1 EN

Tested by OMNI-Test Laboratories, Inc. and approved to

ULC-S610-M87 (A1998), UL 737-2011 And ULC S627-00

Report Number: 304-F-10-2

US EPA exempt

this document was packed with the appliance.

KEEP THESE INSTRUCTIONS FOR FUTURE USE

Page 2 of 21

TABLE OF CONTENTS:

1 –INTRODUCTION

2 –SPECIFICATIONS

a) Characteristics

b) Roof outlet requirement

c) Chimney requirement

d) Structural requirement

e) Connectors

f ) Fresh air intake

g) Clearances to combustibles

3 –INSTALLATION

a) Included parts, materials and required tools for installation

b) Options

c) Assembly details

d) Stainless steel chimney systems : cover disc setup and connection

4 –OPERATING INSTRUCTIONS

a) Storage/use of flammable liquids

b) Fire-dogs

c) Ashes

d) Fuel

e) Before lighting your first fire

f) Building, starting and maintaining the fire

g) Protective glove and separable handle

5 –MAINTENANCE

a) Taking out the ashes

b) Inspection, maintenance and cleaning of the chimney

c) Surfaces

d) Directions and reasons for cleaning glass

e) Replacement parts

6 –WARRANTY

Page 3 of 21

1 –INTRODUCTION:

Please read this entire manual before you install and use your focus fireplace.

Failure to follow instruction may result in property damage, bodily injury or even

death. When this room heater is not properly installed, a house fire may result.

To reduce the risk of fire, follow the installation instructions. Contact local

building or fire officials about restrictions and installation inspection

requirements in your area.

KEEP THIS MANUAL HANDY FOR EASY REFERRAL.

All WARNING and CAUTION statements will appear in bold font and upper

case letters: THEY SHOULD BE STRICTLY OBSERVED.

Thank you for choosing focus fireplaces.

Appliance designation: filiofocus 1600 wall version

Manufacturer: focus - atelier dominique imbert –le fort – 34380 viols le fort –

France.

2 –SPECIFICATIONS:

-NOT FOR MOBILE HOME OR EXTERIOR INSTALLATION!

-DO NOT CONNECT TO ANY AIR DISTRIBUTION DUCT OR SYSTEM!

-THE AUTHORITY HAVING JURISDICTION (SUCH AS MUNICIPAL

BUILDING DEPARTMENT, FIRE DEPARTMENT, FIRE PREVENTION

BUREAU, ETC.) SHOULD BE CONSULTED BEFORE INSTALLATION TO

DETERMINE THE NEED TO OBTAIN A PERMIT.

-USING MAKE-SHIFT COMPROMISES DURING INSTALLATION CAN

CAUSE DAMAGE . SUCH INSTALLATION IS NOT COVERED UNDER

FOCUS LIMITED WARRANTY.

-WHEN THIS ROOM HEATER IS NOT PROPERLY INSTALLED, A HOUSE

FIRE MAY RESULT. TO REDUCE THE RISK OF FIRE, FOLLOW THE

INSTALLATION INSTRUCTIONS. CONTACT LOCAL BUILDING OR FIRE

OFFICIALS ABOUT RESTRICTIONS AND INSTALLATION INSPECTION

REQUIREMENTS IN YOUR AREA.

Page 4 of 21

a) Characteristics:

• Hearth 1.12 m (44-3/32-inch) diameter; weight : 170 kg (374 lbs)

• Flue diameter : 219 mm (8-5/8-inch) ; length custom-made

• Flue weight : 16 kg per meter (35 lbs per foot)

• Cover disc with collar weight : 11 kg (24 lbs)

• 3 mm (1/8-inch) thick steel

• Insulated baseplate

• High heat resistant matte black paint

Page 5 of 21

b) Roof outlet requirement:

c) Chimney requirement:

DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE SERVING ANOTHER

APPLIANCE!

Filiofocus 1600 wall version requirement: the floor to top of chimney length must

be 17'minimum (20' for an installation less than 3 miles from the ocean or if a

30° elbow is necessary). Elbows should not be more inclined than 30° (USA) or

45° (Canada) from vertical, and with maximum number of 2. Maximum inside +

outside height (without use of a fan) : 30 feet.

The filiofocus must be connected to a chimney complying with the requirements

for Type HT chimneys in the standard for Chimneys, Factory-built, Residential

Type and Building Heating Appliance, UL 103 / ULC S629. For example, a class

A insulated stainless steel flue chimney system with an 8 "minimum inside

diameter.

