Haier HR-138A Bedienungsanleitung
HR-138A
Disposal of the old appliance
Before disposing an old appliance that goes
out
of use, please make sure it’s inoperative
and safe. Unplug the appliance and remove
or destroy all of the springs, latches, or
boltlocks in order to avoid the risk of child
entrapment.
It must be noticed that refrigeration system
contains insulating gases and refrigerants,
which require specialized waste disposal.
The valuable materials contained in a
refrigerator can be recycled. Contact your
local waste disposal center for proper
disposal of an old appliance and contact
your local authority or your dealer if you
have any question. Please ensure that the
pipework of your refrigerator does not get
damaged prior to being picked up by the
relevant waste disposal center, and
contribute to environmental awareness
by insisting on an appropriate, anti-pollution
method of disposal.
Disposal of the packaging of your
new appliance
All the packaging materials employed in the
package of your new appliance may be
disposed without any danger to the
environment.
The cardboard box may be broken or cut
into smaller pieces and given to a waste
paper disposal service. The wrapping foil
is
made of polyethylene and the polyethylene
pads and stuffing contain no fluorochloric
hydrocarbon.
All these valuable materials may be taken
to a waste collecting center and used again
after adequate recycling.
Consult your local authorities for the name
and address of the waste materials collecting
centers
and waste paper disposal services
nearest to your house.
Safety Instructions and Warnings
Before starting the appliance, read the
information given in the User’s Guide
carefully. The User’s Guide contains very
important observations relating to the
assembly, operation and maintenance of
the appliance.
Keep the User’s Guide in a safe place and
remember to hand it over to the subsequent
owner, if you ever sell the appliance.
The manufacturer does not accept
responsibility for any damages that may
arise due to non-observation of the
following instruction.
Damaged appliances are not to be put
into operation. In case of doubt, consult your
supplier.
Connection and installation of the
appliance are to be carried out in strict
compliance with the relative instructions set
forth in the User’s Guide.
.1.
Cautions
For the purpose of safety, the appliance
must be properly grounded in accordance
with specifications.
Always remember to unplug the appliance
before cleaning. Never unplug your
refrigerator by pulling on the power cord.
Always grip plug firmly and pull straight out
from the outlet.
All electrical repairs must be carried out
by qualified electricians. Inadequate repairs
may result in a major source of danger for
the user of the appliance.
Keep high-proof beverages in airtight
bottles or containers and always store in
an upright position. In addition, do not store
any explosive substances inside the appliance-
Danger of explosion!
Do not damage any parts of the appliance
that carry refrigerant by piercing or perforating
the refrigerant’s grooves with sharp or
pointed items, crushing or twisting any tubes,
or scraping the coatings off the surfaces. If
the refrigerant spurts out and gets into eyes,
it may result in serious eye injuries.
Do not obstruct or cover the ventilation
grille of the appliance.
Do not allow children to play with the
appliance. In no case should children be
allowed to sit on the drawers or hang to the
door.
If the supply cord is damaged, it must
be replaced by the manufacturer or its service
agent or a similarly qualified person in order
to avoid a hazard.
Specifications
This appliance is designed for food
refrigeration, ice making and frozen food
storage also can be accessed if the tem-
perature regulator is set at “6” or”7”.
It is intended strictly for household use.
If using it for industrial or commercial
purpose, be sure to observe the relevant
norms and regulations.
The refrigerating circuit is leak-proof.
.2.
Cautions
WARNING:
The plug should be accessible after the
appliance positioned.
The manufacturer reserves the right to improve the
product from time to time without further notice.
.3.
Parts
.4.
Installation
The appliance must stand on even flooring.If the freezer is not level, adjust the
front leveling leg to raise or lower it.
Install the appliance in a well-ventilated
room. Allow 10cm on each side and 10cm
over the top of the
freezer
for easy
installation and proper air circulation.
Do not expose the appliance to direct sun-
light or a heat source as cookers, radiators,
heaters, etc.
An extremely cold room is unsuitable for
installation of the appliance.
To prevent electric shock, do not ex-
pose the appliance to rain or moisture.
.5.
Reversible door
1. Detach the plug (6) at the left upper corner and the screws (1) at the left lower corner.
2. Detach the cover (5) of the hinge box at the right upper corner to remove the upper hinge.
Hold and lift the door to take it out and put aside.
3. Detach the lower hinge (2) and the component (3). Insert the component (3) to the left hole
of lower hinge (2) and tighten.
4. Assemble the screws (1) to the corresponding position on the right side and tighten.
5. Assemble the upper hinge (4) to the corresponding position on the left side and tighten.
6. Assemble the door from below on the hinge (4).
7. Assemble the lower hinge (2) to the left side of the door.
8. Insert the plug (6) on the right upper corner.
9. After reversion of the door, open and close the door for several times to see to it that there
is no unusual noise and all the screws and hinges are tightened.
