Garmin Zumo 200 Series Gebrauchsanweisung

zumo®200 series

quick start manual

for use with the zūmo 220

January 2009 190-01144-01 Rev. A Printed in Taiwan

Your zūmo

Serial number

under the battery

Mini-USB

connector under

the weather cap microSD

™

card slot

under the battery

Release key: Slide

up to open the

battery cover.

Battery

contacts

Power button:

Press and hold to turn on/off the zūmo.

Press quickly to adjust the backlight

brightness.

Speaker

GPS antenna

Battery cover

Important Information

‹

Warning

See the Important Safety and Product

Information guide in the product box for

product warnings and other important

information.

‹

Warning

This product contains a lithium-ion battery.

To prevent personal injury or device

damage, remove the device from the

vehicle when exiting or store it out of direct

sunlight.

‹

Warning

Before mounting the zūmo, see the Important

Safety and Product Information guide

for information about laws pertaining to

windshield mounting.

Getting Started

Install the zūmo Battery

1. Locate the lithium-ion battery that came

in the product box.

2. Slide the release key up to open the

battery cover on the back of the zūmo.

3. Locate the metal contacts on the end of

the lithium-ion battery.

4. Insert the battery so that the metal

contacts on the battery match up with

the metal contacts inside the battery

compartment.

5. Press the battery into place.

6. Slide the battery cover back on until it

clicks into place.

Mount Your zūmo in an

Automobile

1. Pull back the weather cap from the mini-

USB connector located on the back of

your zūmo.

2. Plug the vehicle power cable into the

mini-USB connector.

3. Snap the cradle onto the suction cup

arm.

Cradle

Lever

Suction cup

arm

4. Remove the clear plastic from the suction

cup. Clean and dry your windshield and

the suction cup with a lint-free cloth.

5. Place the suction cup on the windshield.

6. Flip the lever back, toward the

windshield.

7. Fit the bottom of your zūmo into the

cradle.

8. Tilt the zūmo back until it snaps into

place.

9. Plug the other end of the vehicle power

cable into a power outlet in your vehicle.

Your zūmo should turn on automatically if

it is plugged in and the vehicle is running.

Mount Your zūmo on the

Motorcyle

‹

Warning

Incorrectly wiring the power cable with

bare wire leads can result in damage to the

vehicle or the battery and can cause bodily

injury. Garmin strongly recommends having

an experienced installer with the proper

knowledge of electrical systems install the

unit.

Step 1: Connect Power to the

zūmo

Select a suitable and secure location to

mount the zūmo on your motorcycle, based

on available power sources and safe cable

routing.

Step 2: Install the Handlebar

Base

The zūmo includes parts for two handlebar

installation solutions. Custom mounts can

require additional hardware (www.ram-

mount.com).

A) To install the U-bolt and handlebar

base:

1. Place the U-bolt around the handlebar,

and thread the ends through the

handlebar base.

2. Tighten the nuts to secure the base. Do

not overtighten.

NOTE: The recommended torque is 50 lbf-

in. Do not exceed torque of 80 lbf-in.

Handlebar

base

Handlebar

U-bolt

B) To install the handlebar base to the

clutch/brake clamp bracket:

NOTE: Both 1/4 in. standard and M6 bolts

are included. Match the size of the factory

bolts on your clutch/brake clamp bracket.

1. Remove the two factory bolts on your

clutch/brake clamp bracket.

2. Thread the new bolts through the

handlebar base, spacers, and clamp

bracket.

3. Tighten the bolts to secure the base.

Clutch/brake

clamp bracket

Handlebar

base

Spacers

Base plate

Cradle

Panhead screws

Washers

Spacers

Nuts

Step 3: Attach the Base Plate to

the zūmo Mount

1. Thread the M4 × 40 mm panhead screws

through the washers, cradle, spacers,

and base plate.

2. Tighten the nuts to secure the base

plate.

Step 4: Attach the Base Plate to

the Handlebar Base

1. Align the ball of the handlebar base and

the ball of the base plate with the double-

socket arm.

2. Tighten the knob slightly.

3. Adjust for better viewing and operation.

4. Tighten the knob to secure the mount.

Cradle

Base plate

Double-socket arm

Knob

Handlebar base

Step 5: Install Your zūmo in the

Mount

1. Fit the bottom of your zūmo into the

cradle.

2. Tilt the zūmo back until it snaps into

place.

Cradle

Release button

Remove Your zūmo from Either

Mount

1. Press the release tab on the top of the

mount to release the zūmo.

2. Lift out the zūmo.

3. Place the weather cap on the cradle

(motorcycle mount only).

Congure the zūmo

To turn on your zūmo, press and hold .

Follow the on-screen instructions.

Acquire Satellites

Go outdoors to an open area, out of garages,

and away from tall buildings. Stop your

vehicle, and turn on the zūmo. Acquiring

satellite signals may take a few minutes.

The bars indicate satellite strength.

When the bars are green, the zūmo has

acquired satellites signals. Now you can

select a destination and navigate to it.

Resetting the zūmo

If the zūmo stops functioning, turn the

zūmo off and on again. If this does not

help, press and hold for 10 seconds. The

zūmo should operate normally. You can also

remove the battery, and then reinstall it.

Using the Menu Page

➊➋ ➌

➍

➎

➏ ➐

➑➒

➊

GPS satellite strength.

➋

Bluetooth headset status.

NOTE: Pages appear differently based on

your usage mode and settings.

➌

Touch to change usage mode.

➍

Battery status.

