2 | P a g e
the Anti-Wind Brush Pile within the small openings in the Screen Fabric. Now retract the
screen.
Check and correct any interference (e.g. screws or debris) inside the B-Inside Rails.
Check that the D-Pull Bar glides smoothly. Slightly trim the aluminum D-PULL BAR if needed.
Check to see if the J-Weather Strip is catching or binding in the B-Inside Rails
Remove the plastic Cassette End Cap with Chain from the A-Screen Cassette Assembly and
verify that the bolt is not fastened so tightly that it is restricting the operation.
THE SCREEN DOES NOT RETRACT EVENLY
Check that the screen has been installed in a square and plumb opening, correct as needed.
Pull the screen all the way down to the bottom of the opening and then retract the screen. This
will often help the screen fabric to realign.
Pull the screen all the way down to the bottom of the opening. Look to see if there are creases
in the fabric or other signs indicating that the screen fabric may have rolled over itself inside the
A-Screen Cassette Assembly. If needed remove the A-Screen Cassette Assembly from the
opening, extend (unroll) all of the screen fabric and on the A-Screen Cassette Assembly and
then retract the fabric making sure to remove any wrinkles or creases.
ANTI-WIND BRUSH PILE MOVES IN THE SIDE GUIDE RAILS
The Anti-Window Brush Pile that is located inside the aluminum B-Inside Rails need to be
crimped securely in place so that it does not move within the channels of the B-Inside Rails (see
step 4).
THE L-PULL BAR LOCKS DO NOT CATCH ON THE D-PULL BAR
Adjust the height of the latch on the L-Pull Bar Locks using the wheel style finger adjustment.
The engagement of the L-Pull Bar Locks to the D-Pull Bar should match image 4C.
THE D-PULL BAR MOVES DURING WINDY CONDITIONS
Add an additional O-Weight Bar (or other ballast material) inside the D-Pull Bar.
Windy conditions may affect the performance of a retractable screen. Retract the screen in
windy circumstances, during inclement weather, when not needed to support immediate
ventilation or during prolong periods when not used.
THE SCREEN IS TORN OR WRINKLED
Contact dealer to order a Screen Refill Replacement Kit
THE J-WEATHER STRIP DOES NOT SEAL AGAINST THE FLOOR/SILL
Check that the screen has been installed in a square and plumb opening. Correct the opening as
needed.
Contact dealer to order the slightly larger seal options.
Adjust the height of the latch on the L-Pull Bar Locks using the wheel finger adjustment. The
engagement of the L-Pull Bar Locks to the D-Pull Bar should match image 4C.
Add an additional O-Weight Bar (or other ballast material) inside the D-Pull Bar.
WHEN RETRACTED THE L-PULL BAR WITH SCREEN FABRIC FALLS DOWN SEVERAL INCHES
Add spring tension.
