Programming and Information Guide
Programming 2-Button HomeLink:
Before programming HomeLink®
•During programming, it is possible that garage doors, gates, or other devices may operate. For
this reason, make sure that people and objects are clear of the garage door or other devices to
prevent injury or other potential harm.
•It is recommended that a new battery be placed in the remote control transmitter for more
accurate programming.
•Garage door opener motors manufactured after 1995 may be equipped with rolling code
protection. If this is the case, you may need a stepladder or other sturdy, safe device to reach the
“Learn” or “Smart” button on the garage door motor.
•Please note that the instructions below apply to the majority of HomeLink use cases. However,
there are some HomeLink applications or HomeLink compatible systems that require slightly
different instructions.
Programming a brand new HomeLink
•Position the hand-held transmitter 1-3 inches away from the HomeLink surface, keeping the
HomeLink indicator light in view.
•Using both hands, simultaneously press and hold both the desired HomeLink button and hand
held transmitter button. DO NOT release until the HomeLink indicator light flashes slowly and
then changes to solid or rapidly flashing. The change in flashing indicates the frequency signal
has been learned.
oNote: Some gate operators and garage door openers may require you to use the
“cycling” procedure noted in the “Programming an entry gate” section.
•Press and hold the programmed HomeLink button and observe the indicator light.
oIf the indicator light is solid/continuous, programming is complete and your device should
activate when the HomeLink button is pressed and released.
oIf the indicator light blinks rapidly, proceed with the following programming instructions for
a rolling code device.
oA second person may make the following steps quicker and easier. Use a stepladder or
other stable, safe device.
•Rolling Code
•At the garage door opener motor in the garage, locate the “learn” or “smart” button (usually near
where the hanging antenna wire is attached to the unit). If there is difficulty locating the “learn” or
“smart” button, reference the garage door opener’s manual.
•Press and release the “learn” or “smart” button (the name and color of the button may vary by
manufacturer).
oNote: Once the button is pressed, there are typically about 30 seconds in which to initiate
the next step.
•Return to the vehicle and press and release the programmed HomeLink button. Repeat the
“press/release” sequence up to 3 times to complete the training process. HomeLink should now
activate your rolling code equipped device.
•To program additional HomeLink buttons, repeat this process.
•Once programmed, the HomeLink Wireless Control System or the original hand-held transmitter
may be used to activate the device (e.g. garage door, entry lock, gate, etc.).
Programming an entry gate (for U.S.A. owners)/Programming a device in the Canadian market
•Position the hand-held transmitter 1-3 inches away from the HomeLink surface, keeping the
HomeLink indicator light in view.
•Using both hands, hold the HomeLink button, and simultaneously press and release the hand-
held transmitter button at 2-second intervals. DO NOT release the HomeLink button until the
indicator light flashes slowly and then changes to solid or rapidly flashing. The change in flashing
indicates the frequency signal has been learned.
