Friedrich CP08G10 Bedienungsanleitung
200
0F
Power
Mode
Timer
0n/0ff
Fan
Speed
Temp
CoolMoney
Saver
®
Fan
Only
Dry
hr
Auto
Swing
CP06 CP08
0
F
Power
Mode
Timer
0n/0ff
Fan
Speed
Temp
CoolMoney
Saver
®
Fan
Only
Dry
hr
Auto
Swing
0
F
Power
Mode
Timer
0n/0ff
Fan
Speed
Temp
CoolMoney
Saver
®
Fan
Only
Dry
hr
Auto
Swing
Congratulations! Thank you for choosing
Friedrich.
Your Friedrich unit is designed for
maximum comfort and quietness.
Table of Contents
Introduction ..................................................................................2
Safety Precautions.......................................................................3
How to operate your Friedrich ...................................................5
Adjusting the Air Flow Direction.................................................6
Care and Maintenance .................................................................7
Hardware Location.......................................................................8
Installation Instructions
..........................................................
9
Troubleshooting Tips.................................................................17
Warranty......................................................................................18
2
G N E
Before Operating Your Unit
Make sure the wiring is adequate for your unit.
If you have fuses, they should be of the time delay type. Before you install or relocate this unit, be sure that
the amperage rating of the circuit breaker or time delay fuse does not exceed the amp rating listed in figure 1.
DO NOT use an extension cord.
The cord provided will carry the proper amount of electrical power to the unit; an extension cord will not.
Make sure that the receptacle is compatible with the wall plug provided.
This insures proper grounding. If you have a two-prong receptacle you will need to have the circuit replaced
by a certified electrician with a grounded circuit that meets all national and local codes and ordinances. You
must use the three-prong plug furnished with the air conditioner.
Figure 1
For the Best Cooling Performance and Energy Efficiency
Keep the filter clean
Make sure that your air conditioner is always in top performing condition by cleaning the filter regularly.
Instructions for removing and cleaning the filter can be found on page 7.
Provide good air flow
Make sure that the airflow to and from the unit is clear. Your air conditioner puts the air out at the side of
the unit, and takes in air at the left. Airflow is critical for good operation. It is just as important on the
outside of the building that the airflow around the unit exterior is not blocked.
Unit Placement
If your air conditioner can be placed in a window or a wall that is shaded by a tree or another building, the
unit will operate even more efficiently. Using drapes or blinds on the sunny side of the dwelling will also
add to your unit's efficiency.
Insulation
Good insulation will be a big help in maintaining desirable comfort levels. Doors should have weather
stripping. Be sure to caulk around doors and windows.
Introduction
MODEL
CP06 CP08
AMP VOLT NEMA NO.
15 125 5-15P
CIRCUIT RATING OR
TIME DELAY FUSE PLUG FACE
115V~ 230V~
Power cord may include a current
interrupter device. A test and reset button is
provided on the plug case. The device
should be tested on a periodic basis by first
pressing the TEST button and then the
RESET button. If the TEST button does not
trip or if the RESET button will not stay
engaged, discontinue use of the air
conditioner and contact a qualified service
technician.
Aluminum house wiring may pose special problems. Consult a qualified electrician.
N OT E!
For inner cleaning, contact an Authorized Service Center or a dealer.
Do not use harsh detergent that causes corrosion or damage on the unit.
Harsh detergent may also cause failure of product, fire, or electronic shock.
24
24
e
9
ENGLISH
NOTE TO INSTALLER: Leave these
instructions with the air conditioner after
installation is complete.
NOTE TO CONSUMER: Keep this Installation
and Operation Manual for future use.
Important notes:
It is recommended that proper attire be worn
during installation.
For personal safety, this air conditioner must
be properly grounded.
It is important to have the wall outlet and circuit
checked by a qualified electrician if there is any
doubt as to whether a proper ground exists.
CAUTION:
Do not under any circumstances, cut or remove
the third (ground) prong from the power cord.
Do not change the plug on the power cord of
this air conditioner.
Aluminum house wiring may present special
problems ; consult a qualified electrician.
Before You Begin
Read these instructions completely and carefully.
Installation Instructions
❒Phillips-head screwdriver
❒Flat-blade screwdriver
❒Ruler or tape measure
❒Scissors or knife
❒Pencil
❒Level
❒Hammer
Tools You Will Need
Dieses Handbuch passt für folgende Modelle
3
Inhaltsverzeichnis
Sprachen:
Andere Friedrich Klimaanlage Handbücher
Friedrich
Friedrich MWM24Y3J Bedienungsanleitung
Friedrich
Friedrich Q Series Leitfaden
Friedrich
Friedrich M30CF Bedienungsanleitung
Friedrich
Friedrich Uni-Fit US10C10 Bedienungsanleitung
Friedrich
Friedrich MWM18Y3J Bedienungsanleitung
Friedrich
Friedrich X-Star XQ05L10A Bedienungsanleitung
Friedrich
Friedrich Kuhl KCQ08 Bedienungsanleitung
Friedrich
Friedrich S36YF Bedienungsanleitung
Friedrich
Friedrich 9315342973 Bedienungsanleitung
Friedrich
Friedrich Chill Premier Inverter Series Bedienungsanleitung
Friedrich
Friedrich WallMaster PACKAGED TERMINAL AIR CONDITIONERS AND HEAT... Bedienungsanleitung
Friedrich
Friedrich CP10 Bedienungsanleitung
Friedrich
Friedrich VHA24K25 Series Original Betriebsanleitung
Friedrich
Friedrich KCS08A10A Bedienungsanleitung
Friedrich
Friedrich Hazardgard SH20N50AT Bedienungsanleitung
Friedrich
Friedrich WallMaster WE10B33C Bedienungsanleitung
Friedrich
Friedrich Vert-I-Pak A-Series Bedienungsanleitung
Friedrich
Friedrich Uni-Fit UE10C33 Thru-the-Wall Series Bauanleitung
Friedrich
Friedrich EP08 Bedienungsanleitung
Friedrich
Friedrich QStar SQ06 Bedienungsanleitung