Page 6 of 21

d) Structural requirement:

CAUTION: THE SUPPORT OF THIS UNIT (FLOOR) MUST BE SIZED IN

CONGRUENCE WITH THE FIREPLACE STATIC AND DYNAMIC CHARGES

(WEIGHT). THE SIZE CALCULATION FOR THE SUPPORT IS NOT THE

RESPONSIBILITY OF FOCUS OR ITS AFFILIATES. IT IS YOUR

RESPONSIBILITY TO CONSULT WITH AN ENGINEER OR ARCHITECT FOR

YOUR PROJECT.

e) Connectors:

Connectors are all non-insulated chimney parts including focus black flue, focus

8" universal adaptor and the chimney manufacturer single wall slip adaptor.

To avoid heat traps the chimney connector shall not pass through an attic or

roof space, closet or similar concealed space, or a floor, or ceiling.

Passage through an attic, roof frame floor, or ceiling must be done using an

insulated chimney respecting all chimney manufacturer clearances. For Canada

the installation should conform to CAN/CSA-B365.

CAUTION: PASSAGE THROUGH A WALL OR PARTITION OF

COMBUSTIBLE CONSTRUCTION IS NOT AN APPROPRIATE

INSTALLATION FOR THIS FOCUS FIREPLACE.

Refractory compound must be used to seal each connection. Connectors

should always be in good condition and kept clean. Minimum thickness : 1/32"

(1 mm). Please refer to installation details in this manual.

f) Fresh air intake:

To balance room air pressure with outdoors air pressure, we recommends a

fresh air intake in the room (ideally emerging under of the fire bowl). Fresh air

intake shall only take combustion air from outdoors and not terminate in attic

spaces. We recommend Ø6ʼʼ deflect-O ID0625 UL listed 181 class 1 insulated

air duct. Minimum fresh air intake size:

Page 7 of 21

Important: this fresh air intake is compulsory when operating venting appliances

such as kitchen hoods, permanent air extractors or any appliances creating an

air depression in the habitation. A lack of air intake may alarm smoke detectors.

Duct maximum lenght : 30 feet.

Guidance on how to seal at the penetration of the building envelope :

Installation of the combustion air inlet system will require a 6” diameter

penetration through the wall and then insert the passive air vent with pipe

extension through this opening. Take note that proper caulking is to be used

between the vent and exterior wall to insure no air leaks in or out of building

envelope. For in depth detail refer to your local building code having jurisdiction.

For vertical external façade building termination, we recommend Deflect-O fresh

air intake galvanized hood and pipe with screen ref. GFAI6 (see image

hereunder and technical specs at the end of this manual).

g) Clearances to combustibles:

MINIMUM FLOOR TO CEILING HEIGHT: 113".

• Floor protection:

The insulated baseplate is a compulsory, integral component required on all

combustible floors and proper care is to be used when permanently attaching

this component to the Fireplace Hearth Base. Improper installation or failure to

install could result in floor being exposed to high temperatures and resulting in a

fire or possibly death. Please read and follow instructions carefully using all

fasteners as indicated.

Page 8 of 21

• Insulated baseplate assembly details:

Baseplate must be secured to the fireplace using 2 hexagon headless bolts.

• Clearances to back wall:

FIREPLACE MUST BE MAINTAINED AT ½" OFF THE BACK WALL IN

ORDER TO MAINTAIN VENTILATION AND AIR CIRCULATION IN THIS

AREA.

BACK WALL MUST BE INSULATED FROM FLOOR TO CEILING WITH ½"

CEMENT BOARD AND 1" ROCK WOOL. SUPPORTING STUDS MUST

ALSO BE NON COMBUSTIBLE.

BACK WALL PROTECTION REQUIRES TO EXTEND 24" TO EITHER SIDE

OF THE CENTERLINE OF THE UNIT.

-Clearances to side walls :

CAUTION: THE DISTANCE TO A COMBUSTIBLE SIDE WALL MUST BE

MAINTAINED AT 32" FROM THE GLASS PANEL OF THE FIREPLACE.

PROPERTY DAMAGE OR DEATH CAN OCCUR IF THIS DISTANCE IS NOT

MAINTAINED. DRYWALL PRODUCTS LINED WITH PAPER SUCH AS

SHEETROCK ARE COMBUSTIBLE. CLEARANCES AS INDICATED

FURTHER APPLY.

