Goodman TSTATG2152-2 Bedienungsanleitung

Air Conditioning & Heatin g

Model TSTATG2152-2

Digital Thermostat

Owner ’s Manual

Tha nk good nes s for Goodman.

Heat Pump 5+2 Day Programmable

Control up to 2-Heat & 1-Cool

Battery or System Powered

Auxiliary Heat Indicator

Fahrenheit or Celsius

Service Filter Indicator

Backlit Digital Display

Page 2

Contents Page #

Time Period Programming

Advanced Setup

Battery Replacement

Overview

Weekday Programming

Weekend Programming

Normal Operation

Manual Operation

Warranty

Safety Warnings

Location of Controls

Display

Programmed Operation

Clock Set

Advanced Features

Factory Defaults

Calibration

Aux Heat

OWNER'S MANUAL TSTATG2152-2

The two Alkaline “AA” batteries must be replaced at

least once every 12 months to ensure proper

operation. The Low Battery icon (fig. 1) will

appear on the display when it is time to replace

the batteries. If the thermostat is connected to

24v power, the batteries should still be installed, but

are not required.

When is displayed the batteries must be replaced

immediately. The manufacturer cannot be liable for

improper operation of the thermostat if the batteries are

not immediately replaced.

Annual battery replacement is especially critical in

locations subject to freezing temperatures. The

thermostat will be unable to turn on the heating system

if the batteries are exhausted.

CAUTION Follow Installation Instructions carefully.

DISCONNECT POWER TO THE HEATER -

AIR CONDITIONER BEFORE REMOVING

THE OLD THERMOSTAT AND INSTALLING

THE NEW THERMOSTAT.

WARNING

Page 3

Safety Warnings

CAUTION

This device complies with Part 15 of the FCC rules.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2)

this device must accept any interference received, including

interference that may cause undesired operation.

P/N TSTATG2152-2

FIG. 1

OWNER'S MANUAL

TSTATG2152-2

Location of Controls

Page 4

NEXT BUTTON

RESET FILTER

OWNER'S MANUAL

How to Use: Press and

hold the RESET FILTER

button to clear the

AUX HEAT

SWITCH

Emergency

Normal

Lockout

icon from the

display (pg 5). To adjust

when the icon

appears, see Advanced

Setup screens (pg 19).

FILTER

TSTATG2152-2

COOLER &

WARMER

BUTTONS

PROGRAM SWITCH

RUN program

Program OFF

SET program

SET

HEAT

I2:00

BATTERIES

COOL

OFF

PROGRAM

RUN OFF SET

RESET

FILTER

FAN

HEAT

AUX HEAT

NORM

EMRGC’Y LOCKOUT

AUTO

ON On or Auto

FAN SWITCH

For programming

How to use: The NEXT

button is used to advance

from one step to the next

in the programming and

advanced setup screens

(pgs 9 - 18).

BI-COLOR LED

Heat or Cool demand

indicator when system

powered: Red = Heat

Green = Cool

MODE

SWITCH

Cool, Off,

or Heat

SET

MTuWThF

SaSu

PM MorningEvening

Day

Night AUX

HEAT

COOL

I2:00

FILTER

Page 5

Display

Clock Display.

Desired set temperature.

Current room temperature.

Indicates that 2nd stage of heat is energized.

Indicates when the filter should be serviced. Appears

after 0 - 1950 hours of blower operation (adjustable).

Indicates batteries need replacement.

Heat and Cool indicators. In normal operation, Heat or

Cool appears, depending on the Mode Switch position.

When heat or cool is energized, the Heat or Cool

indicator will flash.

Day of the week. When programming, MTuWThF

represent the five weekdays and SaSu represent the

two weekend days.

Time period indicators. These indicate the part of

the program that is currently active, if the Program

Switch is positioned to RUN.

OWNER'S MANUAL TSTATG2152-2

Page 6

COOLER & WARMER

BUTTONS

PROGRAM SWITCH

RUN program

Program OFF

SET program

MODE SWITCH

Cool, Off, or Heat

Normal Operation

OWNER'S MANUAL

Manual Operation (Program Switch OFF)

Select Cool or Heat with the Mode Switch.

Normally leave the fan switched to Auto.

In Fan Auto, the fan will turn on only with a heat

or cool demand. When Fan On is selected, the

fan will run continuously.

Adjust the desired set temperature with the

COOLER and WARMER buttons.

TSTATG2152-2

SET

HEAT

I2:00

BATTERIES

COOL

OFF

PROGRAM

RUN OFF SET

RESET

FILTER

FAN

HEAT

AUX HEAT

NORM

EMRGC’Y LOCKOUT

AUTO

On or Auto

FAN SWITCH

Normal Operation

Page 7

OWNER'S MANUAL

Programmed Operation

Select Cool or Heat with the Mode Switch.

Normally leave the fan switched to Auto.

In Fan Auto, the fan will turn on only with a heat

or cool demand. When Fan On is selected, the

fan will run continuously.

The desired set temperature may be temporarily

overridden. The thermostat will revert to the

programmed settings in the following time period.

Select RUN with the Program Switch.

