Graco SnugRide Click Connect Base Bedienungsanleitung

Infant Restraint Base

Owner’s Manual

SnugRide®

Click ConnectTM

Base

See infant restraint owner’s manual for complete

installation instructions.

DO NOT PLACE THIS INFANT RESTRAINT IN A VEHICLE

SEATING LOCATION THAT HAS A FRONT AIR BAG . If the air bag

inflates, it can hit the infant restraint with great force and cause serious

injury or death to your child. Check vehicle owner’s manual for

information about side air bags and infant restraint installation.

You MUST read and understand both the owner’s manual from the

infant restraint and these instructions before using the infant restraint

and base. Keep this sheet with the instruction booklet in the base for

reference.

This base can only be used with a Graco®SnugRide® Click

Connect™ 35 LX, SnugRide® Click Connect™ 30 and SnugRide® Click

Connect™ 35.

If you do not have instructions for your infant restraint or if you have

any questions about your product, call Graco at 1-800-345-4109.

Your infant restraint base is equipped with Graco’s recline adjustment

foot, which helps to properly recline the infant restraint/base on the

vehicle seat. Use itAFTER you have carefully followed all of the steps

in your infant restraint owner’s manual.

Locking clip

(See infant restraint

owner’s manual)

Installing the Base Using Vehicle Belt

You must carefully follow the instructions provided by your vehicle

manufacturer, in addition to the information in this manual.

If a front passenger seat is used, slide the

vehicle seat rearward as far as possible from

the dashboard. If a rear seat is used, make sure

the seat in front of it is moved forward enough

and is upright enough to allow room for the

infant restraint.

1. Make sure vehicle is on level ground in order

to get the correct recline position .

2. Place the base in a rear-facing position on a

forward-facing vehicle seat.

3. When using the base to install the

infant restraint, the lock-off is ALWAYS

used to secure both belts of the

lap or lap/shoulder belt.

Open the lock-off and route the

vehicle belt through the vehicle belt path and

over the lock-off . Buckle the vehicle belt.

4. Make sure the buckle tongue goes into the

correct buckle

. The seat belt should

not be twisted or turned.

Lap Belt Lap/Shoulder

Belt



Belts MUST go

under lock-off



Lock-off





5. To create a secure installation, while

pushing down on the base, pull the free

end of the lap belt or the shoulder portion

of the lap/shoulder belt to tighten .

6. Close lock-off over lap belt AND free end of the

lap/shoulder belt .

NEVER allow any object other than the vehicle

belts to go under or interfere with the lock-off.

If any other part of the vehicle belt interferes

with the lock-off choose another seating location.

MAKE SURE that you push the top of the

lock-off all the way down.

7. Check that belt does not move by pulling

and pushing hard on base with hands near the

vehicle belt path. If belt loosens or lengthens,

repeat procedure. If it does not stay tight, try

another seating position or contact Graco at

1-800-345-4109.

8. Push the infant restraint down into the base and

make sure that you hear a “click” . Pull up on

the infant restraint to be sure it is latched

securely into the base.

If the infant restraint does not securely latch

into the base, the infant restraint provides NO

protection for your child. DO NOT use the

infant restraint/base if the infant restraint

does not securely latch into the base.

9. Test infant restraint for secure installation as

described in infant restraint “Final Safety

Check” page 9.







CLICK!

1. MAKE SURE vehicle is on level ground. Make

sure to check your vehicle owner's manual for

LATCH seating positions.

2. For ease of installation, press button to extend

LATCH to its MAXIMUM LENGTH .

3. Position base in vehicle seat as shown.

4. Make sure LATCH is through vehicle/LATCH

belt path normally used for vehicle seat belt. .

Belt must lie flat and not be twisted.

LATCH belt must not go under lock-off.

Using LATCH to Install Base

Newer vehicles may have one or more seating positions with LATCH

anchorage systems. If vehicle is equipped with LATCH, the vehicle lower

anchor points may be visible at the vehicle seat crease. If not visible,

they may be marked with the symbol .

See your vehicle owner’s manual for exact locations, anchor

identification, and requirements for use with an infant restraint.

LATCH locations

Typical seat in a passenger vehicle.

Other vehicle types may have

different LATCH locations or

different markings.

Vehicle Lower

Anchor Points

Vehicle

Seat Crease





5. Attach connectors to vehicle lower anchors.

Pull firmly on connectors to be sure they

are attached .

6. Tighten LATCH by pushing down hard on

base and pulling the adjustment belt back

through belt path .

7. NEVER put two LATCH connectors on one

vehicle LATCH anchor .

8. Test infant restraint for secure installation as

described in infant restraint “Final Safety

Check” page 9.

9. Check that the LATCH stays tight and does not

slip from the tightened position. If it does not stay

tight, try another seating position or contact

Graco at 1-800-345-4109.

10. To remove LATCH, push button while

pulling on the LATCH belt as shown .

11. Press and hold LATCH release hinge .

12. Push connector in, lift connector up and

pull out (away from anchor point) .

