"Autoswitch-on" mode: With the handset off the cradle,
allows to stablish audio communication with the door
panel that has been configured with the autoswitch-on
function.
"PA" output mode: regardless of the handset's
position, it activates the "PA" telephone output.
"Call to a slave porter's exchange" mode: With the
handset off the cradle, allows to call to a slave porter's
exchange.
"Intercom" mode: With the handset off the cradle, allows
to make an intercom call between two units of the same
apartment.
Function push buttons.
With handset on the cradle: sends a panic call to the
porter's exchanges.
With handset off the cradle: allows to call to the master
porter's exchange. During call reception and communication
progresses allows the lock release activation.
Auxiliary function push button, depending on setting in the
SW1 dip switch.
P3
SW1
1 2
1 2
1 2
1 2
1 2
SW1 configuration dip switch.
Accessed by opening the telephone, allow the
next modes for the auxiliary function push button:
Fix the telephone to the wall.
To install the telephone directly over the wall, drill
two holes of 6mm. on the specified positions,
using 6mm. wall plugs and Ø3,5 x 25mm
screws.
OPERATION
DESCRIPTION
IMPORTANT: Select the auxiliary function push button mode
before programming the telephone.
Factory default
Avoid placing the telephone near sources of heat, in dusty locations
or smoky environments. The telephone can be fixed using an
electrical embedding box or directly on the wall.
INSTALLATION
To open the telephone, insert a plain
screwdriver into the slots and gently lever
as shown in the drawing.
Pass the installation wires through the corresponding
hole and connect them. Close the telephone as
shown on the picture. Once the telephone is
closed, connect the handset using the telephone
cord and put it on the cradle.
2
Receiving calls: While the call is in progress, pick up the telephone
handset to stablish audio communication for one and a half minutes
or until the handset is replaced.
Door release: During call or communication progresses, press the
door release push button to allow the visitor acces to the building.
