FPV Model ZMR180 Series Handbuch
ZMR180 BRIEF BUILD MANUAL
V1.0
FPV Model
1
www.fpvmodel.com
Congratulations on the purchase of the ZMR180 Mini FPV Quadcopter! This mini
quadcopter is a ton of fun and building can be a really enjoyable experience too. We hope
this manual will assist you with your build.
The ZMR180 is a micro quad designed with "fun" in mind. Agile, quick, and small all fit together
with this kit and its a blast to fly.
Keeping simplicity in mind that this frame has high quality 3mm bottom plate and a 1.5 mm top
plate. Using the same carbon fiber that you find in FPVMODEL’s ZMR250 V2, you can rest
assured that this is NOT the run of the mill cheap eBay Carbon Fiber that most others sell. This
CF is backed with FPVMODEL’s name so you can trust that it is top of the line.
The ZMR180 is an awesome time to be had and you will find the smaller size can zoom through
gaps that were previously not even considered with a 250 sized quad.
The ZMR weighs in at 72g including the given mounting hardware and spacers allowing for an
ultra-light weight build yet leaving plenty of build room for adding all necessary FPV gear. If you
wanna add more muscle, pick the ZMR180 with the larger mounts for 22xx motors.
Hurry up and get yours now, they are "flying" off the shelves.
FPV Model
2
www.fpvmodel.com
First, cut the ESCs’ power cord to an appropriate length, and solder them onto PDB.
Cut the transmitter’s power cord to an appropriate length.
FPV Model
3
www.fpvmodel.com
And draw out the inner metal wire.
Cut the wires (red, black and yellow) on camera to appropriate lengths.
FPV Model
4
www.fpvmodel.com
Solder both positive and negative poles of the transmitter’s power cord onto PDB, so does the
positive and negative poles of camera.
Cut the signal wire of transmitter to an appropriate length.
FPV Model
5
www.fpvmodel.com
Keep the yellow wire only and draw others out.
Draw out the inner metal wires as well.
FPV Model
6
www.fpvmodel.com
Solder the yellow wire of transmitter and the yellow wire of camera.
Make a power cord with SR wire and XT60, then solder them onto PDB.
FPV Model
7
www.fpvmodel.com
Install the PDB on the frame (see above), and then install the motors, cut the wires to appropriate
lengths so as to solder the ESCs easier.
Solder the ESCs and motors.
FPV Model
8
www.fpvmodel.com
Test the motors to make sure they rotate correctly, and then seal off the heat-shrink tubes.
Carefully cut off the unnecessary outer part of camera.
FPV Model
9
www.fpvmodel.com
Install camera and camera mount.
Secure the camera and camera board with M2X10 screws, nuts and nylon nuts.
FPV Model
10
www.fpvmodel.com
Dieses Handbuch passt für folgende Modelle
2
Andere FPV Model Quadcopter Handbücher
