Harvia SENTIO pronet Bedienungsanleitung
pronet
1-017-521 PRO-NET sentio pronet
EN
EN Instructions for installation and use of the web server
DE Montage- und Gebrauchsanleitung des Webserver
FR Instructions d’installation et mode d’emploi du serveur web
IT Istruzioni per d’uso e di montaggio del server web
NL Instructies voor installatie en gebruik van de webserver
SV Monterings- och bruksanvisning för webserver
FI Verkkopalvelin asennus- ja käyttöohje
RU
Инструкция по установке и эксплуатации для вебсервера
PRONET
RS485
ETHERNET
.sentiotec.com
IP: 192.168.0.110
sauna / sentiotec
Table of Contents
1. About this instruction manual 4
2. Important information for your safety 5
2.1. Intended use 5
2.2. Safety information 5
2.3. Legal information 6
3. Product description 7
3.1. Scope of delivery 7
3.2. Product features 7
4. Connection diagram 8
5. Starting up for the rst time 11
5.1. Setting up a new local WLAN network 12
5.2. Integration into an existing local area network (LAN) 13
5.3. Setting up WEB access 14
5.4. Bridge mode for wireless connection to the router 15
6. Help with starting up 16
7. Conguration examples 17
7.1. Conguringalocalnetwork 17
7.2. Internet access via SIM card (3G stick) or WAN 17
7.3. Bridge mode 17
DE
EN
8. Operation 18
8.1. Overview of the main menu 19
8.2. Operating example 20
8.3. Setting the preset time 21
8.4. System settings 22
9. Cleaning and maintenance 24
9.1. Cleaning 24
9.2. Maintenance 24
10. Troubleshooting 24
11. Disposal 25
12. Technical data 25
Instructions for installation and use p. 4/26
1. About this instruction manual
Read these instructions for installation and use carefully, and keep them within
reach of the pronet web server. This ensures that you can refer to information
on safety and operation at any time.
Symbols used for warning notices
In these instructions for installation and use, a warning notice located next to
an activity indicates that this activity poses a risk. Always observe the warning
notices. This prevents damage to property and injuries, which in the worst case
may be fatal.
The warning notices contain keywords, which have the following meanings:
DANGER!
Serious or fatal injury will occur if this warning notice is not observed.
WARNING!
Serious or fatal injury can occur if this warning notice is not observed.
CAUTION!
Minor injuries can occur if this warning notice is not observed.
ATTENTION!
This keyword is a warning that damage to property can occur.
Other symbols
This symbol indicates tips and useful information.
These installation and operating instructions can also be found in the down-
loads section of our website: www.sentiotec.com/downloads.
EN
Instructions for installation and use p. 5/26
2. Important information for your safety
The pronet web server has been produced in accordance with the
recognised safety regulations. However, hazards may arise during
use. Therefore adhere to the following safety information and the
specicwarningnoticesintheindividualchapters.
2.1. Intended use
The pronet web server allows all the available sauna functions to
be operated using devices such as a PC, smartphone, tablet, etc.
This is done using either a local network (LAN, WLAN) or over the
Internet (web). Up to 2 sauna control units can be connected to
the web server.
The pronet web server may only be used for operating and regu-
lating a sauna heater that passes the combustion test described in
paragraph 19.101 of EN 60335-2-53. Alternatively, a suitable safety
shut-off device can be installed in or above the heater.
Any use exceeding this scope is considered improper use. Improper
use can result in damage to the product, severe injuries or death.
2.2. Safety information
●Installation and connection of the sauna control unit may only be
performed when the power supply is disconnected.
●Also comply with the regulations applicable at the installation
location.
●For your own safety, consult your supplier in the event of prob-
lemsthatarenotexplainedinsufcientdetailintheinstallation
instructions.
Instructions for installation and use p. 6/26
●The device must not be used by children under 8 years of age.
●The device may only be used by children over 8 years of age,
by persons with limited psychological, sensory or mental capa-
bilities or by persons with lack of experience/knowledge under
the following conditions:
– They are supervised.
– They have been shown how to use the device safely and
are aware of the hazards that could occur.
●Children must not play with the device.
●Children under 14 years of age may only clean the device if they
are supervised.
● Forhealthreasons,donotusethesaunawhenundertheinu-
ence of alcohol, medication or drugs.
● Makesurethatnoammableobjectshavebeenplacedonthe
sauna heater before the sauna control unit is switched on.
2.3. Legal information
●The company sentiotec GmbH reserves the right to charge fees
or to discontinue the service offered at any time without stating
reasons. Sentiotec GmbH cannot guarantee that the service is
compatible with the user's technical equipment and takes no
responsibility for any resulting damages.
EN
Instructions for installation and use p. 7/26
3. Product description
3.1. Scope of delivery
●pronet web server
●2 x network cable, 1 m
●1 x network cable, 3 m
●Power supply unit
●Instructions for installation and use
3.2. Product features
The pronet web server allows all the available sauna functions to be operated
using devices such as a PC, smartphone, tablet, etc. This is done using either
a local network (LAN, WLAN) or over the Internet (web). Up to 2 sauna control
units can be connected to the web server.
Compatible sauna control units:
●Pro B2
●Pro B3
●Pro C2
●Pro C3
●Pro D (only in conjunction with PRO-D-CON / 1-045-317)
A web application that is accessed using the web browser on your device (e.g. PC,
smartphone, tablet, etc.) is used for operation. Depending on the sauna control
unit being used, the number of functions that can be operated using the web
app will vary.
Instructions for installation and use p. 8/26
4. Connection diagram
Observe the following points when connecting the power to the sauna control unit:
●Work on the sauna control unit may only be performed when the power has
been disconnected.
12
3
4
5
1Sauna 1 RS485 connection
2Sauna 2 RS485 connection
3 5 V DC mains input
4Ethernet RJ45
5Mini-USB (not in use)
6RS485 transmission indicator lamp
7RS485 reception indicator lamp
Figure 1: Connections
6 7
EN
Instructions for installation and use p. 9/26
RJ45 socket
RS485 ETHERNET
WEB
Figure 2: Pro B and Pro C operating principle:
Figure 3: Pro D operating principle:
RJ10 socket
WEB
ETHERNET
PRO-D-CON
1-045-317
RS485
Instructions for installation and use p. 10/26
Checking the connection:
After successfully connecting the web server and the sauna control unit,
the transmission indicator lamp 6and the reception indicator lamp 7start
toash.
This means: The web server is sending and receiving data.
If this is not the case, check the following items:
– The sauna control unit is switched on.
– The web server has a voltage supply and is operating.
– The cable connection between the sauna control unit and the web
server is in order.
The web server requires up to 2 minutes until it has started up and is
ready for operation after being plugged into the power supply.
Connecting the cables
●Connect your sauna control unit to the web server (connection 1or 2).
►Use the network cables included with the delivery for connection.
●Connect the web server to your LAN network/WLAN router (Ethernet 4).
►Use the network cable included with the delivery for connection.
●Connect the power supply unit included with the delivery to a voltage supply
(5 V DC mains input 3).
●Pro D only:
►The Pro D BUS converter RS485 is required to establish a connection
between the sauna controller and the web server. This converts the
internal CAN-BUS to RS485.
►Use the Y-distributor included with the converter to connect the converter
to the control unit as well.
Inhaltsverzeichnis
Sprachen:
