Garmin GVN 53 - Navigation System Bedienungsanleitung

GVN 53

installation instructions

WARNING

Failure to avoid the following potentially hazardous situations could result in serious injury, re, or death.

• Do not attempt to install or service the GVN 53 unless you are a professional electronics installer. Installing or servicing the unit

without training and experience in electronic equipment and automotive accessories may be dangerous and could expose you to the

risk of electric shock or other hazards.

• When extending ignition, battery, or ground wires, use automotive-grade wires or other wires with AWG 18 (0.75 mm

gauge) or

greater.

CAUTION

Failure to avoid the following potentially hazardous situations may result in injury or property damage.

• Make sure to ground the unit to the chassis of your vehicle.

• Secure all wiring with cable clamps or electrical tape. Insulate unconnected wires; do not allow any bare wiring to remain exposed.

• Do not let unconnected wires or terminals touch metal on the vehicle or anything else that can conduct electricity.

• Do not expose the GVN 53 to water or other liquids. The GVN 53 is not waterproof.

June 2007 Part Number 190-00833-00 Rev. A Printed in Taiwan

Getting Started

Optional

Speaker

RF Remote

GPS antenna

and metal plate

GVN 53 Screws (4) Wiring harness

Hook and loop

fasteners (2)

Remote control

Before you begin installation, disconnect the negative battery cable. Then follow the steps below to install the GVN 53.

➊

Install the GPS antenna

Install the GPS antenna on the outside of the vehicle on a metal surface or metal plate. The plate or surface must be at least 3.5

inches by 3.5 inches square. The GPS antenna must have a clear view of the sky and must be placed horizontally for best GPS

reception. See the next page for further instructions.

CAUTION

The permanent adhesive on the back of the metal plate is extremely difcult to remove after it is installed.

➋

Connect the wiring harness

Connect each wire to the appropriate signal in the vehicle. Note that some wires are optional. Refer to the wiring diagram for more

information. Wrap any unused wires with electrical tape; do not leave any metal exposed.

➌

Install the GVN 53

Use the screws or the hook and loop fasteners provided to mount the GVN 53 in the vehicle. Select a location that allows you to

access the unit’s SD card slot. We recommended installing it under a seat or in another place close to the driver. Do not install the

GVN 53 inside a metal housing or where it might be shielded from you by a metal object. If there are large metal objects between

you and the GVN 53, the remote control may not work.

CAUTION

Do not install the unit where it will be exposed to direct sunlight, excessive heat or humidity, or dust as these conditions

could damage the unit. Use only the screws provided. If you use the wrong screws, you could damage the unit.

➍

Install optional accessories

You can install an optional XM Smart Antenna (such as the GXM 30) either inside or outside the vehicle. Like the GPS antenna, it

must have a clear view of the sky. If you use an extension cable with the XM antenna, wrap the two connectors with electrical tape.

For information on installing an optional FM trafc receiver (such as the GTM 10), refer to the Installation Guide included with the

trafc receiver.

➎

Test the installation

Reconnect the negative battery cable, and then turn on the audio/video system to ensure that everything is connected and is

functioning properly. Install batteries in the remote. Then test the remote control to ensure that it is working. If the remote control

does not work, you may need to move the GVN 53 to a different location in the vehicle.

To mount the GPS antenna inside your vehicle:

1. Clean your dashboard or other surface.

2. Peel the backing off of the adhesive on the bottom of the

metal plate.

3. Pressthemetalplatedownrmlyonyourdashboardor

other mounting surface. You can bend the metal plate to

conform to a curved surface, if necessary.

4. Place the GPS antenna on top of the metal plate.

Connect the ignition wires to a power

source that can be turned on and off

with the ignition key. If you connect the

ignition wire to a power source with a

constant voltage supply, such as battery

wires, the vehicle’s battery may die.

Do not connect the yellow wire

directly to the vehicle battery.

Doing so may cause the wire

insulation to fail and may pose

a risk of short circuit and electric

shock.

Optional accessory:

XM Smart Antenna or

FMtrafcreceiver

Composite video

mode switch

GVN 53

SD card

GPS antenna

Better (trunk

of vehicle)

Good (inside car

on dashboard)

Installing the GPS antenna

Best (roof of

vehicle)

Yellow RCA

White RCA

Red RCA

Blue

Gray (Rx In)

WARNING

Composite Video

Audio L

Audio R

Audio Mute

Purple (Tx Out)

Orange (Digital Gnd)

Black (GND)

To vehicle chassis

Red (ACC)

To ignition (12 V)

2 A

To battery (12 V)

Car fuse box

Ignition key switch

Car fuse box

(main fuse)

CAUTION

2 A

Yellow (BATT)

White (Speaker -)

Green (Speaker +)

Can be connected

to optional speaker

Blue wire is

optional. Gray,

purple, and or-

ange wires will not

be connected for

most applications.

See the Owner's

Manual for more

information.

Optional Speaker

Acquiring GPS Signals

The rst time you turn on the GVN 53, you must wait while the system acquires satellite signals for the rst time. This process

could take up to several minutes. Make sure your vehicle is outdoors in an open area away from tall buildings and trees for fastest

acquisition. After the system acquires satellites for the rst time, it will acquire satellites quickly each time thereafter.

