Haier BW1500W Bedienungsanleitung
Fully automatic washing machine
User's manual
This manual is for
BW1500W
Please read this manual carefully before using.
Retain it for future reference.
Contents
Names of the parts
Safety precautions
Trouble-shooting Answer to question
Packing list Specification
Installation and adjustment
Preparation before washing
Put in the laundries
Add the detergent
Use the operation knobs and buttons
Installation the water inlet hose
Disposal after washing
*
Finish washing
Close the top lid
Please check if the power receptacle has good earthing
condition before using to guarantee your safety.
Warning sign
Names of the parts
Meaning and description of the symbols
Forbidding sign
Contents marked with that symbol are related
to the safety of the product and the personal
safety of the users. Please operate in strict
conformity to the contents, otherwise it may
cause damageof the machine or injure the
personal safety of the user.
Contents marked with that symbol are actions
forbidden to perform. Performing of those
actions may result in damage of the machine
or injure the personal safety of the user.
Top lid, I
Detergent box
Location of lint filter
Control panel seat
Inner tub
Control panel film
Pulsator
Cabinet
Lower cabinet
Top lid, II
Adjustable foot
Power cord
Drain hose
Fixing foot
(three)
Water absorption cushion Water inlet valve
Handle
Drain hose hanging hole
Back cover
Level meter
Safety precautions
Please insert the power cord into
special receptacle with rated vol-
tage.Be sure to use single-phase
three pins receptacle.The earthing
terminal of the receptacle must be
earthed reliably.If possible,please
adopt electric leakage protector.
When the machine is normally
using, please put the power plug
at the location easily to be insert-
ed and extracted by hand. Be sure
to pull the plug off when there's
power failure, or the machine is
being moved, cleaned or when it
is idle.
If the power cord is bad, to avoid risk it is required to replace it by the
technicians of our special shop or the after-sale service department.
Keep the pin of the power plug clean.
Earth
The ventilation
holes at the bottom
Soft object
Do not put the machine at damp place like
the bathroom. Never wash it with water.
In case the washing machine is installed on ground with
carpet, do not block the ventilation hole with carpet.
Do not let the machine share one receptacle with other electric appliances. If the power plug is damaged, or the
plugging into the receptacle is loose, do not use the plug any more.
Do not wash water-proof laundries like the raincoat,
bike covers etc. to avoid abnormal vibrations in spinning.
Do not use water hotter than 50 C .
Safety precautions
Do not stretch hands into the working machine.
It is dangerous even if the rotation is slow.
Take special care of the children.
Do not decompose, repair or alter the machine
by yourself.
Do not put any hot or heavy items (such as the kettle
with hot water) on the washing machine
Do not wash laundries with volatile materials
(such as thinner, petrol etc.).
Keep the machine away from direct sunlight and
heat source like the heater.
The handicapped or children without care shall not
use the machine.
The lint filter shall be kept in good condition, and
installed to proper position. If the lint filter is lost
or damaged, please contact the local after-sales
service department of our company.
Benzene
Install the bottom plate
Adjust the installation position
Soft items
Bottom plate Screw
Installation and adjustment
Please install and adjust the machine according to the requirement of the manual. It is
very important to your security and correct operating the machine.
Back
Front
After openingthe package, pleaselean the
washing machine gently down on soft items
(like towel cloth, blanket, etc.). Install the
bottom plate to the bottom of the machine
with eight screws by a cross screwdriver,
then lift the machine up gently. See to the
figure:
Loosen Fasten
High Low
Adjustable nut
Adjustable leg
The largest allowable slope of the shank base of the machine is 2 .
The slanting or rough ground will result in unstable running or
stoppage of the machine. Please adjust it with following methods:
Confirm it's horizontal:
Adjust the adjustable leg:
If the bulb of the level meter at the balance display
position is inside the standard circle, it indicates that
the machine is horizontal. Otherwise you need to
adjust the adjustable leg of the machine.
1.To twist the adjustable leg, please first lift up the
leg side slightly, loosen the adjustable nut, and
then twist the leg.
2.After adjustment, fasten the nut.
Air bubble
Standard circle
Suitable Not suitable
Install the lint filter
After opening the package, please take out the
lint filter from the document bag and install it
into the Filter frame of the inner tub. See to the right figure.
Lint filter
Filter frame
1.The height of the drain hose shall be
less than 10cm, or the drainage will not
be smooth, and cost such long time that
the machine may stop at mid way.
2.Do not ramp or press the drain hose.
3.If the drain hose is too long, cut it at mid
point. To make smooth drainage, cut the
front end of the hose slantingly.
4.If extra drain hose is needed, please
make separate purchase. The inner
diameter of the extra hose shall not
less than 30mm, and the length shall
not exceed 1.5m.
1.Lean the machine down gently with the front
surface facing the ground.
3.Extend the drain hose from the left side. Push the
drain hose into the groove with hands.
2.Pull out the drain hose from the groove at the left side.
Back
Front
Soft item
Use groove at
this side after
direction changing
Usage of the drain hose
The drain hose shall drain smoothly
If the extra hose is too long, cut it
either at Aor at B point.
4.Install the bottom plate (as per indicated
before), then lift the machine up gently.
Page 4
How to change the direction of the drain hose
Install the water inlet pipe
Connection between the water inlet hose jointer and the water faucet
Water faucet, suitable water faucet, not suitable
It is required that the front end shall be longer than 10mm.
