Garmin GVN 52 - Antenna For Navigation System Bedienungsanleitung

GVN 52

installation instructions

WARNING

Failure to avoid the following potentially hazardous situations could result in serious injury, ﬁre, or death.

• Do not attempt to install or service the GVN 52 unless you are a professional electronics installer. Installing or servicing the unit

without training and experience in electronic equipment and automotive accessories may be dangerous and could expose you to the

risk of electric shock or other hazards.

• When extending ignition, battery, or ground wires, use automotive-grade wires or other wires with AWG 18 (0.75 mm2 gauge) or

greater.

CAUTION

Failure to avoid the following potentially hazardous situations may result in injury or property damage.

• Make sure to ground the unit to the chassis of your vehicle.

• Secure all wiring with cable clamps or electrical tape. Insulate unconnected wires; do not allow any bare wiring to remain exposed.

• Do not let unconnected wires or terminals touch metal on the vehicle or anything else that can conduct electricity.

• Do not expose the GVN 52 to water or other liquids. The GVN 52 is not waterproof.

June 2006 Part Number 190-00495-13 Rev. A Printed in Taiwan

Getting Started

RF Remote

GPS antenna and

metal plate

GVN 52 Screws (4) Wiring harnessHook and loop

fasteners (2)

Remote control

Before you begin installation, disconnect the negative battery cable. Then follow the steps below to install the GVN 52.

➊

Install the GPS antenna

Install the GPS antenna on the outside of the vehicle on a metal surface or metal plate. The plate or surface must be at least 3.5

inches by 3.5 inches square. The GPS antenna must have a clear view of the sky and must be placed horizontally for best GPS

reception. See the next page for further instructions.

CAUTION

The permanent adhesive on the back of the metal plate is extremely difﬁcult to remove after it is installed.

➋

Connect the wiring harness

Connect each wire to the appropriate signal in the vehicle. Refer to the wiring diagram for more information. Wrap any unused

wires with electrical tape; do not leave any metal exposed.

➌

Install the GVN 52

Use the screws or the hook and loop fasteners provided to mount the GVN 52 in the vehicle. Select a location that allows you to

access the unit’s SD card slot. We recommended installing it under a seat or in another place close to the driver. Do not install the

GVN 52 inside a metal housing or where it might be shielded from you by a metal object. If there are large metal objects between

you and the GVN 52, the remote control may not work.

CAUTION

Do not install the unit where it will be exposed to direct sunlight, excessive heat or humidity, or dust. Use only the screws

provided. If you use the wrong screws, you could damage the unit.

➍

Install optional accessories

You can install an optional XM Smart Antenna (such as the GXM 30) either inside or outside the vehicle. Like the GPS antenna, it

must have a clear view of the sky. If you use an extension cable with the XM antenna, wrap the two connectors with electrical tape.

For information on installing an optional FM trafﬁc receiver (such as the GTM 10), refer to the Installation Guide included with the

trafﬁc receiver.

➎

Test the installation

Reconnect the negative battery cable, and then turn on the audio/video system to ensure that everything is connected and is

functioning properly. Install batteries in the remote. Then test the remote control to ensure that it is working. If the remote control

does not work, you may need to move the GVN 52 to a different location in the vehicle.

To battery (12 V)

To ignition (12 V)

Yellow (BATT)

Black (GND)

To vehicle chassis

Optional accessory:

XM Smart Antenna or

FM traffic receiver

GPS antenna

Do not connect the yellow wire

directly to the vehicle battery.

Doing so may cause the wire

insulation to fail and may pose a

risk of short circuit and electric

shock.

WARNING

Connect the ignition wires to a power

source that can be turned on and off

with the ignition key. If you connect the

ignition wire to a power source with a

constant voltage supply, such as battery

wires, the vehicle’s battery may die.

CAUTION

2 A

Red (ACC)

SD card

Audio Mute

Red RCA

Audio R

Yellow RCA

Composite Video

White RCA

Audio L

Ignition key switch

Car fuse box

(main fuse)

GVN 52

Best (roof of

vehicle)

Good (inside car

on dashboard)

Better (trunk

of vehicle)

Installing the GPS antenna

Composite video

mode switch

To mount the GPS antenna inside your vehicle:

1. Clean your dashboard or other surface.

2. Peel the backing off of the adhesive on the bottom of the

metal plate.

3. Press the metal plate down ﬁrmly on your dashboard or

other mounting surface. You can bend the metal plate to

conform to a curved surface, if necessary.

4. Place the GPS antenna on top of the metal plate.

Acquiring GPS Signals

The ﬁrst time you turn on the GVN 52, you must wait while the system acquires satellite signals for the ﬁrst time. This process

could take up to several minutes. Make sure your vehicle is outdoors in an open area away from tall buildings and trees for fastest

acquisition. After the system acquires satellites for the ﬁrst time, it will acquire satellites quickly each time thereafter.

Changing the Fuses

If you need to replace a fuse on the Red or Yellow wires, make sure the wires are not touching to prevent a short circuit. Then

replace the old fuse with a new 2 Amp fuse.