Page 9 of 21

Important - manufacturer specifications:

-To avoid premature aging of your painted walls, only use mineral or acrylic

paints. With other paints, above clearances apply.

-Fire clearance from window glass to hearth glass: 3 feet.

-Fire clearance to vinyl windows: refer to window technical specifications.

CLEARANCES MAY ONLY BE REDUCED BY MEANS APPROVED BY THE

REGULATORY AUTHORITY.

Page 10 of 21

3 –INSTALLATION:

a) Included parts, materials and required tools for installation:

-Appliance and designated parts are : hearth, insulated baseplate, black

steel flue pipe, 3 curved glass panels, cold handle, and focus kit (heat

protective glove, mounting gloves, can of touch-up paint, manual).

-Required tools: drill, M8 allen key, level, screwdrivers, M12 key, scaffolding

(up to underceiling height), refractory compound.

-2 persons minimum are required for installation.

b) Options:

• custom ceiling cover disc (steel disc)

• focus black steel flue extension

• grey paint finish

c) Assembly details:

Andere Handbücher für Filiofocus 1600

Inhaltsverzeichnis

Andere foc.us Kamin im Innenbereich Handbücher

foc.us

foc.us Filiofocus 1600 Bedienungsanleitung

foc.us

foc.us ERGOFOCUS Bedienungsanleitung

foc.us

foc.us Heterofocus 1400 Bedienungsanleitung

foc.us

foc.us édofocus 630 d.a. Bedienungsanleitung

foc.us

foc.us Slimfocus sur pied Bedienungsanleitung

foc.us

foc.us Gyrofocus Bedienungsanleitung

foc.us

foc.us édofocus 850 d.v. Bedienungsanleitung

foc.us

foc.us Hubfocus Bedienungsanleitung

foc.us

foc.us Paxfocus Bedienungsanleitung

foc.us

foc.us Gyrofocus Original Betriebsanleitung

foc.us

foc.us Slimfocus mural Bedienungsanleitung

foc.us

foc.us Bathyscafocus a hublot Bedienungsanleitung

foc.us

foc.us omegafocus Bedienungsanleitung

foc.us

foc.us Meijifocus Benutzerhandbuch

foc.us

foc.us nemofocus Bedienungsanleitung

foc.us

foc.us Eurofocus 951 pivotant Bedienungsanleitung

foc.us

foc.us filiofocus 2000 mural Bedienungsanleitung

foc.us

foc.us BATHYSCAFOCUS Hublot Bedienungsanleitung

foc.us

foc.us Slimfocus pivotant Bedienungsanleitung

foc.us

foc.us édofocus 630 dv Bedienungsanleitung

foc.us

foc.us Emifocus Bedienungsanleitung

foc.us

foc.us MAGMAFOCUS Benutzerhandbuch

foc.us

foc.us optifocus 1750 Bedienungsanleitung

foc.us

foc.us Curvifocus Benutzerhandbuch

Beliebte Kamin im Innenbereich Handbücher anderer Marken

Brigantia

Brigantia 35-DVRS31N-2 Betriebsanleitung

Nordpeis

Nordpeis Bergen Bedienungsanleitung

Superior

Superior BCT2536TMN Bedienungsanleitung

Quadra-Fire

Quadra-Fire 5100I-GD-B Bedienungsanleitung

Renaissance

Renaissance RUMFORD 1000 Bedienungsanleitung

Lacunza

Lacunza IV-800 Bedienungsanleitung

Baxi

Baxi 940 Gebrauchsanweisung

Dru

Dru Maestro 60/2 Tall RCH Bedienungsanleitung

Diamond Fireglass

Diamond Fireglass SS-O22 Bedienungsanleitung

HearthStone

HearthStone Windsor Bay 8830 Programmierhandbuch

Napoleon

Napoleon ASCENT B42 Bedienungsanleitung

Enviro

Enviro E33GI Bedienungsanleitung

Smeg

Smeg L30 FABE Montageanleitung

KEDDY

KEDDY K700 Bedienungsanleitung

Godin

Godin 3451 Bedienungsanleitung

Jøtul

Jøtul Jotul GI 535 DV IPI New Harbor Bedienungsanleitung

Desa

Desa CCFPDFT Bedienungsanleitung

Miles Industries

Miles Industries Vogue 1300IRN Handbuch