Goldmund REFERENCE II Handbuch

ASSEMBLY &

USER MANUAL

GOLDMUND REFERENCE II

Turntable

Congratulations.

Thank you for purchasing the GOLDMUND Reference II Turntable.

You have acquired a highly exclusive and refined limited series product holding a number of new

features that have never been experienced before. Please take some time to read this manual. It

will provide you with useful information to make your pleasure of using the Reference II Turntable

even higher.

INTRODUCTION

GOLDMUND REFERENCE II Turntable

Goldmund was founded in 1978 and has ever since been dedicated to the accurate reproduction of

sound and image.

At Goldmund, we strive to lead in the creation, development and manufacture of the industry’s

most advanced technologies, including audio and video systems, home - networking and music

distribution.

The guiding principle at Goldmund is to produce a precise sound with the least possible loss of

quality through the different stages. Goldmund will never adopt a technology before it is sufficiently

developed to satisfy the high quality standards we set. This is why Goldmund has often rejected

mainstream technologies and developed its own.

GOLDMUND REFERENCE II - Assembly Manual - 3

Table of Contents

1 UNPACKING 5

2 CHOICE OF TURNTABLE LOCATION 5

3 TURNTABLE ASSEMBLY 6

4 AMPLIFIER CONTROLS 20

5 USER INSTRUCTIONS 21

6 CLEANING & MAINTENANCE 22

GOLDMUND REFERENCE II - Assembly Manual - 4

W A R N I N G !

The Goldmund Reference II you just purchased

represents a summit in terms of design,

concept and quality of reproduction.

Therefore, great care should be taken before

attempting to put the unit together. Read the

instruction manual carefully. This will eliminate

the risk of damage or loss in performance.

PLEASE READ THE INSTALLATION

MANUAL COMPLETELY PRIOR TO

INSTALLATION.

PLEASE DO NOT CONNECT ANY CABLES

OR MOVE ANY PART BEFORE READING

THE FOLLOWING INSTRUCTIONS.

OBSERVE GENERAL ELECTRICAL

SAFETY PRECAUTIONS PARTICULARY

WITH REGARD TO AVOIDING WATER,

MOISTURE AND HEAT. TO REDUCE THE

RISK OF ELECTRIC SHOCK, DO NOT

REMOVE THE COVERS AND REFER

SERVICING TO QUALIFIED PERSONNEL.

GOLDMUND REFERENCE II - Assembly Manual - 5

1 UNPACKING

Your turntable is shipped in 4 separate wood boxes labeled 1 to 4 and 1 carton box labeled

- Box 1: the base (feet assembly)

- Box 2: the table top

- Box 3: the tripod

- Box 4: all mechanical parts to be assembled

- Box 5: the power supply

The electronic control box is already assembled under the table top.

ATTENTION

Please keep the packaging in case you need to transport the turntable at a later date or if

you have to send it for maintenance.

This packaging has been designed specifically to protect the Reference II turntable in

transit. Use of alternative packaging is likely to result in damage, invalidating warranty.

2 CHOICE OF TURNTABLE LOCATION

Due to the total weight of your turntable (300kg), please choose the definitive location of

your turntable in order to install it on site.

Locate the player on a support providing the most rigid possible connection to the floor.

Solid coupling is essential, and if your support is standing on a suspended floor, at least

one foot should be located over a supporting beam or close to a supporting wall for an

optimal result.

WARNING!

PLEASE READ INSTALLATION

MANUAL COMPLETELY PRIOR

TO INSTALLATION.

3 PERSONS ARE NECESSARY

TO INSTALL THIS TURNTABLE

GOLDMUND REFERENCE II - Assembly Manual - 6

3 TURNTABLE ASSEMBLY

STEP 2

Box 2: the Table top

Unscrew and remove the top cover of the wood box n°2.

Remove the protection cover,

Mount the table top on the base with the control panel keyboard facing the front.

Then, unscrew the cover hiding of the electronics cables below the table.

Free the control panel cables from the base bottom and run all cables through

base.

STEP 1

Box 1: the base (feet assembly)

Unscrew and remove the top of the wood box n°1.

Remove the protection cover.

Unscrew and remove a side of the wood box.

Free the feet base and position it at its definitive location, the red bar on the back.

Note:

Make sure the small screen is facing toward the front, with both central pointes

bolt on the back.

BACK

FRONT

GOLDMUND REFERENCE II - Assembly Manual - 7

STEP 3

Box 3: Tripod

Unscrew and remove the top cover of the wood box n°3.

Remove the protection cover.

Remove the 3 cylindrical weights sitting on top of the tripod feet.

STEP 4

Box 3: Tripod

Unscrew the tripod from its 3 feet.

Keep the 3 screws that you will use back at the end of the assembly.

GOLDMUND REFERENCE II - Assembly Manual - 8

STEP 5

Box 3: Tripod

Free the tripod assembly from the box and set it on 3 temporary supports like

foam rubber or books, leaving the center free.

GOLDMUND REFERENCE II - Assembly Manual - 9

STEP 6

Box 3: Tripod

In the box n°3, you will find the 3 cylinder feet of the tripod.

Please take one cylinder foot to position it at the front left position.

Be carful to select the foot with the correct basis (check the bottom of the foot).

Repeat the operation for the front right cylinder foot.

GOLDMUND REFERENCE II - Assembly Manual - 10

Box 4: Various Parts

In the box n°4, you will find:

- 1 platter

- 1 motor bloc

- 1 belt

- 12 rubber seals

- 1 large golden insert

- 3 small golden insert

- 1 clamp

- 1 small oil bottle

STEP 7

Box 4: Various Parts

Take the large golden insert.

STEP 8

Position it in the center of the third cylinder foot position.

Inhaltsverzeichnis

Andere Goldmund Drehscheibe Handbücher

Goldmund

Goldmund Reference II Turntable Handbuch

Beliebte Drehscheibe Handbücher anderer Marken

Gemini

Gemini CDT-05 MKII Bedienungsanleitung

Rotel

Rotel RP-820 Bedienungsanleitung

Shuman

Shuman MC-250BT Bedienungsanleitung

Stanton

Stanton STR8-150 Bedienungsanleitung

Audio Technica

Audio Technica AT-LPW40WN Bedienungsanleitung

Crosley

Crosley McQueen CR7011-GY Bedienungsanleitung

Reloop

Reloop SMP-1 Bedienungsanleitung

auna

auna TT-Classic Plus Bedienungsanleitung

COMO AUDIO

COMO AUDIO Turntable Analog Bedienungsanleitung

Dual

Dual 1009 F Bedienungsanleitung

REED

REED Muse3C Bedienungsanleitung

AXIOMTEK

AXIOMTEK OPS883-H Series Bedienungsanleitung

Pioneer

Pioneer PL-71 Bedienungsanleitung

Vestax

Vestax PDX-a1 Bedienungsanleitung

Denon

Denon DP-400 Bedienungsanleitung

Dual

Dual 504 Bedienungsanleitung

Audio-Techica

Audio-Techica AT-LP60XBT Bedienungsanleitung

Goldring

Goldring G99 Bedienungsanleitung