FS S3410 Series Bedienungsanleitung

S3410 Series Switches

Quick Start Guide

MANAGED L2+ GIGABIT POE+

SWITCHES

Introduction

Accessories

S3410-48TS-P

S3410-24TS-P

S3410-10TF-P

Thank you for choosing S3410 Series Managed PoE+ Switches. This guide is designed to familiarize

you with the layout of the switch and describes how to deploy the switch in your network.

Grounding Cable x1

Power Cord x1

M4 Screw x6

Rubber Pad x4

Mounting Bracket x2

PoE

STATUS M1 M2 PWR1PWR2 PoE

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24

24 25 2623

Green=1000M Yellow=10/100M On=Link Flashing=ACT PoELED:Green=Good Supply Yellow=OverLoad

CONSOLE

SFP+

S3410-24TS-P PoE+

S3410-10TF-P

Cable Clamps x1

Hardware Overview

NOTE: S3410 series PoE+ switches have dust plugs delivered with them. Keep the dust

plugs properly and use them to protect idle optical ports.

S3410-10TF-P

Grounding Cable x1

Power Cord x2

M4 Screw x8

Rubber Pad x4

Mounting Bracket x2

S3410-24TS-P/S3410-48TS-P

Front Panel Ports

Ports Description

RJ45

SFP

CONSOLE

10/100/1000BASE-T ports for Ethernet connection

SFP ports for 1G connection

An RJ45 console port for serial management

CONSOLE RJ45 SFP

USB

CONSOLE

Reserved

An RJ45 console port for serial management

S3410-48TS-P

CONSOLE

USB RJ45 RJ45/SFP Combo

SFP+

Ports Description

RJ45

RJ45/SFP Combo

SFP+

10/100/1000BASE-T ports for Ethernet connection

One RJ45 port and one SFP slot, with one port active at a time

SFP+ ports for 1/10G connection

S3410-24TS-P

CONSOLE

USB RJ45 RJ45/SFP Combo SFP+

PoE

STATUS M1 M2 PWR1PWR2 PoE

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24

24 25 2623

Green=1000M Yellow=10/100M On=Link Flashing=ACT PoE LED:Green=Good Supply Yellow=OverLoad

CONSOLE

SFP+

S3410-24TS-P PoE+

S3410-10TF-P

Front Panel Buttons

S3410-24TS-P

PoE

STATUS M1 M2 PWR1 PWR2 PoE

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24

24 25 2623

Green=1000M Yellow=10/100M On=Link Flashing=ACT PoELED:Green=Good Supply Yellow=OverLoad

CONSOLE

SFP+

S3410-24TS-P PoE+

PoE

PoE RESET

S3410-48TS-P

PoE

Button Description

PoE

RESET

Switch the display mode between PoE mode and switch mode.

Restart: Press and hold the RESET button for more than ve seconds,

and then wait for ten seconds.

Button Description

PoE Switch the display mode between PoE mode and switch mode.

S3410-10TF-P

Back Panels

S3410-24TS-P/S3410-48TS-P

Dual Power Supplies

Expansion Module Slot Grounding Point

Front Panel LEDs

Power Supply

Cable Clamps Holes

Grounding Point

S3410-10TF-P

STATUS

PoE RJ45

PoE(1-8) SFP

Power

Input

Module1 Module2

Output

Input

Output

LEDs DescriptionStatus

STATUS

O Switch is not receiving power.

System is being initialized. Continuous blinking indicates

errors.

The switch is operational.

Switch is faulty.

Temperature warning, check the working environment of

the switch immediately.

Blinking Green

Solid Green

Solid Yellow

Solid Red

S3410-24TS-P

PoE

STATUS M1 M2 PWR1 PWR2 PoE

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24

24 25 2623

Green=1000M Yellow=10/100M On=Link Flashing=ACT PoELED:Green=Good Supply Yellow=OverLoad

CONSOLE

SFP+

S3410-24TS-P PoE+

RJ45

PoE(1-24)

STATUS

PWR1

PoE

PWR2

SFP

SFP+

S3410-48TS-P

RJ45

PoE(1-48) SFP

SFP+STATUS

PWR1

PoE

PWR2

M1/M2

O

Solid Green

PWR1/PWR2

O

Solid Red The power module is in place but the AC power cord or

switch is abnormal.

The power module is not in place.

There is no expansion module or the expansion module is

not correctly installed.

The expansion module is correctly installed.

Solid Green The power supply is operational.

Solid Green

Solid Yellow

PoE

RJ45

O

Indicates the PoE state.

The port is not connected.

Solid Green The port is connected at 1000 Mbps.

Blinking Green The port is receiving or transmitting trac at 1000 Mbps.

Solid Yellow The port is connected at 10/100 Mbps.

Blinking Yellow The port is receiving or transmitting trac at 10/100 Mbps.

Indicates the switching state.

