Basic Operation
On receipt of a Fire signal, the audio/visuals will activate.
After a delay, set by the Delay pot. (30-91secs), the door will close to the Fully
Closed position, set by the Run timer (60-183 secs). Once the Run timer has
timed out (60-183secs) the panel will pulse the solenoid output and reset.
Part Close (Smoke Curtain) Operation
On receipt of a Fire signal, the audio/visuals will activate.
The door will close to the Part Close position, set by the Part Close pot. (3-30secs).
After a delay, set by the Delay pot. (0-330secs), the door will close to the Fully
Closed position. Once the Run timer has timed out (60-183secs) the panel will
pulse the solenoid output and reset.
Mains Fail - Basic Operation
In the event of a Mains Power failure, the audio/visuals will activate.
After a delay, set by the Delay pot. (30-91secs), the door will close to the Fully
Closed position by solenoid release. Once the Run timer has timed out
(60-183secs) the panel outputs will reset. The audio/visuals will remain active until
mains power is restored to the panel.
Mains Fail - Part Close (Smoke Curtain) Operation
In the event of a Mains Power failure, the audio/visuals will activate.
After a delay, set by the Delay pot. (30-91secs) the door will close to the Fully
Closed position by solenoid release. Once the Run timer has timed out
(60-183secs) the panel outputs will reset. The audio/visuals will remain active until
mains power is restored to the panel.
Photocell Override - Basic Operation
On receipt of a Fire signal the audio/visuals will activate.
After a delay, set by the Delay pot. (30-91secs), the door will attempt to close to the
Fully Closed position. If the photocell beam is broken, the door will stop & reverse
(if connected to a MINI Standard control panel) or the door will stop (if connected to
a tube motor). When the photocell beam is remade the door will attempt to close
again. The photocell beam will be overridden after 5 operations and the door will
close to the Fully Closed position. If the time the photocell beam is broken exceeds
the set duration of the Photocell Override timer (60-308secs), the door will close to
the Fully Closed position, set by Run timer (60-183secs). Once the Run timer has
timed out the panel will pulse the solenoid output and reset.
Photocell Override - Mains Fail Operation
In the event of a Mains Power failure, the audio/visuals will activate.
After a delay, set by the Delay pot. (30-91 secs), the door will attempt to close to
the Fully Closed position. If the photocell beam is broken, the Photocell Override
timer is activated. Once this timer has timed out the door will close to its Fully
Closed position via solenoid release. Once the Run timer has timed out (60-183
secs) the panel outputs will reset. The audio/visuals will remain active until mains
power is restored.
EMC-3B Audio/Visual Control Panel Operation
D.I.L. Sw.1 OFF
D.I.L. Sw.2 OFF
D.I.L. Sw.1 ON
D.I.L. Sw.2 OFF
D.I.L. Sw.1 OFF
D.I.L. Sw.2 ON
D.I.L. Sw.1 ON
D.I.L. Sw.2 ON
D.I.L. Sw.1 OFF
D.I.L. Sw.2 OFF
D.I.L. Sw.1 OFF
D.I.L. Sw.2 ON
