5
1
(h)
ASE 130 8 33 9
ASE 130 8 41 11
ASE 130 8 49 12
(h)
6 5
7
3
4
2
Fig. 4
Fig. 5
Fig. 3
3 Preparaon for use
3.1 Transport and storage
Protect the hose reel from rain, snow aggressive
atmospheres and other damaging circuimstances.
3.2 Installaon and assembly
3.2.1 Assembly
Assembly may only be carried out under consideraon of
these assembly instrucons and applicable regulaons.
1. Remove all the packaging from the product and leave it
assembled on the pallet.
Item 2-6 does not apply if the reel has been
ordered complete with hose.
When assembling the hose, ensure that the reel
is blocked correctly. Risk of personal injury.
2. Secure the pallet and pre-load the hose reel according
to the table. Turn the drum in the direcon indicated by
the arrow (1, Fig. 3).
3. Remove the hose clamp (2) and rubber sheet (3).
4. Install the hose (5) on the sucon tube (4) using hose
clamps (6).
5. Secure the hose by first placing the rubber cloth (3) around
the hose. Then pull the hose clip (2) through the holes
and around the rubber sheet to lock securely (Fig. 4).
The hose stop should, when in the retracted
posion, rest against the drum and fit between
the end cap and the adjacent hose. Risk of wear.
6. Install the hose stop (7, Fig. 3) in the desired posion.
Release the latch and wind the hose unl it stops against
the hose stop.Check that the hose stop is working and
assembled correctly.
7. Remove the roller from the pallet and install it onto the
ceiling or wall using correctly dimensioned fastening
elements.
Dim. Hose length Bias
Product (mm) (m) (turns)*
* The calculaons only apply when using Fumex original AGX hose,
Fumex 3.2 kg nozzle and an installaon height of 6 metres.
8. Check the roller and the venlaon ducts properly, so
that foreign objects are not present. Remove any such
objects immediately.
9. Seal and install the venlaon ducts directly to the
duct connecon on the roller, or use a hose ASL 200
between the duct and roller (see Accessories).
10. Check that the gaskets and connecons on the roller
and venlaon duct are ght.
11. Install the nozzle.
12. The hose winding reel is ready for use.
Maximum mounng height
- 6 m (h, Fig. 5).
