H3C S5500-SI Series Bedienungsanleitung

Tool list

Mounting the switch to a rack

Introduction to installation accessories

Before installation, wear an ESD-preventive wrist strap, and make sure that the wrist strap

has a good skin contact and is well grounded.

When the depth of a switch is greater than 300 mm (11.81 in), the front mounting

brackets only secure the switch rather than bear its weight.

Flathead

screwdriver

Phillips

screwdriver

ESD-preventive wrist

strap

Needle-nose

pliers

Wire-stripping

pliers

Diagonal

pliers

Blow dryer

Grounding cable

Front mounting bracket

and M4 screws

Cage nut (User supplied)

Rear mounting bracket

and load-bearing screw

Rubber pads

M6 screw (User supplied) Bail latch

The installation tools are not provided with the switch. Prepare them by yourself.

Method 1—Using only front mounting brackets

Install front

mounting brackets

Install cage nuts to the

square holes of the rack

Method 2—Using front and rear mounting brackets

Install the load-

bearing screw

Install the front mounting

bracket

Install cage nuts to the

square holes of the rack

Mount the rear mounting

brackets to the square holes on

the rear post of the rack

Mounting the switch to a workbench

Stick the rubber pads to the appropriate

positions on the switch bottom

Connecting the grounding cable

Method 2 +12 VDC (RPS)

123

You can use only the RPS power supply recommended by H3C (optional RPS power

supply and power cable) for RPS DC input.

Install an OT terminal on the other end of the grounding

cable, and connect the OT terminal to the grounding strip.

Connect the OT terminal of the

grounding cable to the switch

Connecting the power cable

Before connecting the power cable, connect the grounding cable and make sure that

the switch is correctly grounded.

Connect the power cable to the switch first and then to the power supply system to

avoid bodily injury.

Connect the AC power cable

Install the bail latch

123

Connect the power

cable to the receptacle

Secure the bail latch over

the power cable

Connect the DC power cable

Method 1 –52 VDC to –55 VDC (RPS)

For more information about the product and installation procedures, log in to www.h3c.com

Andere Handbücher für S5500-SI Series

Andere H3C Schalten Handbücher

H3C

H3C S1200 Series Bedienungsanleitung

H3C

H3C S6520-EI Series Bedienungsanleitung

H3C

H3C S5500-28 C-EI-DC Bedienungsanleitung