The outlet end surface of the faucet shall be flat and smooth. If not, please file it smooth to avoid leakage.
2. Loosen the four screws of the water inlet hose jointer till the water faucet can be accessed. Then set the water inlet hose
jointer on the faucet. See to Figure 2. If the faucet is too large and the jointer cannot be set on, please loosen the four
screws and take out the bush inside the jointer. See to Figure 3.
1.Press the lower end of the lock lever and push down the slider. Take off the water inlet hose jointer from the
water inlet hose component. See to Figure 1.
3. Fasten thefour screws ofthe water inlethose jointer evenly. See toFigure 4.
About 4mm after twisting
Remark: .Before installation, the threading is 4mm above the upper surface of the nut.
After installation, the threading is 2mm above the upper surface of the nut..
About above 2mm after twisting
Water inlet hose jointer
Screw knife
Screw
Bushing
Nameplate
Screw nut
Water inlet hose Figure 1
Figure 4
Figure 2
Figure 5
Figure 3
Figure 6
Slider
Lock level
Install the water inlet hose
4. Take off the nameplate.Twist the fastening nut as per the indication of the figure
to seal up the exit end face of the faucet. See to Figure 5.
Connection between the water inlet hose and the washing machine
1 Do not takeoff the waterabsorption cushion. Pleasecheck
if the cushion isdropped or damaged eachtime before using.
If it happens so,please duly contact ourafter-sale service
department.
2 Set the nutof the water inlethose on the waterinlet valve jointer.
3 Fasten the nut.Swing it gently toconfirm if it's fastenedwell.
Water absorption cushion.
Water inlet
hose nut
Water inlet valvejointer
7
Dismount the water inlet hose
Connection between the water inlet hose jointer and the water inlet hose
Check the connection between the water inlet hose jointer and the
water faucet
1.Swing the hosegently to checkif it is fastened stably.
2.After installation, open thefaucet to check ifit leaks water.
3.Do not bend thehose by force.
4.Each time before using,please check if theconnection
between the water inlethose jointer and thewater faucet,
and the installation ofthe water inlet hoseisfirm, so as
to avoid dropping owingto improper installation.
1. Push downthe slider.Plug the waterinlet hose intothe jointer.
2. Hang thelock lever ontothe jointer.Release
the slider tilla click soundis heard.
Lock level
Slider
The water inlet
hose jointer
Slider
Locking level
1. Close thewater faucet.
2 .Press thelock lever andpush down theslider. Thenpull off the
water inlet hose.If the machineis used more than once every
week, the waterinlet hose jointercan remain onthe faucet to
avoid damaging thefastening screws.
1 Preparation before washing
Preparation before washing
1.Connect the water inlet hose. Open
the water faucet.
2.Confirm that the washing machine is
earthed reliably. Then insert the
power plug into the receptacle. The
earth terminal shall not link to gas
pipeline and faucet water pipeline.
3.Put down the drain hose.
Pay attention to followings before washing the laundries
Check if
the laundries
has special
requirement
on washing
Clear the
pocket. Take
out the coins,
sand, hairpins
etc.
Tie the long
strips; fasten
the buttons;
close zippers.
When the pulsator
is running , the
buttons of the
laundries may
cause noise. For
the sake of
discretion, please
put the laundries
with buttons into
other laundries.
The quantity of
the laundries
shall not be too
large. Stretch
and loosen the
laundries before
putting them in
the tub.
a. Check if the laundries are applicable for washing with machine.
b. Divide the laundries that are not colorfast from other laundries.
c. Put those laundries difficult to absorb water into water with hand.
d. For those laundries with heavy soil, please first remove the dirt like
mud or dust. For the parts with heavy soil, please apply detergent on
them in advance, which can make it easier to remove the soil.
e. For those laundries that may get lint ball and those with long fur, turn
it over before putting in.
f. Do not put those laundries polluted by chemicals into the washing
machine directly.
Inhaltsverzeichnis
Andere Haier Waschmaschine Handbücher
Haier
Haier SIG100-97 Bedienungsanleitung
Haier
Haier HW80-B14939S8 Bedienungsanleitung
Haier
Haier JW-G42A Bedienungsanleitung
Haier
Haier XPB60-DS Bedienungsanleitung
Haier
Haier HW60-B12866NZP Bedienungsanleitung
Haier
Haier HBS82-880 Bedienungsanleitung
Haier
Haier JW-K70F Bedienungsanleitung
Haier
Haier HWM130-9188 Bedienungsanleitung
Haier
Haier XQG80-HB1286A Bedienungsanleitung
Haier
Haier Thermocool HMS800TVE Bedienungsanleitung
Haier
Haier HWM70-928NZP Bedienungsanleitung
Haier
Haier HW70-IM12929 Bedienungsanleitung
Haier
Haier HWM100-1701R Bedienungsanleitung
Haier
Haier XPB56-23S Bedienungsanleitung
Haier
Haier HW100-BD14979U1 Bedienungsanleitung
Haier
Haier HWM140-826S5 Bedienungsanleitung
Haier
Haier GE GFW510SCN0 Anleitung zur Verwendung
Haier
Haier HW-B1460 Kurzanleitung
Haier
Haier JW-K60A Bedienungsanleitung
Haier
Haier HLP21N Bedienungsanleitung