13. Repeat steps 11 and 12 for other connector.



CLICK!











Reclining Infant Restraint/Base

1) Vehicle MUST be level with ground to get

correct recline position.

2) Use level indicator on base. When reading

the level indicator on base, view it directly from

side of the indicator.

Check the level indicator. You must look

straight on at the indicator.

WHEN READING THE LEVEL INDICATOR,

- If the indicator shows light blue

in the window, the restraint is

level for infants 0+ months in age.

- If the indicator shows light blue

and dark blue in the window,

the restraint is level for a child

3+ months in age.

- If any RED is showing, child

restraint is NOT level. You must

adjust your recline position.

3+ months

(meses)

Use corrected age for preemies.

Turn the knob counter clockwise to the desired

setting to lower the foot .

Turn the knob clockwise to raise the foot .

If there is still red in the level indicator when the

foot is completely extended then raise the foot

and place a rolled towel under the foot until

ONLY blue shows.

Re-adjust the vehicle seat belt as necessary to

secure the infant restraint firmly in the vehicle seat.







Final Safety Check:

Every time you drive with your child,

PUSH DOWN on the top of the infant restraint slowly but

firmly to make sure the vehicle belt does not

lengthen at all and that the vehicle belt or LATCH is

fastened securely around the infant restraint/base.

Holding the infant restraintor base near the vehicle

belt path, TWISTAND PULL the infant restraint

forward and to both sides to make sure the vehicle

belt or LATCH does not lengthen or loosen and the infant restraint does

not easily move. The infant restraint should not move side to side or

forward more than 1 inch (2.5 cm).

1. For ease of storing, extend

LATCH to its maximum

length .

2. LATCH storage should look

like this when complete .





Storing LATCH

To purchase parts or accessories or for warranty

information in the United States,

please contact us at the following:

www.gracobaby.com

1-800-345-4109

Replacement Parts

Bottom

of Base

Inhaltsverzeichnis

Sprachen:

Andere Graco Autositz Handbücher

Graco

Graco ECE.R44/03 Universal 03.44.160 Bedienungsanleitung

Graco

Graco Car Booster Seat Bedienungsanleitung

Graco

Graco SNUGRIDE 35 LITE LX Bedienungsanleitung

Graco

Graco PD269300A Bedienungsanleitung

Graco

Graco Child Restraint Bedienungsanleitung

Graco

Graco SNUGRIDE SNUGLOCK Bedienungsanleitung

Graco

Graco 65 Bedienungsanleitung

Graco

Graco SnugRide Classic Connect 35 Stücklistenhandbuch

Graco

Graco 8491 Bedienungsanleitung

Graco

Graco NAUTILUS SNUGLOCK LX Bedienungsanleitung

Graco

Graco SnugRide Classic Connect 30 Bedienungsanleitung

Graco

Graco Child Restraint Bedienungsanleitung

Graco

Graco 8J00MTX - Nautilus 3- In 1 Toddler Car Seat Bedienungsanleitung

Graco

Graco Turn2Me Bedienungsanleitung

Graco

Graco 8487 Stücklistenhandbuch

Graco

Graco NAUTILUS Stücklistenhandbuch

Graco

Graco Child Restraint Bedienungsanleitung

Graco

Graco 8689HOU Bedienungsanleitung

Graco

Graco Child Restraint Bedienungsanleitung

Graco

Graco 41413ZOL Bedienungsanleitung

Graco

Graco 8402L04 - SnugRide Infant Car Seat Base Bedienungsanleitung

Graco

Graco Turn2Me Bedienungsanleitung

Graco

Graco ARGOS 80 Bedienungsanleitung

Graco

Graco AFFIX Bedienungsanleitung

Beliebte Autositz Handbücher anderer Marken

Britax

Britax PARKWAY SGL Bedienungsanleitung

JANE

JANE nurse cruiser Bedienungsanleitung

Digicom

Digicom Tippy Pad Bedienungsanleitung

Giordani

Giordani orion 012 Bedienungsanleitung

BRIO

BRIO ZENTO Bedienungsanleitung

Combi

Combi Zeus Turn 8815 Series Bedienungsanleitung

Coccolle

Coccolle Atira Bedienungsanleitung

hifold

hifold HF01-GL Bedienungsanleitung

CYBEX

CYBEX SOLUTION X2-FIX Bedienungsanleitung

kiwy

kiwy SLF 123 Bedienungsanleitung

Safety 1st

Safety 1st Summit ISO 30 Bedienungsanleitung

Safety 1st

Safety 1st Grand 2-IN-1 Bedienungsanleitung

Britax

Britax Multi-Tech BB0-702-00 Bedienungsanleitung

Grammer

Grammer MSG45/421 Betriebsanleitung

Nuna

Nuna REBL PLUS Bedienungsanleitung

Little Tikes

Little Tikes Highway Bedienungsanleitung

Combi

Combi Navette 22 Bedienungsanleitung

Britax

Britax FRONTIER Bedienungsanleitung