➎

Current time. Touch to change time

settings.

➏

Touch to nd a destination.

➐

Touch to view the map.

➑

Touch to adjust the volume.

➒

Touch to use the tools such as settings,

Where Am I?, Help, and routes.

Finding Points of Interest

1. Touch Where To? > Points of Interest.

2. Select a category.

3. Select a destination, and touch go!.

To search by name, touch Where To? >

Points of Interest > Spell Name.

To search in a different area, touch Where

To? > Near.

Using the Go! Page

➊➋

➌➍

➊

Touch to view the route on the map.

➋

Touch to start navigating the route.

➌

Touch to view this location and

surrounding areas on the map.

➍

Touch to save this location to your

Favorites.

Using the Map Page

Your route is marked with a magenta line.

As you travel, your zūmo guides you to

your destination with voice prompts, arrows

on the map, and directions at the top of

the map. A checkered ag marks your

destination. If you depart from the original

route, your zūmo recalculates the route and

provides new directions.

➊ ➋

➎➏

➍

➌

➊

Touch to view

the next turn

(navigating on

road).

➊

Touch to view

the compass

(navigating off

road).

➋

Touch the text

bar to view the

turn list.

➌

Touch to zoom

in and out.

➍

Touch the

vehicle icon to

view the Where

Am I? page.

➎

Touch to

view the trip

computer.

➏

Touch to view

the Menu page.

Taking a Detour

If the road ahead is closed, you can take a

detour.

NOTE: Detour is not available when

navigating off road.

1. With a route active, touch Menu.

2. Touch Detour.

The zūmo attempts to nd an alternate route

that avoids the current road or the next road

on your turn list, and then returns to your

original route. If the route you are currently

navigating is the only reasonable option, the

zūmo might not calculate a detour.

Adding a Stop to Your Route

1. With a route active, touch Menu >

Where To?.

2. Search for the extra stop.

3. Touch go!.

4. Touch Add as Via Point to add this stop

before your destination.

Touch Set as new Destination to make

this your new nal destination.

Tip

To add more than one stop, edit the current

route. Touch Where To? > Custom Routes.

Navigating Off Road

When you choose a destination while the

off road feature is enabled, the zūmo plots a

straight line to the destination.

1. Touch Tools > Settings > Navigation.

2. Under Route Preference, touch Off

Road.

Direction to

destination

Customizable

data elds

Heading

Andere Handbücher für Zumo 200 Series

Inhaltsverzeichnis

Andere Garmin GPS Handbücher

Garmin

Garmin GPS 12 MAP Bedienungsanleitung

Garmin

Garmin GNS 430AW Bedienungsanleitung

Garmin

Garmin GPSmap 585 Plus Bedienungsanleitung

Garmin

Garmin GPSMAP 4000 Series Betriebsanleitung

Garmin

Garmin Nuvi 750 - Automotive GPS Receiver Referenzhandbuch

Garmin

Garmin GPS GPS 60 Referenzhandbuch

Garmin

Garmin GPSMAP 376C Bedienungsanleitung

Garmin

Garmin Zumo TM 500/550 Bedienungsanleitung

Garmin

Garmin GWS 10 Marine Wind Sensor Bedienungsanleitung

Garmin

Garmin GPS 400W Bedienungsanleitung

Garmin

Garmin GTS 820 TAS Handbuch

Garmin

Garmin GPSMAP 180 Bedienungsanleitung

Garmin

Garmin GPSMAP 400 series Bedienungsanleitung

Garmin

Garmin G3X Touch Bedienungsanleitung

Garmin

Garmin Nuvi 205 Series Gebrauchsanweisung

Garmin

Garmin GPSMAP 87 Series Bedienungsanleitung

Garmin

Garmin Approach S4 Bedienungsanleitung

Garmin

Garmin nuvi 5000 Bedienungsanleitung

Garmin

Garmin Montana 700i Bedienungsanleitung

Garmin

Garmin GNS 530 Bedienungsanleitung

Garmin

Garmin GPS II+ Bedienungsanleitung

Garmin

Garmin nuvi 1250 Gebrauchsanweisung

Garmin

Garmin GNS 5XXW Bedienungsanleitung

Garmin

Garmin GNS 480 Handbuch

Beliebte GPS Handbücher anderer Marken

Hama

Hama 53118 Bedienungsanleitung

Jigabot

Jigabot EX Bedienungsanleitung

Pointer

Pointer Cellocator CelloTrack XT LTE Installationsanleitung

Queclink

Queclink GV55LITE Bedienungsanleitung

Voxson

Voxson Voxtrack GPS500 Gebrauchsanweisung

Starcom Systems

Starcom Systems Kylos Compact Bedienungsanleitung

Cobra

Cobra Marine MC 600Ci Bedienungsanleitung

Cellocator

Cellocator CelloTrack T Bedienungsanleitung

Enfora

Enfora Mini-MT GSM2228UG001 Bedienungsanleitung

Magellan

Magellan eXplorist 100 Bedienungsanleitung

LTE

LTE G50B Bedienungsanleitung

SkyGolf

SkyGolf SkyCaddie SG1 Bedienungsanleitung

Kenwood

Kenwood DNN9330BT Bedienungsanleitung

Safelet

Safelet Indra Bedienungsanleitung

Bushnell

Bushnell 360100 Bedienungsanleitung

Geneq

Geneq SXBlue Bedienungsanleitung

ORIGO

ORIGO ED308 Bedienungsanleitung

Magellan

Magellan RoadMate 66 Series Bedienungsanleitung