TSTATG2152-2

COOLER & WARMER

BUTTONS

PROGRAM SWITCH

RUN program

Program OFF

SET program

MODE SWITCH

Cool, Off, or Heat

SET

HEAT

I2:00

BATTERIES

COOL

OFF

PROGRAM

RUN OFF SET

RESET

FILTER

FAN

HEAT

AUX HEAT

NORM

EMRGC’Y LOCKOUT

AUTO

On or Auto

FAN SWITCH

Page 8

Normal - Aux Heat is allowed to run, if necessary,

along with the heat pump to satisfy the

heat demand.

Lockout - Aux Heat will never turn on

regardless of the heat demand.

Aux Heat

OWNER'S MANUAL

Emergency - Disables all compressor

functions* and energizes only Aux

Heat to satisfy the heat demand.

When the Aux Heat switch is in the Emergency position the compressor will also be

locked out during cooling operation.

AUX HEAT

SWITCH

TSTATG2152-2

SET

HEAT

I2:00

BATTERIES

COOL

OFF

PROGRAM

RUN OFF SET

RESET

FILTER

FAN

HEAT

AUX HEAT

NORM

EMRGC’Y LOCKOUT

AUTO

Page 9

Clock Set

Use these buttons to

adjust the current time.

Use these buttons to

adjust the current day.

Setting the time & day are the first two steps after

sliding the Program Switch to SET.

Slide the Program Switch to the SET position.

This thermostat is preprogrammed from the

factory to operate 1 or 2-Stage equipment without

the need for further programming. To optimize the

installation of this thermostat follow the instructions

in the Advanced Setup section.

6:00

Press NEXT

to advance

OWNER'S MANUAL

To slew the time more rapidly, push and hold the

COOLER or WARMER buttons.

TSTATG2152-2

PROGRAM

RUN OFF SET

Time Period Programming

PROGRAM SWITCH

Page 10

Overview

Slide the Program Switch to the SET position.

The blinking icon(s) on the display may be

changed by pressing the COOLER or

WARMER buttons.

After the blinking icon is changed to the desired

selection, press the NEXT button.

Each item in the time period programming screens will flash

and can be modified with the COOLER & WARMER buttons.

Continue the steps above until programming is complete.

Slide the Program Switch to RUN and the thermostat

will run the time period programming.

If the Program Switch is in the OFF position, the thermostat

will not run the time period program. In this case, the

thermostat will be a manual heat or cool only thermostat.

OWNER'S MANUAL TSTATG2152-2

PROGRAM

RUN OFF SET

Andere Handbücher für TSTATG2152-2

Inhaltsverzeichnis

Andere Goodman Thermostat Handbücher

Goodman

Goodman TSTATG1100-2 Bedienungsanleitung

Goodman

Goodman OTDFPKG-01 Bedienungsanleitung

Goodman

Goodman TSTATG4271GT Bedienungsanleitung

Goodman

Goodman G2270 Originalbetriebsanleitung

Goodman

Goodman TSTATG4272 Bedienungsanleitung

Goodman

Goodman TSTAT G2200C Bedienungsanleitung

Goodman

Goodman G4273 Technisches Handbuch

Goodman

Goodman GT4273 Bedienungsanleitung

Goodman

Goodman G4273 Bedienungsanleitung

Goodman

Goodman TSTATG1152-2 Bedienungsanleitung

Goodman

Goodman GT4272 Fehlerbehebungshandbuch

Goodman

Goodman TSTATG1152-2 Bedienungsanleitung

Goodman

Goodman TSTATG2152-2 Bedienungsanleitung

Goodman

Goodman TSTATG2111 Bedienungsanleitung

Goodman

Goodman TSTATG2100-2 Bedienungsanleitung

Goodman

Goodman TSTATG2111 Bedienungsanleitung

Goodman

Goodman TSTATG2111-2 Betriebsanleitung

Goodman

Goodman TSTAT GTS1175 Bedienungsanleitung

Goodman

Goodman TSTATG1100-2 Bedienungsanleitung

Goodman

Goodman TSTATG4272GT Betriebsanleitung

Goodman

Goodman TSTATG2152-2 Bedienungsanleitung

Goodman

Goodman TSTATG2100-2 Bedienungsanleitung

Beliebte Thermostat Handbücher anderer Marken

EWELLY

EWELLY EW-181 Bedienungsanleitung

Prolon

Prolon T1100 Montageanleitung

Computherm

Computherm Q20 Bedienungsanleitung

Heatmiser

Heatmiser neoStat Bedienungsanleitung

Mars

Mars HEAT CONTROLLER IR Wireless Thermostat Bedienungsanleitung

Saswell

Saswell SAS920XWHB-7-S-RF Leitfaden

Aircalo

Aircalo TFP1-ET85P2 Bedienungsanleitung

Honeywell

Honeywell CM721 Bedienungsanleitung

Carrier

Carrier DEBONAIR 33CS Bedienungsanleitung

Lennox

Lennox iHarmony Zone Thermostat Montageanleitung

Gemtech

Gemtech GT7000 Bedienungsanleitung

Rollei

Rollei Smartes 45000 Bedienungsanleitung

Sinope

Sinope TH1300RF Bedienungsanleitung

Honeywell

Honeywell RLV4305 Bedienungsanleitung

Honeywell

Honeywell Prestige 2.0 THX9421 Bedienungsanleitung

NuTone

NuTone NTBZ48 Original Betriebsanleitung

Stelpro

Stelpro MAESTRO ASMT402AD Bedienungsanleitung

Honeywell

Honeywell T6811 Bedienungsanleitung