CAUTION

When replacing a fuse, use only a new fuse with the prescribed rating. Using a fuse with the wrong rating may cause your

unit to malfunction. Disconnect the wiring harness before replacing a fuse to prevent short circuits.

Speciﬁcations

General

Operating Temperature: 5°F to 158°F (0°C to 70°C)

Storage Temperature: -40°F to 185°F (-40°C to 85°C)

Operating Voltage: 9.5 V to 25 V

Current Consumption: 0.12 A typical at 13 V (Max 1.0 A at 13 V)

ACC off Current: 70 uA typical at 13 V

Dimensions: 1 3/16" H x 4 3/4" W x 4 5/8" L (30 mm x 120 mm x 117 mm)

Weight: 0.41 lb (184 g)

Map Storage: Internal non-removable memory (pre-loaded City Navigator map data on European and North American units) and

optional removable SD card

Connectors: System/power, GPS antenna, SD card slot, Mini-B for optional XM (only on the U.S. version) or FM trafﬁc receivers

Navigation

Receiver: 12 parallel channel GPS receiver

Frequency: 1,575.42 MHz

Acquisition Times:

Warm: Approx. 15 seconds

Cold: Approx. 45 seconds

AutoLocate®: Approx. 2 minutes

Update Rate: 1/second, continuous

GPS Accuracy: 15 meters (49 feet) RMS 95% typical with GPS

DGPS (WAAS) Accuracy: < 3 meters (10 ft) 95% typical with DGPS (WAAS/EGNOS) corrections

Antenna: External GPS antenna, requires metal surface, such as a car roof or the included metal plate. A larger metal

mounting surface improves GPS reception.

Composite Video Switch

Left: NTSC (default)

Middle: NTSC

Right: PAL

NOTE

Video quality varies depending on the display.

Andere Handbücher für GVN 52 - Antenna For Navigation System

Inhaltsverzeichnis

Andere Garmin GPS Handbücher

Garmin

Garmin Zumo 550 - Motorcycle GPS Receiver Bedienungsanleitung

Garmin

Garmin GPSMAP 62 Bedienungsanleitung

Garmin

Garmin Zumo 660 Bedienungsanleitung

Garmin

Garmin GRS 77 Bedienungsanleitung

Garmin

Garmin Speak with Amazon Alexa Bedienungsanleitung

Garmin

Garmin StreetPilot c330 Bedienungsanleitung

Garmin

Garmin Nuvi 205 Series Referenzhandbuch

Garmin

Garmin GPS III Plus Bedienungsanleitung

Garmin

Garmin ECHOMAP ULTRA100 Series Bedienungsanleitung

Garmin

Garmin zumo 590LM Bedienungsanleitung

Garmin

Garmin GPSMAP 8400 series Bedienungsanleitung

Garmin

Garmin nuvi 205W Series Konfigurationshandbuch

Garmin

Garmin nuLink 1695 Bedienungsanleitung

Garmin

Garmin eTrex Legend Cx Bedienungsanleitung

Garmin

Garmin Monterra Bedienungsanleitung

Garmin

Garmin GPSMAP 4000 Series Bedienungsanleitung

Garmin

Garmin DEZL OTR610 Bedienungsanleitung

Garmin

Garmin Etrex Bedienungsanleitung

Garmin

Garmin nuvi 1690 Bedienungsanleitung

Garmin

Garmin eTrex 10 Bedienungsanleitung

Garmin

Garmin eTrex 30x Gebrauchsanweisung

Garmin

Garmin nuvi 850 Bedienungsanleitung

Garmin

Garmin GPSMAP 420 Bedienungsanleitung

Garmin

Garmin GTN Xi Series Bedienungsanleitung

Beliebte GPS Handbücher anderer Marken

Hama

Hama 53118 Bedienungsanleitung

Jigabot

Jigabot EX Bedienungsanleitung

Pointer

Pointer Cellocator CelloTrack XT LTE Installationsanleitung

Queclink

Queclink GV55LITE Bedienungsanleitung

Voxson

Voxson Voxtrack GPS500 Gebrauchsanweisung

Starcom Systems

Starcom Systems Kylos Compact Bedienungsanleitung

Cobra

Cobra Marine MC 600Ci Bedienungsanleitung

Cellocator

Cellocator CelloTrack T Bedienungsanleitung

Enfora

Enfora Mini-MT GSM2228UG001 Bedienungsanleitung

Magellan

Magellan eXplorist 100 Bedienungsanleitung

LTE

LTE G50B Bedienungsanleitung

SkyGolf

SkyGolf SkyCaddie SG1 Bedienungsanleitung

Kenwood

Kenwood DNN9330BT Bedienungsanleitung

Safelet

Safelet Indra Bedienungsanleitung

Bushnell

Bushnell 360100 Bedienungsanleitung

Geneq

Geneq SXBlue Bedienungsanleitung

ORIGO

ORIGO ED308 Bedienungsanleitung

Magellan

Magellan RoadMate 66 Series Bedienungsanleitung