6
LED working light
1.5.2 Setting in the
Configuration menu
Requirements:
• Batteries inserted
• Diagnosis plug 97097737 available
Preparation:
1. Placethemachineonalevelsurface
and hold it with the parking brake.
2. Open the seat console.
3. Remove the bolts of the cover.
4. Carefully remove the cover from the
front, ensuring that the plug of the
on-board charger is not pulled out.
5. Connectdiagnosisplug97097737to
plug A1.X3 (Fig. 3/2) of the
control electronics A1.
Setting:
1. Open the configuration menu:
Press buttons 1 and 2 simultaneous-
ly,switch on thekey switch (Fig. 3/3)
and hold for 3 seconds. The right-
hand dot flashes in the indicator
(Fig. 3/4):
2. Press button 2 twice.
The chapter is now set to 1. The dot
next to 1 flashes:
3. Press button 1 twice.
The dot to theright of configuration 1
flashes:
4. Press button 2 five times.
The configuration changes to 6:
5. Press button 1 once.
The dot to the right of the content 0
flashes:
6. Press button 2 once.
Thecontent changesto1. The dot to
the left of the content goes off.
7. Press and hold button 3 for
3seconds to save the setting. The
dot to the left of the content appears.
8. Remove the diagnosis plug from the
control electronics and reattach the
cover.