LEDs DescriptionStatus

SFP

O

Solid Green

Solid Yellow

Blinking Yellow

O The port is not connected.

The port is not connected.

Solid Green The port is connected at 1000 Mbps.

Blinking Green

O

Solid Green

Blinking Green

The port is receiving or transmitting trac at 1000 Mbps.

The port is connected at 100 Mbps.

The port is receiving or transmitting trac at 100 Mbps.

PoE (1-8)

PoE (1-24)

PoE (1-48)

PoE is not enabled.

PoE is enabled. The port is operational.

The port has a PoE fault of overload.

SFP+

The port is connected.

The port is receiving or transmitting trac at 10 Gbps.

Installation Requirements

Before you begin the installation, make sure that you have the followings:

Category 5e or higher RJ-45 Ethernet cables, ber optical cables and console cable for

connecting network devices.

Phillips screwdriver.

Standard-sized, 19" wide rack with a minimum of 1U height available.

Site Environment:

Do not operate it in an area that exceeds an ambient temperature of 50°C.

The installation site must be free from leaking or dripping water, heavy dew, and humidity.

Ensure rack and working platforms are well earthed.

Standard-sized, 19" wide rack with a minimum of 1U height available.

Be sure that the switch is level and stable to avoid any hazardous conditions.

Do not install the equipment in a dusty environment.

PoE

Status M1 M2 PWR1 PWR2 PoE

1 2

3456 7 8 9 10 11 12

12 14 24

13 14 15 16 17 18 19 20 21 22 23 24

Green=1000M Yellow=10/100MOn=Link Flashing=ACT PoE LED:Green=Good Supply Yellow=Over Load

Console

25F 26F 27F

RG-S2910-24GT2XS-UP-E

SFP+

Desk Mounting

1. Attach four rubber pads to the bottom.

2. Place the chassis on a desk.

PoE

STATUS

M1 M2 PWR1 PWR2 PoE

12345678910 11 12 13 14 15 16 17 18 19 20 21 22 23 24

24 25 26

Green=1000M Yellow=10/100M On=Link Flashing=ACT PoE LED:Green=Good Supply Yellow=OverLoad

CONSOLE

SFP+

S3410-24TS-P

PoE+

Mounting the Switch

1. Secure the mounting brackets to the two sides of the switch with the supplied M4 screws.

Rack Mounting

RG-S2910-24GT2XS-UP-E

Andere Handbücher für S3410 Series

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere FS Schalten Handbücher

FS KVM-160217IP Bedienungsanleitung

FS IES5100-24FS Bedienungsanleitung

FS MANAGED L2 Bedienungsanleitung

FS S5860-20SQ Bedienungsanleitung

FS S5860 Series Betriebsanleitung

FS S5500-48T8SP Bedienungsanleitung

FS S3700-24T4F Bedienungsanleitung

FS S5860-20SQ Bedienungsanleitung

FS S5800-48MBQ Bedienungsanleitung

FS S3150-8T2FP Bedienungsanleitung

FS PoE+ Series Bedienungsanleitung

FS N9510-64D Bedienungsanleitung

FS S5300-12S Bedienungsanleitung

FS S5810 Series Bedienungsanleitung

FS NC8200 Series Bedienungsanleitung

FS IES3100-8TF-P Bedienungsanleitung

FS S3150-8T2FP Bedienungsanleitung

FS S5860 Series Bedienungsanleitung

FS T5850 Series Bedienungsanleitung

FS S3700-24T4F Bedienungsanleitung

FS S2805S Series Bedienungsanleitung

FS S5500-48T8SP Bedienungsanleitung

FS IES5100-24TF Bedienungsanleitung

Beliebte Schalten Handbücher anderer Marken

URC

URC Total Control MFS-8 Bedienungsanleitung

Azbil

Azbil HPQ-D11 Bedienungsanleitung

Sony

Sony DFS-900M Bedienungsanleitung

SICK

SICK i17S Bedienungsanleitung

F&F

F&F SZR-277 Bedienungsanleitung

Shure

Shure UAMS/BK Bedienungsanleitung

Dräger

Dräger X-zone Switch Off Bedienungsanleitung

Asco

Asco Joucomatic 349 Series Bedienungsanleitung

BT Mini Hub Bedienungsanleitung

D-Link

D-Link DES-1226G Bedienungsanleitung

Johnson Controls

Johnson Controls FS80-C Bedienungsanleitung

MicroNet

MicroNet SP1200A Bedienungsanleitung

Ruijie

Ruijie RG-PF2920 Series Installations- und Betriebsanleitung

Altinex

Altinex DA1914SX Bedienungsanleitung

RJM

RJM MASTERMIND PBC/6X Bedienungsanleitung

Atlas

Atlas MMK-KVM8 Bedienungsanleitung

Cabletron Systems

Cabletron Systems GIGAswitch GSR-16 Bedienungsanleitung

Cisco

Cisco Catalyst X4448 Handbuch