Genee G-Touch Bedienungsanleitung

G-Touch 4K & FHD Touchscreen

Interactive Flat Panel Display

User Manual

Please keep the manual for further reference.

This is the general user manual for all interactive displays.

Therefore, it may be different from the actual product.

Welcome

Thanks for purchasing this product. Please read the instructions carefully before

using this product.

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that

may cause undesired operation.

Note 1: This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses and radiates

radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following

measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Note 2: Any changes or modifications to this unit not expressly approved by the

party responsible for compliance could void the user’s authority to operate the

equipment.

The symbol of the crossed out wheeled bin indicates this product should not be

placed in municipal waste. Instead, you need to dispose of the waste equipment

by handing it over to a designated collection point for the recycling of waste

electrical and electronic equipment.

Contents

Safety Instruction ............................................................................................................... 5

1 Installation Requirement ............................................................................................... 9

2 Introduction ..................................................................................................................... 11

3 Basic Operation .............................................................................................................. 19

3.1 Power on ........................................................................................................................ 19

3.2 Power off ...................................................................................................................... 21

3.3 Software Installation .................................................................................................. 22

3.4 Software Uninstall ...................................................................................................... 22

3.5 Software Positioning ................................................................................................. 23

3.6 Positioning Method for Windows 7 System ......................................................... 25

3.7 OPS Installation ........................................................................................................... 27

4 Toolbar Introduction .................................................................................................... 28

4.1 Task Manager .............................................................................................................. 29

4.2 Whiteboard ................................................................................................................... 30

4.3 Gallery ........................................................................................................................... 33

4.4 File Manager ................................................................................................................ 35

4.5 System Settings ......................................................................................................... 35

4.6 Browser ......................................................................................................................... 36

4.7 Audio Only .................................................................................................................... 36

4.8 Kids Safety Lock ......................................................................................................... 37

4.9 Application Programs ................................................................................................ 39

4.10 Temperature Reminder and Thermal Shutdown ............................................... 40

5 Signal Source Selection .............................................................................................. 41

6 Menu ................................................................................................................................. 42

7 ECO Mode ........................................................................................................................ 45

8 Serial Port Control ........................................................................................................ 46

9 VGA Signal Input ........................................................................................................... 49

10 Multimedia Format Support .................................................................................... 50

11 Common Faults and Solutions ............................................................................... 51

12 Care and Maintenance .............................................................................................. 54

13 Technical Parameters ............................................................................................... 55

Safety Instruction

For your safety, please read the following instruction before you use the product.

Serious injury or property loss may be caused by improper operations. Do not try

to repair the product by your own!

ARNING

Disconnect the product from power supply immediately if major

failures occur.

The major failures include the following:

• Smoke, peculiar smell or abnormal sound is discharged from the product.

• No image or sound is displayed, or the image error occurs.

• Where the mains plug or an appliance coupler is used as the disconnect device

the disconnect device shall remain readily operable.

In the preceding scenarios, do not continue to use the product, disconnect power

supply immediately and contact professional staff for troubleshooting.

The socket-outlet shall be installed near the equipment and shall be easily

accessible.

Do not drop liquid, metal or combustible into the product.

• If any liquid or metal is dropped into the product, power off the product and

disconnect power supply, then contact professional staff for solutions.

• Pay attention to the children when they are close to the product.

Do not damage the power cable.

• Do not damage, change, wind, bend, heat or drag the power cable forcibly.

• Do not put weights (such as the product itself) on the power cable.

• Do not drag the cable forcibly when you pull out the power plug. If the power

cable is damaged, please contact the local distributor to repair or replace it.

• The power cable in the accessory box is for this product only. Don’t use it on

other devices.

Put the product on a stable surface.

An unstable surface includes and does not limit to an inclined plane, a shaky

stand, desk or platform, which might cause it to turnover and damage.

ARNING

Use the battery correctly.

• Galvanic corrosion, electric leakage and even fire may be caused by improper

battery usage.

• It is recommended to use the designated type of battery and install the battery

by correct electrodes (positive and negative electrodes).

• Do not install and use new battery together with the used one.

• Take out the battery if the remote control is not used for a long period.

• Do not expose the battery to overheated environments such as sunlight and

fire.

• Dump the used battery based on local regulations.

Do not open the cover or change the product by your own.

High voltage components are installed in the product. When you open the

cover, high voltage, electric shock or other dangerous situations may occur. If

inspection, adjustment or maintenance is required, contact the local distributor

for help.

Use the specified power supply.

• Do not use any types of power cables other than the one provided with the

product to prevent the product from being damaged.

• Use a three-wire socket and ensure that it is properly grounded.

• Pull out the power plug from the socket if the product is not used for a long

period.

Before you move the product, disconnect all external connections

and separate all toppling preventing devices!

Move the product carefully to prevent it from being hit or squeezed, especially the

screen, which may cause injury if broken.

Clean the dust and metal on the power plug regularly.

• When you are cleaning, fire or electric shock may be caused if the product is

powered on.

• Keep in mind to pull out the power plug before cleaning it by using a dried cloth.

Do not put items on the top of the product.

• Do not put items, such as a container for liquid (a vase, flowerpot, cosmetics or

liquid medicine), on the top of the product.

• If any water or liquid is spilled on the product, short circuit may occur and

cause fire or electric shock.

• Do not tread on the product or hang any items on the product.

SAFETY INSTRUCTION

ARNING

Do not install the product in an improper place.

