IMPORTANT: Always activate a moving screen saver program when you leave the Jamboard unattended. Always activate a
periodic screen refresh application if the unit will display unchanging static content. Uninterrupted display of still or static images
over an extended period may cause “burn in”, also known as “after-imaging” or “ghost imaging”, on your screen. This is a well-
known phenomenon in LCD panel technology. In most cases, the “burned in” or “after-imaging” or “ghost imaging” will disappear
gradually over a period of time after the power has been switched off.
WARNING: Severe “burn-in” or “after-image” or “ghost image” symptoms will not disappear and cannot be repaired. This is also not
covered under the terms of your warranty.
RF Warning:
Federal Communication Commission Interference Statement:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
• If the Jamboard becomes wet, wipe it with dry cloth as soon as possible.
• If a foreign substance or water gets in the Jamboard, turn the power off immediately and disconnect the power cord.
Then remove the foreign substance or water, and send the unit to the maintenance center.
• Do not store or use the Jamboard in locations exposed to heat, direct sunlight or extreme cold.
• In order to maintain the best performance of the Jamboard and ensure a longer lifetime, we strongly recommend using
the Jamboard in a location that falls within the following temperature and humidity ranges.
-- Temperature: 0-40°C 32-104°F
-- Humidity: 20-80% RH
Service:
• The casing cover should be opened only by qualified service personnel.
• If there is any need for repair or integration, please contact your local service center.
• Do not leave the Jamboard under direct sunlight.
!
If the Jamboard does not operate normally, having followed the
instructions set out in this document, please contact a technician
or your local service center.
