IPCam SECURE300W User’s Manual
KYE Systems Corp. 8
1. Network Cable Connector
The IPCam SECURE300W’s rear panel features an RJ-45 connector
for connections to 10Base-T Ethernet cabling or 100Base-TX Fast
Ethernet cabling (which should be Category 5 twisted-pair cable).
The port supports the N-Way protocol and “Auto-MDIX” function,
allowing the IPCam SECURE300W to automatically detect or
negotiate the transmission speed of the network.
2. External Antenna
The rotatable external antenna allows you to adjust its position to
obtain the maximum signal.
3. Reset Button
Reset will be initiated when the reset button is pressed once, and
Power LED begins to flash.
Factory Reset will be initiated when the reset button is pressed
continuously for three seconds or when Power LED begins to light
up. Release the reset button and the Power LED will begin to flash,
indicating the IPCam SECURE300W is changing to factory reset.
When factory reset is completed, the IPCam SECURE300W will be
set to default on channel 11 and SSID is set as “NULL String” (This
default setting will let the IPCam SECURE300W connect to ANY
access point on the infrastructure network). The IP address will also
return to the default setting as 192.168.0.20.
4. DC Power Connector
The DC power input connector is located on the IPCam
SECURE300W’s rear panel, and is labeled DC5V with a single jack