Basic Operation
.6.
Basic Operation
.7.
Operation Instructions
Do not make the inner temperature lower than
necessary. Adjust the temperature regulator in ac-
cordance with the ambient temperature and the
amount of food.
To lower the power consumption, allow warm
foods and beverages to cool down before storing them
in the refrigerator.
For cold air circulation in the inner compartment, do
not overfill the shelves.
Wrap or pack the foods to be refrigerated sepa-
rately to keep the strong smells from giving off and to
keep the foods from being dried.
Ice preparation
Fill 4/5 the ice tray with water and place in the
lower part of the evaporator.
Set the temperature regulator at ‘7’.
After making ice, reset the regulator to its origi-
nal setting. Otherwise the foods in the refrigera-
tor may get frozen.
How to take out the ice cubes
To take out the ice tray, knock the ice tray lightly
to remove it from the evaporator.
Hold the bottom of the ice tray in running water
for a while.
Twist both sides of the ice tray to remove the ice
cubes.
.8.
The appliance is unsuitable for storage of frozen
food or ice-cream-Danger of thawing!
Bottles of beverages that may get cracked when fro-
zen should not be stored in the evaporator.
Medicine or valuable scientific specimen should
not be stored in the refrigerator.
Keep off the cold surface of the evaporator espe-
cially when hands are wet.
When the plug is pulled out, wait 3 minutes or
more before plug in again. Otherwise it may do harm
to the compressor.
When not in use
Unplug the appliance.
Clean the inner compartment thoroughly. Leave
the door open for 2 or 3 days.
Note: Do not stop the appliance frequently.
Otherwise, the service life of the appliance may
be shortened.
Operation Instructions
.9.
Defrosting/Cleaning
Defrosting
The surface of evaporator ices up when the re-
frigerator is working. When the frost layer is thick
as 3mm, the refrigerator must be defrosted and
cleaned. Otherwise, it may results in lower efficiency
and high energy consumption.
Set the temperature at ‘0’ position. After
defrosting, dry the water tray and then replace it in
the refrigerator. Reset the temperature regulator to
its original position.
Note: Never use a sharp or pointed item to
defrost or loose the ice tray. Otherwise it’s likely to
damage the surfaces of the evaporator and result in
the leakage of refrigerant. The manufacturer takes no
responsibility for cost of the reparation even the ap-
pliance is under warranty.
When a power failure is announced
No defrosting
Set the temperature regulator to the highest
setting.
No more fresh foods are to be stored in the
refrigerator.
Power failure
Do not open the door more often than necessary.
For a power failure not more than 3 hours, foods
in the refrigerator can be well stored even in
summer.
Moving the refrigerator
Unplug the appliance
Take out foods and dry the water tray before
moving the refrigerator.
Note:Do not hold the refrigerator by its door and
the piping of condensor-That’s dangerous!
Andere Handbücher für HR-138A
1
Inhaltsverzeichnis
Andere Haier Kühlschrank Handbücher
Haier
Haier HOBT7719EW Bedienungsanleitung
Haier
Haier A3FE742CMJ Bedienungsanleitung
Haier
Haier AFL631CB Bedienungsanleitung
Haier
Haier HTE10WNA Bedienungsanleitung
Haier
Haier A3FE737CPJM Bedienungsanleitung
Haier
Haier HSBS582AW Bedienungsanleitung
Haier
Haier HDE03WNA Bedienungsanleitung
Haier
Haier HRF-521D 6 Series Bedienungsanleitung
Haier
Haier HR-138AR Bedienungsanleitung
Haier
Haier ACMO3ARW Bedienungsanleitung
Haier
Haier HRF-220 Bedienungsanleitung
Haier
Haier HNSE04 Montageanleitung
Haier
Haier CSM SERIES Bedienungsanleitung
Haier
Haier HRF-800DGS8 Bedienungsanleitung
Haier
Haier HRF-349NAA Bedienungsanleitung
Haier
Haier HBF130SS Bedienungsanleitung
Haier
Haier JR-NF140A Bedienungsanleitung
Haier
Haier HRT02WNC Bedienungsanleitung
Haier
Haier HRQ04GNB Bedienungsanleitung
Haier
Haier HRF08WND Bedienungsanleitung
Beliebte Kühlschrank Handbücher anderer Marken
Bonnet Neve
Bonnet Neve SKYVIEW PLUS Bedienungsanleitung
Zanussi Electrolux
Zanussi Electrolux ZERB 8441 Bedienungsanleitung
Sharp
Sharp SJ-BA31IEXW2-EU Bedienungsanleitung
CORBERO
CORBERO CC2300MCW Bedienungsanleitung
KitchenAid
KitchenAid 2205264 Bedienungsanleitung
Stengel
Stengel KU 1101 A++ Bedienungsanleitung
