6
Instructions
• Power On/Off—Press and hold power button ( ) for 1 second to switch
ON or OFF. Note: WT-1 will switch on when it receives detector audio.
Modules will automatically switch off after 10 minutes without a paired
mate, or after 30 minutes of inactivity.
• Volume—Adjust with WR-1 volume control buttons. If using
volume-control headphones, set headphones to full volume, and then
adjust WR-1 to maximum desired level. While hunting, additional
adjustments can be made with headphone volume controls.
• Pairing—Switch both modules on. If the pairing indicator ( ) is blinking,
bring modules within 3 feet (1 meter) of each other (and away from any
other Z-Lynk device), and then quickly press and release the power button
on theWT-1 (TX module). Steady pairing indicators on both units indicates
the units are properly paired. The modules will remain paired until you
choose to pair them with another Z-Lynk device.
• Recharging—Plug the supplied charging cables into the modules and
any standard USB port to recharge.
• LED Indicators—Battery indicator ( ) begins blinking when there are
approximately 3 hours remaining. Battery indicator LED displays solid light
while charging and is off when complete.
Pairing indicator ( ) will blink slowly when not paired; will blink quickly
during pairing search; and will remain steady when paired.
• Caution—The WR-1 unit is weather resistant in light rain; the WT-1 unit
will tolerate heavier rain.The Z-Lynk modules should never be submerged.
