Setup Procedure (QUAVAR-PI & Metal Detector)
Once you have assemble the aachment to the device.
Clip it to the waist band of your harness, now you are
ready to tune your Detector To the QUAVAR-PI. It is a
very simple procedure. We are providing you with a
series of seng to suit Minelab pulse inducon detec-
tors series. Just fallow the steps.
Note: For the best tacle percepon, secure the hapc
transducer underneath your harness on the chest area
for maximum body contact.
Connect the QUAVAR-PI to your detector by in-
serng the 6.5mm male jack from the audio cable
of the device into your detector power pack or
baery audio output female jack.
Next turn on both machines and let the detector
go through its tuning cycle. On the QUAVAR-PI
adjust the volume of its external speaker to a
comfortable level. The hapc transducer acvates
automacally when the device is turned to the ON
posion.
SD & GP Series:
On your detector adjust the Audio Pitch (TONE).
With the SD & GP series the TONE level is to be
set to about 3/4 of the way up. Use the QUAVAR-
PI audio extension cable (GT3021) .
SDC Serie:
The SDC 2300 has two audio pitch sengs, High
and Low. For the Quavar-PI to funcon properly
the detector has to be set to the LOW Audio Pitch
(Tone) seng.
GPX Series:
With the GPX 5000 it is important to set the Audio
Tone to 43 or under so as not to overload the
QUAVAR-PI. Do not lower the seng below 40 or
raise the seng above 45.
GPZ Serie:
With the GPZ 7000 it is important to set the
Threshold Pitch to between 65 to 70. It has a pre-
set seng of 53.
5
Looking for the it in the pile of
dirt