• Do not install the product in humid places, such as the bathroom, the shower

room, or near windows or outdoor environments where rain, snow or other

harsh weather occurs. The installation of the product should avoid humid

environments. The preceding environments may cause faults or electric shock

under extreme conditions.

• Do not put exposed fire source, such as an ignited candle, on the product.

Pull out the power plug during thunderstorms.

• Do not touch the product when lighting to avoid electric shock.

• Install or place components which power supply voltage is high enough to

cause personal injury in places out of the reach of children.

Do not cover or block up any vents on the product.

• The overheated components may cause fire, damage the product and shorten

the service life.

• Do not put the venting surface of the product face down.

• Do not install the product on a carpet or bed clothes.

• Do not use a cloth such as table cloth to cover the product.

Do not touch the power cable with wet hands to avoid electric

shock.

Altitude during operation (m): less than 5000m.

SAFETY INSTRUCTION

CAUTION

Do not install the product in high temperature environments.

• Do not install the product near a heat source, such as a radiator, a stove or

other heating device.

• Do not expose the product to sunlight, which may cause high temperature and

subsequent faults in the product.

For transport:

• Pack the product for mobility or maintenance by using the cartons and

cushioning material provided with the product.

• Vertically move the product during transport. The screen or other components

are easily broken if the product is moved in an improper way.

Keep away from the product when you use a radio.

The product is designed to prevent radio interference and complies with the

international EMI standard. However, the interference still exists and causes

noise in the radio.

• If noise occurs in the radio, try the following solutions.

• Adjust the direction of the radio antenna to avoid the interference from the

product.

• Keep the radio away from the product.

Advice for watching:

• Use the product in an environment with comfortable light. It is harmful to your

eyes to watch in a too bright or too dark environment.

• Relax your eyes after a period of time of watching.

• When you are watching, the distance which is 3 to 7 times of the display height

should be kept, and it is the best distance to protect eyes and prevent eye

strain.

• Adjust the volume to an appropriate level, especially at night.

• Use amplifier equipment as the audio input source with caution. If you must

use amplifier equipment, the input power should not exceed the maximum

of speaker power. Otherwise, problems occur, such as the speaker being

overpowered and damaged.

SAFETY INSTRUCTION

1 Installation Requirement

Bearing

You can choose the portable or a wall-mounting method according to your

needs. The wall mounting can substantially save space.

If you choose portable mounting, use the mounting rack or support. If you want

to use a self-made mounting rack, the bearing capacity of the rack should be

at least four times of the display weight. The bearing capacity of the mounting

support must be four times of the actual weight of the display to ensure

steadiness of the interactive display.

When you choose wall mounted, the bearing capacity of the mounting surface

must be at least four times of the weight of the display. When the mounting

surface is a wall or ceiling of a building, the wall must be built with solid bricks,

concrete or materials of equal intensity. If you need to mount the display on a

loose surface such as an old brick wall, wood plank wall, solid wall, metal or

non-metal structure wall or a wall with a thick decoration layer, take necessary

consolidating measure to ensure that the display is steadily mounted.

Ventilation

requirements Distance to the surface for installation (mm)

Nominal power Left and right

sides Top Bottom Back

Larger than 100 W 100 200 200 100

WARNING

If the product is mounted inside a wall or a cabinet, in addition to the preceding

requirements, the area of ventilation holes at the bottom, top and two sides must

be at least 50% of the sealing surface to ensure proper ventilation.

Left ≥ 100 mm Right ≥ 100 mm

Top ≥ 200 mm

Bottom ≥ 200 mm

Back ≥200 mm

Note

When you install by wall mounting method, ensure the screws are inserted into

the wall deeper than 10mm.

Do not block ventilation vents.

Reference to the CAS 132-2006.

The dimension of the 4 bracket mounting holes in the back panel is VESA

MIS-F compliant (400 x 400mm). Please use the metric M8 screws with length

of 10 to 15 mm to secure the display with the mounting system.

Please have a professional installer to install the display unit.

1 INSTALLATION REQUIREMENT

Inhaltsverzeichnis

Andere Genee Interaktives Whiteboard Handbücher

Genee

Genee 56" Bedienungsanleitung

Beliebte Interaktives Whiteboard Handbücher anderer Marken

SMART

SMART KAPP42 Bedienungsanleitung

Buhl

Buhl LyteBoard Bedienungsanleitung

SMART Board

SMART Board 680 Bedienungsanleitung

SMART

SMART SBX880 Bedienungsanleitung

Legamaster

Legamaster e-SCREEN ETX Bedienungsanleitung

SMART Board

SMART Board SBM685ix2 Bedienungsanleitung

Seneca

Seneca eno Bedienungsanleitung

BenQ

BenQ RP840G Bedienungsanleitung

SMART

SMART Sympodium IC-150 Bedienungsanleitung

Olivetti

Olivetti OLIBOARD Bedienungsanleitung

Turning Technologies

Turning Technologies MOBIVIEW Bedienungsanleitung

Panasonic

Panasonic UB-5335 Bedienungsanleitung

Dukane

Dukane ITP84 Bedienungsanleitung

Bretford

Bretford EDUIMS Konfigurationshandbuch

Panasonic

Panasonic Panaboard UB-5315 Bedienungsanleitung

Plus

Plus M-11S Bedienungsanleitung

TRIUMPH BOARD

TRIUMPH BOARD ULTRA SLIM Bedienungsanleitung

Returnstar Interactive Tech

Returnstar Interactive Tech IQBoard DVT V7.0 Bedienungsanleitung