Changing the Fuses

If you need to replace a fuse on the red or yellow wires, make sure the wires are not touching to prevent a short circuit. Then replace

the old fuse with a new 2 Amp fuse.

CAUTION

Specications

General

Operating Temperature: 5°F to 158°F (0°C to 70°C)

Storage Temperature: -40°F to 185°F (-40°C to 85°C)

Operating Voltage: 9.5 V to 25 V

Current Consumption: 0.13 A typical at 13 V (Max 1.0 A at 13 V)

ACC off Current: 60 uA typical at 13 V

Dimensions: 1 3/16" H x 4 3/4" W x 4 5/8" L (30 mm x 120 mm x 117 mm)

Weight: 0.41 lb (184 g)

Map Storage: Internal non-removable memory (pre-loaded City Navigator map data on European and North American units) and

optional removable SD card

Connectors: System/power,GPSantenna,SDcardslot,Mini-BforoptionalXM(onlyontheU.S.version)orFMtrafcreceivers

Navigation

Receiver: SiRF STAR III high-sensitivity GPS receiver

Frequency: 1,575.42 MHz

Acquisition Times*:

Warm: < 1 second

Cold: < 38 seconds

AutoLocate®:< 45 seconds

*On average for a stationary receiver with an open sky view

Update Rate: 1/second, continuous

GPS Accuracy: Position: < 10 meters, typical

Velocity: 0.05 meter/sec RMS

DGPS (WAAS) Accuracy: Position: < 5 meters, typical

Velocity: 0.05 meter/sec RMS

Antenna: External GPS antenna, requires metal surface, such as a car roof or the included metal plate. A larger metal

mounting surface improves GPS reception.

Composite Video Switch

Left: NTSC (default)

Middle: NTSC

Right: PAL

Video switch not applicable in North America

NOTE

Video quality varies depending on the display.

Andere Handbücher für GVN 53 - Navigation System

Inhaltsverzeichnis

Andere Garmin GPS Handbücher

Garmin

Garmin GNS 430 Bedienungsanleitung

Garmin

Garmin nuvi 500 Series Bedienungsanleitung

Garmin

Garmin GBR 21 Bedienungsanleitung

Garmin

Garmin nuvi 350 Bedienungsanleitung

Garmin

Garmin nuvi 205W Series Gebrauchsanweisung

Garmin

Garmin GPSMAP 9000 Series Bedienungsanleitung

Garmin

Garmin GMX 200 Bedienungsanleitung

Garmin

Garmin Cessna Caravan G1000 Bedienungsanleitung

Garmin

Garmin ETREX 22X Bedienungsanleitung

Garmin

Garmin GNS 400W Bedienungsanleitung

Garmin

Garmin GPSMAP 60CS Bedienungsanleitung

Garmin

Garmin iQue 3600a Benutzerhandbuch

Garmin

Garmin RINO 750 Bedienungsanleitung

Garmin

Garmin GNS 530 Bedienungsanleitung

Garmin

Garmin GPSMAP 400 series Bedienungsanleitung

Garmin

Garmin GMA 350c Handbuch

Garmin

Garmin GPSMAP 172C - Marine GPS Receiver Bedienungsanleitung

Garmin

Garmin GPSMAP 60Cx Kurzanleitung

Garmin

Garmin GMI 10 Digital Marine Instrument Display Bedienungsanleitung

Garmin

Garmin GPSMAP 78 series Gebrauchsanweisung

Garmin

Garmin nuvi 2555LT Gebrauchsanweisung

Garmin

Garmin STRIKER Series Bedienungsanleitung

Garmin

Garmin StreetPilot III Bedienungsanleitung

Garmin

Garmin 1200 Gebrauchsanweisung

Beliebte GPS Handbücher anderer Marken

Raven

Raven Cruizer II Handbuch

Hama

Hama 53118 Bedienungsanleitung

Jigabot

Jigabot EX Bedienungsanleitung

Pointer

Pointer Cellocator CelloTrack XT LTE Installationsanleitung

Queclink

Queclink GV55LITE Bedienungsanleitung

Voxson

Voxson Voxtrack GPS500 Gebrauchsanweisung

Starcom Systems

Starcom Systems Kylos Compact Bedienungsanleitung

Cobra

Cobra Marine MC 600Ci Bedienungsanleitung

Cellocator

Cellocator CelloTrack T Bedienungsanleitung

Enfora

Enfora Mini-MT GSM2228UG001 Bedienungsanleitung

Magellan

Magellan eXplorist 100 Bedienungsanleitung

LTE

LTE G50B Bedienungsanleitung

SkyGolf

SkyGolf SkyCaddie SG1 Bedienungsanleitung

Kenwood

Kenwood DNN9330BT Bedienungsanleitung

Safelet

Safelet Indra Bedienungsanleitung

Bushnell

Bushnell 360100 Bedienungsanleitung

Geneq

Geneq SXBlue Bedienungsanleitung

ORIGO

ORIGO ED308 Bedienungsanleitung